|
|
前一阵子特价买的R1，买来就直接换了32M内存和8Mflash，跳线也改了，直接拿编程器写入的a100的编程器固件，用ttl查看输出信息，发现无限重启，求解。
附上启动信息
- U-Boot 1.1.8 (Feb 6 2012 - 16:07:57)
- Board: Ralink APSoC DRAM: 32 MB
- relocate_code Pointer at: 81fb0000
- spi_wait_nsec: 42
- spi device id: ef 40 17 0 0 (40170000)
- find flash: W25Q64BV
- raspi_read: from:30000 len:1000
- .*** Warning - bad CRC, using default environment
- ============================================
- Ralink UBoot Version: 3.6.0.0
- --------------------------------------------
- ASIC 5350_MP (Port5<->None)
- DRAM_CONF_FROM: Boot-Strapping
- DRAM_TYPE: SDRAM
- DRAM_SIZE: 256 Mbits
- DRAM_WIDTH: 16 bits
- DRAM_TOTAL_WIDTH: 16 bits
- TOTAL_MEMORY_SIZE: 32 MBytes
- Flash component: SPI Flash
- Date:Feb 6 2012 Time:16:07:57
- ============================================
- icache: sets:256, ways:4, linesz:32 ,total:32768
- dcache: sets:128, ways:4, linesz:32 ,total:16384
- ##### The CPU freq = 360 MHZ ####
- estimate memory size =32 Mbytes
- raspi_read: from:40028 len:6
- .
- raspi_read: from:0 len:30004
- ....[ff ff]
- Init Plat A1
- *************Is_update = 0 plat = 1**************
- No lcd plat
- Disable usb
- Usb ok
- Please choose the operation:
- 1: Load system code to SDRAM via TFTP.
- 2: Load system code then write to Flash via TFTP.
- 3: Boot system code via Flash (default).
- 4: Entr boot command line interface.
- 7: Load Boot Loader code then write to Flash via Serial.
- 9: Load Boot Loader code then write to Flash via TFTP.
- You choosed 3
- 0
-
- 3: System Boot system code via Flash.
- ## Booting image at bc050000 ...
- raspi_read: from:50000 len:40
- . Image Name: Linux Kernel Image
- Created: 2012-07-30 7:18:26 UTC
- Image Type: MIPS Linux Kernel Image (lzma compressed)
- Data Size: 5538252 Bytes = 5.3 MB
- Load Address: 80000000
- Entry Point: 803a0000
- raspi_read: from:50040 len:5481cc
- ..................................................................................... Verifying Checksum ... OK
- Uncompressing Kernel Image ... OK
- No initrd
- ## Transferring control to Linux (at address 803a0000) ...
- ## Giving linux memsize in MB, 32
- Starting kernel ...
- LINUX started...
- THIS IS ASIC
- Linux version 2.6.21 (root@localhost.localdomain) (gcc version 3.4.2) #178 Fri Jul 27 13:47:46 CST 2012
- The CPU frequency set to 360 MHz
- CPU revision is: 0001964c
- Determined physical RAM map:
- memory: 02000000 @ 00000000 (usable)
- Built 1 zonelists. Total pages: 8128
- Kernel command line: console=ttyS1,57600n8 root=/dev/mtdblock5
- Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
- Primary data cache 16kB, 4-way, linesize 32 bytes.
- Synthesized TLB refill handler (20 instructions).
- Synthesized TLB load handler fastpath (32 instructions).
- Synthesized TLB store handler fastpath (32 instructions).
- Synthesized TLB modify handler fastpath (31 instructions).
- Cache parity protection disabled
- cause = 70808018, status = 11000000
- PID hash table entries: 128 (order: 7, 512 bytes)
- calculating r4koff... 0015f900(1440000)
- CPU frequency 360.00 MHz
- Using 180.000 MHz high precision timer.
- Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
- Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
- Memory: 28560k/32768k available (3051k kernel code, 4208k reserved, 656k data, 116k init, 0k highmem)
- Mount-cache hash table entries: 512
- NET: Registered protocol family 16
- usbcore: registered new interface driver usbfs
- usbcore: registered new interface driver hub
- usbcore: registered new device driver usb
- NET: Registered protocol family 2
- Time: MIPS clocksource has been installed.
- IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
- TCP established hash table entries: 1024 (order: 1, 8192 bytes)
- TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
- TCP: Hash tables configured (established 1024 bind 1024)
- TCP reno registered
- deice id : ef 40 17 0 0 (40170000)
- W25Q64BV(ef 40170000) (8192 Kbytes)
- mtd .name = raspi, .size = 0x00800000 (8M) .erasesize = 0x00010000 (64K) .numeraseregions = 0
- Creating 7 MTD partitions on "raspi":
- 0x00000000-0x00800000 : "ALL"
- 0x00000000-0x00030000 : "Bootloader"
- 0x00030000-0x00040000 : "Config"
- 0x00040000-0x00050000 : "Factory"
- 0x00050000-0x0018220c : "Kernel"
- mtd: partition "Kernel" doesn't end on an erase block -- force read-only
- 0x0018220c-0x01000000 : "RootFS"
- mtd: partition "RootFS" extends beyond the end of device "raspi" -- size truncated to 0x67ddf4
- mtd: partition "RootFS" doesn't start on an erase block boundary -- force read-only
- 0x00050000-0x01000000 : "Kernel_RootFS"
- mtd: partition "Kernel_RootFS" extends beyond the end of device "raspi" -- size truncated to 0x7b0000
- RT3xxx EHCI/OHCI init.
- squashfs: version 3.2-r2 (2007/01/15) Phillip Lougher
- squashfs: LZMA suppport for slax.org by jro
- fuse init (API version 7.8)
- io scheduler noop registered (default)
- Hame plat 1
- Ralink gpio driver initialized [003c7f01]
- HDLC line discipline: version $Revision: 1.1.1.1 $, maxframe=4096
- N_HDLC line discipline registered.
- Serial: 8250/16550 driver $Revision: 1.8 $ 2 ports, IRQ sharing disabled
- serial8250: ttyS0 at I/O 0xb0000500 (irq = 37) is a 16550A
- serial8250: ttyS1 at I/O 0xb0000c00 (irq = 12) is a 16550A
- loop: loaded (max 8 devices)
- rdm_major = 253
- eth2 mii.o query= phy_id:0, address:1 retval:7849
- Ralink APSoC Ethernet Driver Initilization. v2.1 256 rx/tx descriptors allocated, mtu = 1500!
- MAC_ADRH -- : 0x00009c41
- MAC_ADRL -- : 0x7cb00b40
- PROC INIT OK!
- PPP generic driver version 2.4.2
- PPP BSD Compression module registered
- NET: Registered protocol family 24
- PPPoL2TP kernel driver, V0.17
- PPTP driver version 0.8.1
- === pAd = c0019000, size = 628392 ===
- <-- RTMPAllocAdapterBlock, Status=0
- block2mtd: version $Revision: 1.1.1.1 $
- usbcore: registered new interface driver cdc_acm
- drivers/usb/class/cdc-acm.c: v0.25:USB Abstract Control Model driver for USB modems and ISDN adapters
- nf_conntrack version 0.5.0 (256 buckets, 2048 max)
- ip_tables: (C) 2000-2006 Netfilter Core Team, Type=Restricted Cone
- arp_tables: (C) 2002 David S. Miller
- TCP cubic registered
- NET: Registered protocol family 1
- NET: Registered protocol family 10
- NET: Registered protocol family 17
- 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
- All bugs added by David S. Miller <davem@redhat.com>
- VFS: Mounted root (squashfs filesystem) readonly.
- Freeing unused kernel memory: 116k freed
- init started: BusyBox v1.12.1 (2011-11-21 13:19:18 CST)
- starting pid 14, tty '': '/etc_ro/rcS'
- Algorithmics/MIPS FPU Emulator v1.5
- devpts: called with bogus options
- -------------------------------------------
- Welcome to
- __ __ __ __ __ ______
- | | | | / \ | \ / | | ____|
- | |_| | / /\ \ | |\\//| | | |___
- | _ | |_/__\ \ | | \/ | | | |___|
- | | | | | | | | | | | | | |___
- |_| |_| |_| |_| |_| |_| |_____|
- HameData Technology Co., Ltd
- -------------------------------------------
- killall: goahead: no process killed
- ---=== reset by HAME ===---
- killall: chat: no process killed
- killall: pppd: no process killed
- killall: 3g: no process killed
- killall: lcdaemon: no process killed
- killall: minidlna: no process killed
- killall: wscd: no process killed
- clean user parascheck = WebInit=
- okokokokokokokokkokkoko
- The system is going down NOW!
- Sending SIGTERM to all processes
- Sending SIGKILL to all processes
- Requesting system reboot
- Restarting system.
|
|
IP卡
狗仔卡
发表于 2013-12-15 16:25
置顶卡
沉默卡
喧嚣卡
顶贴卡
显身卡
谢谢
非常感谢，我的cpu虚焊了，过两天找修手机的吹吹，另外求刷机方法。ttl显示checksum bad。。。。压住cpu可以开机，不压住没用。。。
非常感谢，我来试试看