|
U-Boot 2012.07 [Standard IPQ806X.LN,r40331] (Oct 12 2015 - 17:00:55)
CBT U-Boot ver: 1.0.12
smem ram ptable found: ver: 0 len: 5
DRAM: 491 MiB
NAND: SF: Unsupported manufacturer 00
ipq_spi: SPI Flash not found (bus/cs/speed/mode) = (0/0/48000000/0)
128 MiB
MMC:
PCI0 Link Intialized
PCI1 Link Intialized
In: serial
Out: serial
Err: serial
cdp: get part failed for 0:HLOS
Net: MAC1 addr:0:3:7f:ba:db:1
athrs17_reg_init: complete
athrs17_vlan_config ...done
S17c init done
MAC2 addr:0:3:7f:ba:db:2
eth0
Warning: eth0 MAC addresses don't match:
Address in SROM is 00:03:7f:ba:db:01
Address in environment is 00:06:3b:01:41:00
, eth1
Updating boot_count ... done
Saving Environment to NAND...
Erasing Nand...
Erasing at 0xec0000 -- 100% complete.
Writing to Nand... done
Hit any key to stop autoboot: 0
MMC Device 0 not found
MMC Device 0 not found
Loading from nand0, offset 0x3780000
NAND read from offset 3780000 failed -74
** Read error
Write Reg: 0x00000660: Oldval = 0x00140020 Newval = 0x0014007e
Write Reg: 0x0000066c: Oldval = 0x0014005c Newval = 0x0014007d
Write Reg: 0x00000678: Oldval = 0x0014005a Newval = 0x0014007b
Write Reg: 0x00000684: Oldval = 0x00140056 Newval = 0x00140077
Write Reg: 0x00000690: Oldval = 0x0014004e Newval = 0x0014006f
Write Reg: 0x0000069c: Oldval = 0x00140001 Newval = 0x0014005f
Write Reg: 0x000006a8: Oldval = 0x0014001e Newval = 0x0014003f
Write Reg: 0x00000420: Oldval = 0x00020001 Newval = 0x00010001
Write Reg: 0x00000428: Oldval = 0x00010001 Newval = 0x00010001
Write Reg: 0x00000430: Oldval = 0x00010001 Newval = 0x00010001
Write Reg: 0x00000438: Oldval = 0x00010001 Newval = 0x00010001
Write Reg: 0x00000440: Oldval = 0x00010001 Newval = 0x00010001
Write Reg: 0x00000448: Oldval = 0x00020001 Newval = 0x00010001
Write Reg: 0x00000450: Oldval = 0x00010001 Newval = 0x00010001
|
|