|
从ttl信息看总感觉怪怪的。
- CFE for WNR3500L version: v1.0.36
- Build Date: Tue Aug 11 15:09:14 CST 2009
- Init Arena
- Init Devs.
- Boot partition size = 262144(0x40000)
- Found a 16MB ST compatible serial flash
- et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.10.56.28
- CPU type 0x19740: 453MHz
- Tot mem: 65536 KBytesDevice eth0: hwaddr 00-FF-FF-FF-FF-FF, ipaddr 192.168.1.1, mask 255.255.255.0
- gateway not set, nameserver not set
- Loader:raw Filesys:tftp Dev:eth0 File:192.168.1.2:vmlinuz Options:(null)
- Loading: Failed.
- Could not load 192.168.1.2:vmlinuz: Timeout occured
- Checksum mismatch:
- Image chksum: 0x54C54D08
- Calc chksum: 0x02C0010E
- Loader:raw Filesys:raw Dev:flash0.os File: Options:(null)
- Loading: .. 5192 bytes read
- Entry at 0x80001000
- Closing network.
- Starting program at 0x80001000
- Linux version 2.6.22.19 (root@tomato) (gcc version 4.2.4) #1 Mon Apr 2 01:37:30 CST 2012
- CPU revision is: 00019740
- Found a 16MB ST compatible serial flash
- Determined physical RAM map:
- memory: 04000000 @ 00000000 (usable)
- Built 1 zonelists. Total pages: 16256
- Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200
- Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
- Primary data cache 32kB, 4-way, linesize 32 bytes.
- Synthesized TLB refill handler (20 instructions).
- Synthesized TLB load handler fastpath (32 instructions).
- Synthesized TLB store handler fastpath (32 instructions).
- Synthesized TLB modify handler fastpath (31 instructions).
- PID hash table entries: 256 (order: 8, 1024 bytes)
- CPU: BCM4716 rev 1 pkg 10 at 453 MHz
- Using 226.500 MHz high precision timer.
- console [ttyS0] enabled
- Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
- Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
- Memory: 62048k/65536k available (2121k kernel code, 3432k reserved, 460k data, 108k init, 0k highmem)
- SLUB: Genslabs=6, HWalign=32, Order=0-1, MinObjects=4, CPUs=1, Nodes=1
- Mount-cache hash table entries: 512
- NET: Registered protocol family 16
- PCI: Using membase 8000000
- PCI: Disabled
- PCI: Fixing up bus 0
- PCI: Fixing up bus 1
- Time: MIPS clocksource has been installed.
- NET: Registered protocol family 2
- IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
- TCP established hash table entries: 2048 (order: 2, 16384 bytes)
- TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
- TCP: Hash tables configured (established 2048 bind 2048)
- TCP reno registered
- squashfs: version 3.0 (2006/03/15) Phillip Lougher
- io scheduler noop registered (default)
- HDLC line discipline: version $Revision: 4.8 $, maxframe=4096
- N_HDLC line discipline registered.
- Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled
- serial8250: ttyS0 at MMIO 0x0 (irq = 8) is a 16550A
- PPP generic driver version 2.4.2
- PPP Deflate Compression module registered
- MPPE/MPPC encryption/compression module registered
- NET: Registered protocol family 24
- PPPoL2TP kernel driver, V0.17
- PPTP driver version 0.8.5
- pflash: found no supported devices
- Creating 6 MTD partitions on "sflash":
- 0x00000000-0x00040000 : "pmon"
- 0x00040000-0x00f90000 : "linux"
- 0x00120400-0x007a0000 : "rootfs"
- 0x007a0000-0x00f80000 : "jffs2"
- 0x00ff0000-0x01000000 : "nvram"
- 0x00fe0000-0x00ff0000 : "board_data"
- u32 classifier
- OLD policer on
- Netfilter messages via NETLINK v0.30.
- nf_conntrack version 0.5.0 (512 buckets, 4096 max)
- ip_tables: (C) 2000-2006 Netfilter Core Team
- net/ipv4/netfilter/tomato_ct.c [Apr 2 2012 01:37:30]
- NET: Registered protocol family 1
- NET: Registered protocol family 17
- 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
- All bugs added by David S. Miller <davem@redhat.com>
- VFS: Mounted root (squashfs filesystem) readonly.
- Freeing unused kernel memory: 108k freed
- Warning: unable to open an initial console.
- et: module license 'unspecified' taints kernel.
- eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.10.56.46
- eth1: Broadcom BCM4329 802.11 Wireless Controller 5.10.56.46
- Algorithmics/MIPS FPU Emulator v1.5
- NVRAM No change was necessary.
- / # Hit ENTER for console...Unlocking 0x0 - 0xffff
- Unlocking 0x10000 - 0x1ffff
- Unlocking 0x20000 - 0x2ffff
- Unlocking 0x30000 - 0x3ffff
- Unlocking 0x40000 - 0x4ffff
- Unlocking 0x50000 - 0x5ffff
- Unlocking 0x60000 - 0x6ffff
- Unlocking 0x70000 - 0x7ffff
- Unlocking 0x80000 - 0x8ffff
- Unlocking 0x90000 - 0x9ffff
- Unlocking 0xa0000 - 0xaffff
- Unlocking 0xb0000 - 0xbffff
- Unlocking 0xc0000 - 0xcffff
- Unlocking 0xd0000 - 0xdffff
- Unlocking 0xe0000 - 0xeffff
- Unlocking 0xf0000 - 0xfffff
- …………
- Unlocking 0x780000 - 0x78ffff
- Unlocking 0x790000 - 0x79ffff
- Unlocking 0x7a0000 - 0x7affff
- Unlocking 0x7b0000 - 0x7bffff
- Unlocking 0x7c0000 - 0x7cffff
- Unlocking 0x7d0000 - 0x7dffff
- lo: File exists
- read: File exists
- …………
- read: File exists
- read: No such device
- …………
- read: No such device
- iptables: Bad rule (does a matching rule exist in that chain?)
- iptables: Bad rule (does a matching rule exist in that chain?)
- iptables: Bad rule (does a matching rule exist in that chain?)
- read: Interrupted system call
- …………
- read: Interrupted system call
- iptables: No chain/target/match by that name
- iptables: No chain/target/match by that name
- read: No such file or directory
- …………read: No such file or directory
- device eth1 entered promiscuous mode
- br0: port 2(eth1) entering forwarding state
- br0: port 1(vlan1) entering forwarding state
- lo: File exists
- vlan2: Setting MAC address to ec 40 0f d2 13 b1.
- vlan3: Setting MAC address to ec 40 0f d2 13 b2.
- read: File exists
-
复制代码
|
|