在tomato上设置wds（分享）

eddiechen

只有一个router，没有测试过，不过今天在tomato网站上看到设置wds的步骤，倒是很详细的，虽然是英文，不过很清楚

http://www.polarcloud.com/tomatofaq#how_do_i_use_wds


How do I use WDS?[toc, link]

Here's an example basic 2-router setup as configured in the Basic/Network page:

#1 - 00:11:11:11:11:11
The WAN port of this router is connected to the Internet.

WAN
(configure normally)

LAN
IP Address = 192.168.1.1
DHCP Server = enabled

Wireless
Wireless Mode = Access Point + WDS
SSID = samessid
Channel = 3
Security = WPA Personal
Encryption = AES
Shared Key = samesharedkey
WDS = Link With
MAC Address = 00:22:22:22:22:22 (the *wireless* MAC of the 2nd router)


#2 - 00:22:22:22:22:22
The WAN port of this router is not used.

WAN
Type = Disabled

LAN
IP Address = 192.168.1.2
Default Gateway = 192.168.1.1 (the 1st router's IP address)
Static DNS = 192.168.1.1 (the 1st router's IP address or any DNS server)
DHCP Server = Disabled (the 1st router handles it)

Wireless
Wireless Mode = Access Point + WDS
SSID = samessid
Channel = 3
Security = WPA Personal
Encryption = AES
Shared Key = samesharedkey
WDS = Link With
MAC Address = 00:11:11:11:11:11 (the *wireless* MAC of the 1st router)

Once you configure #2, you can hook up wired computers on it or use it as a second AP to extend your LAN's wireless range. As long as you configure your notebook not to stick to a single MAC address, it should switch automatically to the strongest signal as you move around.

You can chain several more routers this way by changing the WDS' MAC address field. #1 --- #2 --- #3

    #1
   /  \
  /    \
#2      #3
But avoid creating loop or a situation where there are multiple paths.     #1
   /  \
  /    \
#2 ---- #3

    #1
   /  \
  /    \
#2      #3
  \    /
   \  /
    #4
If you have to do this for link redundancy, try enabling STP in Advanced/Routing to avoid problems.

ttchoice

我不知道该说什么了.....
搞了2天，WPA就是不工作！！！

早知道去tomato官网看了................

2007年的帖子，2010年，不对，2011年才看到，该死该死！！！

谢谢楼主的先见之明啊！！！

xxyk

收藏啦，但多个路由怎么避免形成环啊？或者多条路径？具体怎么设置？？

easyw

谢谢，借鉴一下。