|
本帖最后由 h000 于 2013-10-2 00:45 编辑
线路板
j1 开始 接 RX TX GND
背面短接TP18 到tp28
启动TTL
________ ________ __ __ ____ _ __ ___
|________|| ___ | | | | || \ | || | / /
| | | |___| | __ __ | | | || \| || |/ /
| | | _____| |__ __| | |___ | || |\ || \
|__| |__| |______||__||_| \____||__|\___\
Software Platform for MIPS
Creation date: Dec 15 2011, 22:21:49 (chenyunchuan@tp-link.net)
Copyright(C) 2001-2010 by TP-LINK TECHNOLOGIES CO., LTD.
CPU: AR9330: AP121 Board
CPU freq: 400 MHZ
SDRAM size: 8 MB
ipaddr:192.168.1.1
serverip:192.168.1.100
file:vxWorks.img
Attaching interface lo0... done
Rx clbufs 768 each of size 1756
eth_rx_netpool_init: allocated, pDmaBuf=0x80637910, buffend = 80782514
ATHRS26: resetting s26
ATHRS26: s26 reset done
eth_rx_netpool_init: done already!
Attached IPv4 interface to mirror unit 0
Press Ctrl+C to stop auto-boot...
0
auto-booting...
Uncompressing...done
Starting at 0x80001000...
Attaching interface lo0... done
Rx clbufs 528 each of size 1596
eth_rx_netpool_init: allocated, pDmaBuf=0x806a54e0, buffend = 80774124
ATHRS26: resetting s26
ATHRS26: s26 reset done
eth_rx_netpool_init: done already!
Attached IPv4 interface to mirror unit 0
Assertion failed: 0, file ../src/router_config/qos_RouterClassifier.c, line 319
在
Attached IPv4 interface to mirror unit 0
Press Ctrl+C to stop auto-boot...
这个地方不停止 我一开 路由器 就 狂按 Ctrl+C 还是继续 执行下去 不 中断 不能输入任何控制符。
是 什么 问题啊 怀疑TX 没找正确 。知道的 大大 说下 小弟 感谢了·
|
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有账号?立即注册
×
|