超级终端按Ctrl+C没反应求救
这是启动日志大家帮我看看应该怎么办吧Decompressing...done
CFE version 5.100.138.22 based on BBP 1.0.37 for BCM947XX (32bit,SP,LE)
Build Date: Sat Mar 31 16:54:11 CST 2012 (root@linux-6091)
Copyright (C) 2000-2008 Broadcom Corporation.
Init Arena
Init Devs.
Boot partition size = 131072(0x20000)
Found an ST compatible serial flash with 128 64KB blocks; total size 8MB
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.100.138.22
CPU type 0x19749: 500MHz
Tot mem: 65536 KBytes
CFE mem: 0x80700000 - 0x80798520 (623904)
Data: 0x8072E340 - 0x80731590 (12880)
BSS: 0x80731590 - 0x80732520 (3984)
Heap: 0x80732520 - 0x80796520 (409600)
Stack: 0x80796520 - 0x80798520 (8192)
Text: 0x80700000 - 0x8072E340 (189248)
Device eth0:hwaddr C8-3A-35-38-85-08, ipaddr 192.168.1.1, mask 255.255.255.0
gateway not set, nameserver not set
Loader:raw Filesys:tftp Dev:eth0 File:192.168.1.100:vmlinuz Options:(null)
Loading: Failed.
Could not load 192.168.1.100:vmlinuz: Timeout occured
Loader:raw Filesys:raw Dev:flash0.os File: Options:(null)
Loading: .. 5192 bytes read
Entry at 0x80001000
Closing network.
Starting program at 0x80001000
Linux version 2.6.22.19 (root@tomato) (gcc version 4.2.4) #1 Wed Jan 22 16:47:22 CST 2014
CPU revision is: 00019749
Found a 8MB ST compatible serial flash
Determined physical RAM map:
memory: 04000000 @ 00000000 (usable)
Built 1 zonelists.Total pages: 16256
Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200
Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, linesize 32 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 256 (order: 8, 1024 bytes)
CPU: BCM5357 rev 2 pkg 10 at 80 MHz
Using 40.000 MHz high precision timer.
console enabled
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 62048k/65536k available (2121k kernel code, 3432k reserved, 460k data, 108k init, 0k highmem)
SLUB: Genslabs=6, HWalign=32, Order=0-1, MinObjects=4, CPUs=1, Nodes=1
Mount-cache hash table entries: 512
NET: Registered protocol family 16
PCI: no core
PCI: Fixing up bus 0
Time: MIPS clocksource has been installed.
NET: Registered protocol fmily 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
squashfs: version 3.0 (2006/03/15) Phillip Lougher
io scheduler noop registered (default)
HDLC line discipline: version $Revision: 4.8 $, maxframe=4096
N_HDLC line discipline registered.
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x0 (irq = 8) is a 16550A
PPP generic driver version 2.4.2
PPP Deflate Compression module registered
MPPE/MPPC encryption/compression module registered
NET: Registered protocol family 24
PPPoL2TP kernel driver, V0.17
PPTP driver version 0.8.5
pflash: found no supported devices
Creating 5 MTD partitions on "sflash":
0x00000000-0x00020000 : "pmon"
0x00020000-0x007f0000 : "linux"
0x00100400-0x00770000 : "rootfs"
0x00770000-0x007f0000 : "jffs2"
0x007f0000-0x00800000 : "nvram"
u32 classifier
OLD policer on
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (512 buckets, 4096 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
net/ipv4/netfilter/tomato_ct.c
NET: Registered protocol family 1
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 108k freed
Warning: unable to open an initial console.
et: module license 'unspecified' taints kernel.
eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.10.56.46
eth%d: 5.10.56.46 driver failed with code 12
Algorithmics/MIPS FPU Emulator v1.5
NVRAM No change was necessary.
/ # vlan0: No such device
eth1: No such device
eth2: No such device
eth3: No such device
lo: File exists
RTNETLINK answers: No such file or directory
RTNETLINK answers: No such file or directory 一通电立刻按就行了 用到软件设置可能导致无法接受输入信号，至少我用SecureCRT会出现，不记得改哪一个选项里 也可能是按得慢了，我也是，想抢小米似的。 nhldp 发表于 2014-4-27 00:31
一通电立刻按就行了
在Decompressing...的时候就按了，还是没反应啊 火腿 发表于 2014-4-27 08:56
用到软件设置可能导致无法接受输入信号，至少我用SecureCRT会出现，不记得改哪一个选项里
我Win8.1用超级终端还有SecureCRT和Putty都试过了没用啊 我的也是按了，按不住呀，一直没有反映。
页:
[1]