看看山寨的 LINKSYS WRT300N 被我弄砖了
今天刷番茄 结果砖了 拆开看 才知道是山寨的 就等工具回来了 看看能不能救了 懂得朋友帮我看看 黑色那根天线是不是摆设U-Boot 1.1.3 (Jan 14 2010 - 20:32:38)
Board: Ralink APSoC DRAM:64 MB
relocate_code Pointer at: 8377c000
Set info->start=BF000000
flash_protect ON: from 0xBF000000 to 0xBF022F47
protect on 0
protect on 1
protect on 2
flash_protect ON: from 0xBF030000 to 0xBF03FFFF
protect on 3
*** Warning - bad CRC, using default environment
============================================
Ralink UBoot Version: 3.2
--------------------------------------------
ASIC 3052_MP2 (Port5<->Phy)
DRAM COMPONENT: 256Mbits
DRAM BUS: 32BIT
Total memory: 64 MBytes
Date:Jan 14 2010Time:20:32:38
============================================
icache: sets:256, ways:4, linesz:32 ,total:32768
dcache: sets:128, ways:4, linesz:32 ,total:16384
##### The CPU freq = 384 MHZ ####
SDRAM bus set to 32 bit
SDRAM size =64 Mbytes
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP.
3: Boot system code via Flash (default).
4: Entr boot command line interface.
9: Load Boot Loader code then write to Flash via TFTP.
0
3: System Boot system code via Flash.
eth_register
Eth0 (10/100-M)
enetvar=ethaddr,Eth addr:00:0C:43:09:26:BB
eth_current->name = Eth0 (10/100-M)
verify is 1
## load addr bf050000 ...
print img header
Magic:
CRC:
Image Name:
Created: 1970-01-01 0:00:00 UTC
System Control Status = 0x20440000
Image Type: Invalid CPU Invalid OS Invalid Image (uncompressed)
Data Size: 0 Bytes =0 kB
Load Address: 00000000
Entry Point:00000000
Bad Magic Number , 00000000
## Booting image at bf050000 ...
sizeof image_header_t is 64
Bad Magic Number,48445230 这是什么意思啊不能用了么没出现*** Press any key to stop
auto run (1 seconds) ***
这货只能刷OP固件了！DD也行！番茄没戏！ 这货只能刷OP固件了！DD也行！番茄没戏！
页:
[1]