友华wr330(wr1200js)变砖,ttl 线刷无法用键盘选择choosed
该用键盘选2的时候,老是自动选择默认5,按键盘没反应,直接代码跑过去,换了ttl设备,win8换成win764到32都不行,有什么办法没,U-Boot 1.1.3 (Aug4 2017 - 21:38:42)Board: Ralink APSoC DRAM:128 MB
relocate_code Pointer at: 87fa0000
Config XHCI 40M PLL
flash manufacture id: c8, device id 40 18
find flash: GD25Q128C
*** Warning - bad CRC, using default environment
============================================
Ralink UBoot Version: 5.0.0.0
--------------------------------------------
ASIC MT7621A DualCore (MAC to MT7530 Mode)
DRAM_CONF_FROM: Auto-Detection
DRAM_TYPE: DDR3
DRAM bus: 16 bit
Xtal Mode=3 OCP Ratio=1/3
Flash component: SPI Flash
Date:Aug4 2017Time:21:38:42
============================================
icache: sets:256, ways:4, linesz:32 ,total:32768
dcache: sets:256, ways:4, linesz:32 ,total:32768
##### The CPU freq = 880 MHZ ####
estimate memory size =128 Mbytes
#Reset_MT7530
set LAN/WAN LLLLW
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP.
3: Boot system code via Flash (default).
4: Entr boot command line interface.
5: Wait for IGMP tools for multi upgrage linux image.
7: Load Boot Loader code then write to Flash via Serial.
9: Load Boot Loader code then write to Flash via TFTP.
default: 5
You choosed 5
上编程器就可以解君愁 a7077447 发表于 2020-5-1 17:59 static/image/common/back.gif
上编程器就可以解君愁
没其它办法了吗
TTL线没接好,只能接收不能发送
未来未知 发表于 2020-5-1 20:25 static/image/common/back.gif
TTL线没接好,只能接收不能发送
到选择的时候太快了,根本不停
wu515393043 发表于 2020-5-1 23:36 static/image/common/back.gif
到选择的时候太快了,根本不停
手速快些,一直点
请问下 ttl 这4个接口是什么顺序的? 请问你这个弄好了吗?
页:
[1]