【求助】ttl救砖不能选择boot启动项

xoribeb575

还没设置uart_en=1，boot_wait=on就刷成砖了
现在ttl看到直接默认3进入系统然后卡在

1. raeth: HW IP/TCP/UDP checksum RX/TX offload enabled
   
2. raeth: HW VLAN RX offload enabled
   
3. raeth: HW VLAN TX offload enabled
   
4. raeth: HW Scatter/Gather TX offload enabled
   
5. raeth: HW TCP segmentation offload (TSO) enabled
   
6. mtk_esw - hw bridge: W|LLLL
   
7. mtk_esw - set broadcast storm control rate as: 10 mbps
   
8. device eth2 entered promiscuous mode

复制代码

其他几个选项不能选，这种情况还有救吗

1. Please choose the operation:
   
2.    1: Load system code to SDRAM via TFTP.
   
3.    2: Load system code then write to Flash via TFTP.
   
4.    3: Boot system code via Flash (default).
   
5.    4: Entr boot command line interface.
   
6.    7: Load Boot Loader code then write to Flash via Serial.
   
7.    9: Load Boot Loader code then write to Flash via TFTP.

复制代码

xoribeb575

解决 https://www.right.com.cn/forum/thread-4044794-1-1.html

neme

xoribeb575 发表于 2020-8-1 02:49
解决 https://www.right.com.cn/forum/thread-4044794-1-1.html

难道是通过引导时断电，开启了uboot输入？

oNe_cAt

Please choose the operation:
   1: Load system code to SDRAM via TFTP.
   2: Load system code then write to Flash via TFTP.
   3: Boot system code via Flash (default).
   4: Entr boot command line interface.
   7: Load Boot Loader code then write to Flash via Serial.
   9: Load Boot Loader code then write to Flash via TFTP.


楼主，我跑到这直接自动选3。其它选项都选不了。重试，断电10几秒再开，同样结果。ctrl+c都试过了。
楼主是怎么解决的？

oNe_cAt

oNe_cAt 发表于 2022-5-17 09:57
Please choose the operation:
   1: Load system code to SDRAM via TFTP.
   2: Load system code th ...

卡在了这时：
event signal: Alarm clock
event signal: User defined signal 1
rc notification: control_wifi_guest_rt_off
rc notification: control_wifi_radio_rt_on
rc notification: control_wifi_guest_wl_off
rc notification: control_wifi_radio_wl_on