小白求助,lg5000有台升级成功的最新固件,然后我编程器移植到另一台LG5000上
本帖最后由 kk老大 于 2019-11-3 22:04 编辑用ttl显示以下信息,求高手解读下,什么问题改怎么弄。。。是unifi
U-Boot unifi-v2.0.2.288-ga8e39aa8 (Oct 30 2018 - 14:05:25)
DRAM:32 MB
Base:0x80000000, Top:0x82000000, Res logbuf:0xa1ff3800, log_magic:0xe244aec0 kse g: 0xa0000000
Flash:8 MB
PCIe WLAN Module found (tries: 1).
Net: No valid address in Flash. Using fixed address
eth0, eth1
Board: Copyright Ubiquiti Networks Inc. 2014
Hit any key to stop autoboot:0
Board: Ubiquiti Networks AR7241 board (e512.0101.002e)
0. Name = u-boot, offset = 0, start_addr=9f000000, size=262144,start_sector=0, end_sector=3
1. Name = u-boot-env, offset = 40000, start_addr=9f040000, size=65536,start_sec tor=4, end_sector=4
2. Name = kernel, offset = 50000, start_addr=9f050000, size=7733248,start_secto r=5, end_sector=122
3. Name = rootfs, offset = 7b0000, start_addr=9f7b0000, size=6684672,start_sect or=123, end_sector=224
4. Name = cfg, offset = e10000, start_addr=9fe10000, size=262144,start_sector=2 25, end_sector=228
5. Name = EEPROM, offset = e50000, start_addr=9fe50000, size=65536,start_sector =229, end_sector=229
UBNT application initialized
reset button pressed: clearing cfg partition!
First 0x7b last 0x7e sector size 0x10000
.... done
reset button pressed: clearing u-boot-env partition!
First 0x4 last 0x4 sector size 0x10000
. done
u-boot-env is invalid, overiding with default.
First 0x4 last 0x4 sector size 0x10000
. done
write addr: 9f040000
Setting default IP 192.168.1.20
Starting TFTP server...
Using eth0 (192.168.1.20), address: 0x81000000
Waiting for connection: /
页:
[1]