|
楼主 |
发表于 2020-8-17 17:03
|
显示全部楼层
本帖最后由 wodaoo 于 2020-8-17 17:06 编辑
putty信息:
U-Boot 1.1.4-gfacc17ef-dirty (Sep 4 2015 - 17:55:33)
ap135 - Scorpion 1.0DRAM:
sri
Scorpion 1.0
ath_ddr_initial_config(196): (32bit) ddr2 init
tap = 0x00000003
Tap (low, high) = (0x3, 0x1e)
Tap values = (0x10, 0x10, 0x10, 0x10)
256 MB
Top of RAM usable for U-Boot at: 90000000
Reserving 256k for U-Boot at: 8ffbc000
Reserving 192k for malloc() at: 8ff8c000
Reserving 44 Bytes for Board Info at: 8ff8bfd4
Reserving 36 Bytes for Global Data at: 8ff8bfb0
Reserving 128k for boot params() at: 8ff6bfb0
Stack Pointer at: 8ff6bf98
Now running in RAM - U-Boot at: 8ffbc000
Flash Manuf Id 0xc2, DeviceId0 0x20, DeviceId1 0x18
flash size 16MB, sector count = 256
Flash: 16 MB
*** Warning *** : PCIe WLAN Module not found !!!
In: serial
Out: serial
Err: serial
Net: ath_gmac_enet_initialize...
athrs_sgmii_res_cal: cal value = 0xe
No valid address in Flash. Using fixed address
No valid address in Flash. Using fixed address
ath_gmac_enet_initialize: reset mask:c02200
Scorpion ----> S17 PHY *
Vlan config...
s17 phy0 register value 0x00004140
TEST: FINAL REG VAL after TX Calibration - 0x4a000000
TEST: FINAL XMII VAL after RX Calibration - 0x5a000000
TEST: FINAL ETH_CFG VAL after RX Calibration - 0x00000001
athrs17_reg_init: complete
: cfg1 0x80000000 cfg2 0x7335
eth0: 00:03:7f:09:0b:ad
eth0 up
athrs17_reg_init_wan done
SGMII in forced mode
athr_gmac_sgmii_setup SGMII done
: cfg1 0x800c0000 cfg2 0x7214
eth1: 00:03:7f:09:0b:ad
eth1 up
eth0, eth1
Atheros on-chip NAND FLash Controller Driver, Version 0.1 (c) 2010 Atheros Communications, Ltd.
Ath Nand ID[8ffee17c]: 01:f1:80:1d:01
ONFI SPANSION S34ML01G2
NAND 128MiB 3,3V 8-bit [128MB]
====== NAND Parameters ======
sc = 0x8ffee158 bbt = 0x8ff9c538 bbt_size = 0x100 nf_ctrl = 0x344
page = 0x800 block = 0x20000 oob = 0x40
size = 128MB
Setting 0x18116290 to 0x50a0214f
last reboot failed.
NAND read: device 0 offset 0x6000000, size 16777216 ... 16777216 bytes read: OK
CRC32 for 80060000 ... 80f9ffff ==> 1ab2fe04
backup crc:b7190af0 image crc:1ab2fe04
Hit any key to stop autoboot: 0
## Booting image at 9fe80000 ...
Image Name: MIPS OpenWrt Linux-4.9.214
Created: 2020-02-27 21:25:59 UTC
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 1472953 Bytes = 1.4 MB
Load Address: 80060000
Entry Point: 80060000
Verifying Checksum at 0x9fe80040 ...Bad Data CRC
ath>
---------------
另外我的情况也不像上面那个链接里说的按f可以进入启动失败模式,输入f回车,显示的是:bank # 1: the hell do you want flinfo for??
help显示flinfo是print flash memory information,好像没什么用
而且不需要去按什么键中断命令行信息滚动,上面的是自己停下来的,就这么多
|
|