腾达AC18 cfe启动故障，大家帮我分析下什么问题

yxb***

nand刷错固件不能启动，现在焊了SPI想救回NAND，在网页下刷写都提示成功的，就是没办法启动
TTL信息如下
Digital core power voltage set to 0.9375V
Decompressing...done
Found a Winbond NAND flash:
Total size:  128MB
Block size:  128KB
Page Size:   2048B
OOB Size:    64B
Sector size: 512B
Spare size:  16B
ECC level:   8 (8-bit)
Device ID: 0xef 0xf1 0x80 0x95 0x00 0x00


CFE version 6.37.14.93 (r469350) based on BBP 1.0.37 for BCM947XX (32bit,SP,)
Build Date: Tue Jul 26 08:38:40 CST 2016 (root@linux-svzy-cj)
Copyright (C) 2000-2008 Broadcom Corporation.

Init Arena
Init Devs.
Boot partition size = 262144(0x40000)
DDR Clock: 400 MHz
Warning: invalid DDR setting of 0 MHz ignored. DDR frequency will be set to 400 MHz.
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 6.37.14.93 (r469350)
CPU type 0x0: 800MHz
Tot mem: 262144 KBytes

CFE mem:    0x00F00000 - 0x017A888C (9078924)
Data:       0x00F5FC14 - 0x00F612C0 (5804)
BSS:        0x00F612D0 - 0x00FA688C (284092)
Heap:       0x00FA688C - 0x017A688C (8388608)
Stack:      0x017A688C - 0x017A888C (8192)
Text:       0x00F00000 - 0x00F53D54 (343380)
Boot:       0x017A9000 - 0x017E9000
Reloc:      I:00000000 - D:00000000

Mac:0-22-15-a5-3-0
Device eth0:  hwaddr 00-22-15-A5-03-00, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
upgrade wait time is 3s  



自己弄好了，命令少打了

yxb***

都没人看么，顶一下

婕***

我看了，我很关心你的cfe哪里来的，我也想要,有的话发我一份

2952***

少打了什么命令？

afe***

我自己编译这个路由的cfe