How to flash DD on linksys wrt54g v4.0?

raoko

Because I am a novice, I have read many previous posts, and I didn't talk about how to flash Linksys WRT54G V4.0, refer to the method of other models of routers, after TFTP, prompt password problem, can't swipe, why? Bosses!?

etoto2000

Use the WEB method to flash the MINI version of DD-WRT first, and then you can flash STD or other versions

raoko

Thank you moderators, I just brushed MINII, and I am testing it to see if it can solve the problem of BT getting slower and slower.

awingbird

The slower BT is, on the one hand, your router allows fewer IP connections, and after swiping dd, you can change it to 4096, which should be much better.
On the other hand, your machine's memory is only 16M, which can only be changed by replacing or changing the hardware.
But I guess the former mainly affects your BT.

raoko

The original firmware can only keep up to 512 connections, and after flashing MINI, it is changed to 4096, which is already very good. The maximum number of connections in the general operating system is 2048, so I think that if the linksys wrt54g is a BT, it will bring 2 machines at most, and no matter how many machines there are, it may not be able to bear the load. In the morning, the number of connections is about 1700, and the BT speed is ideal, because it is a telecom cell broadband, there is no speed limit, and the BT speed is about 500-1000K, and there is no situation where the web page cannot be opened or opened slowly. Try again another day to try the speed of BT and the load of the router with the desktop, but it is estimated that it will not be ideal, because in the case of only using the desktop, the router load is about 70%, and the peak period instantly reaches 99%. There is also one or two sub-router memory 16M seems to be enough, because the memory of the router has basically not changed much, and the usage rate is about 87%.