|
U-Boot 2018.09 (Nov 20 2020 - 19:56:59 +0800)
CPU: MediaTek MT7621AT ver 1, eco 3
Clocks: CPU: 880MHz, DDR: 1200MHz, Bus: 220MHz, XTAL: 40MHz
Model: MediaTek MT7621 reference board (NAND)
DRAM: 256 MiB
NAND: 128 MiB
Loading Environment from NAND... OK
In: uartlite0@1e000c00
Out: uartlite0@1e000c00
Err: uartlite0@1e000c00
Net:
Warning: eth@1e100000 (eth0) using random MAC address - a2:db:82:64:59:fd
eth0: eth@1e100000
Hit any key to stop autoboot: 0
*** U-Boot Boot Menu ***
1. Startup system (Default)
2. Upgrade firmware
3. Upgrade bootloader
4. Upgrade bootloader (advanced mode)
5. Load image
0. U-Boot console
Press UP/DOWN to move, ENTER to select
Loading from nand0, offset 0x180000
Image Name: MIPS OpenWrt Linux-5.15.137
Image Type: MIPS Linux Kernel Image (uncompressed)
Data Size: 3022109 Bytes = 2.9 MiB
Load Address: 80001000
Entry Point: 80001000
Automatic boot of image at addr 0x80010000 ...
## Booting kernel from Legacy Image at 80010000 ...
Image Name: MIPS OpenWrt Linux-5.15.137
Image Type: MIPS Linux Kernel Image (uncompressed)
Data Size: 3022109 Bytes = 2.9 MiB
Load Address: 80001000
Entry Point: 80001000
Verifying Checksum ... Bad Data CRC
ERROR: can't get kernel image!
no partition number specified
Loading from nand0, offset 0x180000
Image Name: MIPS OpenWrt Linux-5.15.137
Image Type: MIPS Linux Kernel Image (uncompressed)
Data Size: 3022109 Bytes = 2.9 MiB
Load Address: 80001000
Entry Point: 80001000
Automatic boot of image at addr 0x82000000 ...
## Booting kernel from Legacy Image at 82000000 ...
Image Name: MIPS OpenWrt Linux-5.15.137
Image Type: MIPS Linux Kernel Image (uncompressed)
Data Size: 3022109 Bytes = 2.9 MiB
Load Address: 80001000
Entry Point: 80001000
Verifying Checksum ... Bad Data CRC
ERROR: can't get kernel image!
=>
|
|