请教，旁路由状态下怎么使用adguardhome?

Related Posts:

Leike NW736 failed to turn bricks, call for help.
但因为媳妇在手机上用浏览器看书的时候，经常出现打不开网页的情况，关了wifi使用流量就能正常打开，所以经常跟我抱怨家里的网不好，为了耳根子清静，我把京东云设成主路由，开了dhcp，把小主机搞成旁路由，然后在我的设备上把网关设成旁路由地址，你用你的，我用我的，各取所需。但我发现adguardhome的广告拦截失效了。打开adguardhome的管理界面，在仪表盘界面上dns查询和已被过滤器拦截也都有数据，我把我的ad规则设在另一台做主路由的wrt上，广告拦截也有是效的，说明规则没有失效，是不是我设置有问题，请教一下，装在旁路由下的adguardhome，应该怎么设置进行使用？


网络环境：主路由京东云192.168.2.1，开dhcp，旁路由X86小主机openwrt 192.168.2.5，关闭dhcp

Limitpea

Ask the great god to flash the firmware of Leike power4s

Limitpea

Ask the great god to flash the firmware of Leike power4s

Related Posts:

Limitpea 发表于 2022-7-2 17:41
Ask the great god to flash the firmware of Leike power4s

我自己的设备IP网关和dns都是指向软路由的，adg的ip就是软路由的ip，这样设置没错吧，

jjit

adg 过滤器，自定义过滤规则里写
||baidu.com^
Leike Q3 brushed tomato and could not be hard reset
ipconfig /flushdns
然后上 百度，试一下能不能上，adg的 查询里，有没有百度被拦截的记录

Related Posts:

jjit 发表于 2022-7-2 18:37
adg 过滤器，自定义过滤规则里写
||baidu.com^
Leike Q3 brushed tomato and could not be hard reset

你好，在adg的过滤器里复制进了||baidu.com^，并点击应用，然后在cmd里输入ipconfig /flushdns，提示已成功刷新dns解析缓存，百度打开正常，adg的查询日志里也没有关于百度的拦截记录，请教，这代表什么？

jjit

View:
你好，在adg的过滤器里复制进了||baidu.com^，并点击应用，然后在cmd里输入ipconfig /flushdns，提示已成 ...

说明设备的 DNS查询，没有经过adg，电脑 cmd 运行
ipconfig /all
Published at 2014-8-8 13:20

Related Posts:

jjit 发表于 2022-7-2 19:03
说明设备的 DNS查询，没有经过adg，电脑 cmd 运行
ipconfig /all
Leike Q3 flashed into bricks for help

Leike Q3 has been painted into bricks
现在电脑通过旁路由海淘购物是没问题的，就是这个adg拦截没有效果，

jjit

Silence card
Pole 1S flashed the firmware of Leike NO1, and now I want to flash OP and can't use SSH to prompt connection refused

The author is banned or deleted and the content is automatically blocked

Related Posts:

jjit 发表于 2022-7-2 19:11
The author is banned or deleted and the content is automatically blocked

Ask for help Why did Leike Q3 brush successfully when brushing, but there was no response

Related Posts:

jjit 发表于 2022-7-2 19:11
The author is banned or deleted and the content is automatically blocked

【Help】 The newly bought Leike Q3 has been painted into bricks, do you have to use a programmer to save the bricks?
iptables -t nat -A PREROUTING -p udp --dport 53 -j REDIRECT --to-ports 54
iptables -t nat -A PREROUTING -p tcp --dport 53 -j REDIRECT --to-ports 54
在dhcp/dns里的dns转发里设置了   旁路由地址#54，这样设置后，在拦截规则不变的情况下，百度还是正常打开。。。。
Leike NO1 brush immortal uboot! Do not disassemble

yang_jnu

Sticky card
2. adg上游DNS设置为：127.0.0.1#53
PS: 使用上述设置，防火墙里的53配置规则可以删除了。

1286791684

Reading mode

hwbest

Published on 2014-8-8 20:00
https://www.right.com.cn/forum/thread-8284982-1-1.html

遇到了跟你类似的问题, 在客户端配置默认网关为旁路由IP后发现
1) “师夷长技以制夷”可以正常进行
Ask for help Why Leike Q3 brushed when the brush was successful, but there was no response-TOMATO Special Edition-Enshan Wireless Forum
Wireless search can't be found The route can't get in
/etc/init.d/firewall status
/etc/init.d/firewall stop

TOMATO Special Edition

iptables -t nat -L PREROUTING
Chain PREROUTING (policy ACCEPT)
target     prot opt source               destination
REDIRECT   udp  --  anywhere             anywhere             /* DNSMASQ */ udp dpt:domain redir ports 5337
REDIRECT   tcp  --  anywhere             anywhere             /* DNSMASQ */ tcp dpt:domain redir ports 5337
prerouting_rule  all  --  anywhere             anywhere             /* !fw3: Custom prerouting rule chain */
zone_lan_prerouting  all  --  anywhere             anywhere             /* !fw3 */
REDIRECT   udp  --  anywhere             anywhere             /* DNSMASQ */ udp dpt:domain redir ports 5337
REDIRECT   tcp  --  anywhere             anywhere             /* DNSMASQ */ tcp dpt:domain redir ports 5337
REDIRECT   udp  --  anywhere             anywhere             /* DNSMASQ */ udp dpt:domain redir ports 5337
REDIRECT   tcp  --  anywhere             anywhere             /* DNSMASQ */ tcp dpt:domain redir ports 5337
Leike power8L flashing machine
REDIRECT   udp  --  anywhere             anywhere             /* DNSMASQ */ udp dpt:domain redir ports 5337
REDIRECT   tcp  --  anywhere             anywhere             /* DNSMASQ */ tcp dpt:domain redir ports 5337

所以问题就出在DNSMASQ的规则比AdguardHome规则更早上, 修改方法如下:
1) 修改文件: vi /etc/config/dhcp
Power off, restart, after a ha, it's fine, I've been like this several times, thinking that if the brush is not successful, I'll re-brush it, and the result is still like that, wait a minute, it's fine
option dns_redirect '0'

重启即可, 重启后的防火墙规则很干净

iptables -t nat -L PREROUTING
Chain PREROUTING (policy ACCEPT)
target     prot opt source               destination
prerouting_rule  all  --  anywhere             anywhere             /* !fw3: Custom prerouting rule chain */
zone_lan_prerouting  all  --  anywhere             anywhere             /* !fw3 */
Leike power8L flashing machine

我的luci界面好像没有DNS重定向的菜单, 如果你的系统有, 也可以参考去关闭:
K1 brush Leike firmware brick, call for help. I can't even start breed.
https://www.right.com.cn/forum/thread-4056236-1-1.html

Leike NW618 brush machine brick