|
路由刷OPENWRT编程器固件后,偶尔才能正常启动,求解
引导停止在:eth0: 00:03:7f:09:0b:ad 与 ag7240_phy_setup 之间
路由型号:TP-link TL-WR710N
以下是TTL引导信息:
1)正常时引导并成功启动
U-Boot 1.1.4 (May 3 2012 - 22:04:42)
AP121 (ar9330) U-boot
DRAM: 64 MB
led turning on for 1s...
id read 0x100000ff
flash size 8388608, sector count = 128
Flash: 8 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag7240_enet_initialize...
No valid address in Flash. Using fixed address
Fetching MAC Address from 0x83ff3564
: cfg1 0x5 cfg2 0x7114
eth0: 00:03:7f:09:0b:ad
ag7240_phy_setup(ps:括号内内容与引导无关,这个过程不执行或者执行不成功?)
eth0 up
: cfg1 0xf cfg2 0x7214
eth1: 00:0c:f0:60:dc:98
athrs26_reg_init_lan
ATHRS26: resetting s26
ATHRS26: s26 reset done
ag7240_phy_setup
eth1 up
eth0, eth1
Autobooting in 3 seconds
## Booting image at 9f020000 ...
Uncompressing Kernel Image ... OK
Starting kernel ...
[ 0.000000] Linux version 3.3.3 (zeaxion@zeaxion-desktop) (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #1 Mon May 21 17:13:10 CST 2012
......(省略N行)
[ 21.440000] usbhid: USB HID core driver
[ 21.580000] fuse init (API version 7.18)
[ 34.440000] device eth0 entered promiscuous mode
2)不能正常引导和启动
1.试验第一次
U-Boot 1.1.4 (May 3 2012 - 22:04:42)
AP121 (ar9330) U-boot
DRAM: 64 MB
led turning on for 1s...
id read 0x100000ff
flash size 8388608, sector count = 128
Flash: 8 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag7240_enet_initialize...
No valid address in Flash. Using fixed address
Fetching MAC Address from 0x83ff3564
: cfg1 0x5 cfg2 0x7114
eth0: 00:03:7f:09:0b:ad
2.试验第二次
U-Boot 1.1.4 (May 3 2012 - 22:04:42)
AP121 (ar9330) U-boot
DRAM: 64 MB
led turning on for 1s...
id read 0x100000ff
flash size 8388608, sector count = 128
Flash: 8 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag7240_enet_initialize...
No valid address in Flash. Using fixed address
Fetching MAC Address from 0x83ff3564
: cfg1 0x5 cfg2 0x7114
eth0: 00:03:7f:09:0b:ad
|
|