|
|
本帖最后由 yetiddbb 于 2009-10-30 20:53 编辑
root@DD-WRT:~# dmesg
Linux version 2.6.24.111 (root@dd-wrt) (gcc version 4.3.2 (GCC) ) #3026 Sat Oct
10 04:54:20 CEST 2009
CPU: XScale-IXP42x Family [690541c1] revision 1 (ARMv5TE), cr=000039ff
Machine: Actiontec MI424WR
Memory policy: ECC disabled, Data cache writeback
On node 0 totalpages: 8192
DMA zone: 64 pages used for memmap
DMA zone: 0 pages reserved
DMA zone: 8128 pages, LIFO batch:0
Normal zone: 0 pages used for memmap
Movable zone: 0 pages used for memmap
CPU0: D VIVT write-back cache
CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
Built 1 zonelists in Zone order. Total pages: 8128
Kernel command line: console=ttyS0,115200 panic=10 root=/dev/mtdblock2 rootfstyp
e=squashfs,jffs2 noinitrd
PID hash table entries: 128 (order: 7, 512 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 32MB = 32MB total
Memory: 29556KB available (2412K code, 382K data, 92K init)
Calibrating delay loop... 532.48 BogoMIPS (lpj=2662400)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
IXP4xx: Using 16MiB expansion bus window size
PCI: IXP4xx is host
PCI: IXP4xx Using direct access for memory space
PCI: bus0: Fast back to back transfers disabled
dmabounce: registered device 0000:00:0d.0 on pci bus
dmabounce: registered device 0000:00:0d.1 on pci bus
dmabounce: registered device 0000:00:0e.0 on pci bus
dmabounce: registered device 0000:00:0f.0 on pci bus
dmabounce: registered device 0000:00:0f.1 on pci bus
NET: Registered protocol family 2
Time: OSTS clocksource has been installed.
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
squashfs: version 3.0 (2006/03/15) Phillip Lougher
io scheduler noop registered
io scheduler deadline registered (default)
ixp425_gpio: IXP425 GPIO driver loaded
Serial: 8250/16550 driver $Revision: 1.90 $ 10 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0xc8000000 (irq = 15) is a XScale
console [ttyS0] enabled
serial8250.0: ttyS1 at MMIO 0xc8001000 (irq = 13) is a XScale
loop: module loaded
nbd: registered device at major 43
PPP generic driver version 2.4.2
PPP Deflate Compression module registered
PPP BSD Compression module registered
MPPE/MPPC encryption/compression module registered
NET: Registered protocol family 24
tun: Universal TUN/TAP device driver, 1.6
tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
try to reserve 0x50000000 with size of 0x00800000
IXP4XX-Flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
Intel/Sharp Extended Query Table at 0x0031
Using buffer write method
cfi_cmdset_0001: Erase suspend on write enabled
erase region 0: offset=0x0,size=0x20000,blocks=64
scanning for root partition
<0>[0x00160000]
found squashfs/jffs2 at 160000
scan redboot from c37e0000
found RedBoot partition at [0x50000000]
found RedBoot config partition at [0x507FF000]
found config partition at [0x507E0000]
found linux partition at [0x50060000]
Creating 9 MTD partitions on "IXP4XX-Flash.0":
0x00000000-0x00060000 : "RedBoot"
0x00060000-0x007a0000 : "linux"
0x00160000-0x00720000 : "rootfs"
0x00720000-0x007a0000 : "ddwrt"
0x007a0000-0x007c0000 : "mampf"
0x007c0000-0x007e0000 : "nvram"
0x007e0000-0x00800000 : "FIS directory"
0x007ff000-0x0081f000 : "RedBoot config"
我也刷上DD了，WAN跟无线都没驱动起来（无线是自带的RT卡）！！ |
|
/1 
IP卡
狗仔卡
发表于 2009-10-12 23:55
置顶卡
沉默卡
喧嚣卡
顶贴卡
显身卡