|
本帖最后由 jbzzz 于 2018-5-22 09:24 编辑
今天收到了,立马拆了,拆闪存备份,换内存
,先换了256M,还是把K2的拆了,结果
开了TTL看看,一会就死机了,去群里,有人说换128,然后又是拆,换128M,终于跑起来了
听说是不支持单颗256
- U-Boot 1.1.4-gbc73b198 (Mar 29 2018 - 15:36:58)
- ap152 - Dragonfly 1.0DRAM:
- sri
- ath_ddr_initial_config(278): (ddr2 init)
- ath_sys_frequency: cpu 775 ddr 650 ahb 258
- Tap values = (0x8, 0x8, 0x8, 0x8)
- 128 MB
- Top of RAM usable for U-Boot at: 88000000
- Reserving 202k for U-Boot at: 87fcc000
- Reserving 192k for malloc() at: 87f9c000
- Reserving 44 Bytes for Board Info at: 87f9bfd4
- Reserving 36 Bytes for Global Data at: 87f9bfb0
- Reserving 128k for boot params() at: 87f7bfb0
- Stack Pointer at: 87f7bf98
- Now running in RAM - U-Boot at: 0x87fcc000
- Flash Manuf Id 0x0xc8, DeviceId0 0x0x40, DeviceId1 0x0x18
- flash size 16MB, sector count = 256
- Flash: 16 MB
- *** Warning - bad CRC, using default environment
- Power up PLL with outdiv = 0 then switch to 3
- In: serial
- Out: serial
- Err: serial
- Net: ath_gmac_enet_initialize...
- No valid address in Flash. Using fixed address
- ath_gmac_enet_initialize: reset mask:0xc02200
- athr_mgmt_init ::done
- Dragonfly ----> S17 PHY *
- athrs17_reg_init: complete
- SGMII in forced mode
- athr_gmac_sgmii_setup SGMII done
- : cfg1 0x80000000 cfg2 0x7114
- eth0: 0x0:0x3:0x7f:0x9:0xb:0xad
- eth0 up
- eth0
- Setting 0x181162c0 to 0x0x4b962100
- Hit any key to stop autoboot: 2 1 0
- ## Booting image at 0x9f090000 ...
- Image Name: MIPS OpenWrt Linux-3.3.8
- Created: 2018-03-29 7:46:08 UTC
- Image Type: MIPS Linux Multi-File Image (lzma compressed)
- Data Size: 1046796 Bytes = 1022.3 kB
- Load Address: 0x80060000
- Entry Point: 0x80060000
- Contents:
- Image 0: 1046788 Bytes = 1022.3 kB
- Verifying Checksum at 0x9f090040 ...OK
- Uncompressing Multi-File Image ... ?
- U-Boot 1.1.4-gbc73b198 (Mar 29 2018 - 15:36:58)
- ap152 - Dragonfly 1.0DRAM:
- sri
- ath_ddr_initial_config(278): (ddr2 init)
- ath_sys_frequency: cpu 775 ddr 650 ahb 258
- Tap values = (0x8, 0x8, 0x8, 0x8)
- 128 MB
- Top of RAM usable for U-Boot at: 88000000
- Reserving 202k for U-Boot at: 87fcc000
- Reserving 192k for malloc() at: 87f9c000
- Reserving 44 Bytes for Board Info at: 87f9bfd4
- Reserving 36 Bytes for Global Data at: 87f9bfb0
- Reserving 128k for boot params() at: 87f7bfb0
- Stack Pointer at: 87f7bf98
- ?
- U-Boot 1.1.4-gbc73b198 (Mar 29 2018 - 15:36:58)
复制代码
|
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有账号?立即注册
×
评分
-
查看全部评分
|