|
楼主 |
发表于 2023-5-8 14:13
|
显示全部楼层
breed> ls /mnt/shares
Unrecognised command: ls
Type 'help' to get available commands.
breed> help
Available commands:
about - About this bootloader
abstatus - Interrupt status of autoboot
arp - Display ARP table
autoboot - Detect firmware type and boot automatically
boot - Boot firmware
btntst - Test GPIO of buttons
dhcp - Display DHCP leases
env - Environment variables utility
exit - Exit from telnet
flash - Flash utility
gpio - GPIO utilities
help - Show available commands
mdio - MDIO utility
mem - Memory operation utilities
net - Network control
netstat - Display network state
reset - Restart device
sysinfo - Display system information
thread - Display all threads
wget - Retrieval file through HTTP
breed> reset
Resetting ...
Boot and Recovery Environment for Embedded Devices
Copyright (C) 2017 HackPascal <hackpascal@gmail.com>
Build date 2017-09-21 [git-35a696e]
Version 1.1 (r1126)
DRAM: 256MB
Platform: MediaTek MT7621A ver 1, eco 3
Board: Xiaomi R3G
Clocks: CPU: 880MHz, DDR: 1200MHz, Bus: 220MHz, Ref: 40MHz
Environment variables @ 00060000 on flash bank 0, size 00020000
Flash: ESMT NAND 128MiB 3.3V 8-bit (128MB) on mt7621-nfi.0
mt7621-nfi.0: Found Fact BBT at block 1023 (offset 0x07fe0000)
rt2880-eth: MAC address from EEPROM is invalid, using default settings.
rt2880-eth: Using MAC address 00:0c:43:00:00:01
eth0: MediaTek MT7530 Gigabit switch
Network started on eth0, inet addr 192.168.1.1, netmask 255.255.255.0
Press any key to interrupt autoboot ... 0
Trying to boot firmware from 0x00600000 in flash bank 0 ...
Error: Unrecognised firmware header!
Starting breed built-in shell
|
|