|
|
本帖最后由 460418589 于 2014-7-14 12:50 编辑
大神们看看这机器有没有搞头！！！本机固件是OP的
机器配置为：
CPU:MNDSPEED M82172G-YY 双核ARM 450MHz
内存：2*128M DDR2 还有两个空焊位
网络端口：2个千兆交换机芯片，wan口是单独的千兆芯片，lan是4口的ar8316，
其他端口：2个usb，其中一个是空位，minipci空焊位一个
无线：bgn频段用rt3052做控制器，单独给它配了4兆的闪存和8兆的内存
SCP上的目录
启动完成后的信息（也不算完成，到这一步后系统还要启动3052那一部分）
启动信息：
U-Boot 1.1.6 (Mar 4 2011 - 10:29:05) Teldat 1.0.3
DRAM: 256 MB
Comcerto Flash Subsystem Initialization
Flash: 4 MB
NAND: board_nand_init nand->IO_ADDR_R =30000000
256 MiB
In: serial
Out: serial
Err: serial
Reserve MSP memory
Net: comcerto_gemac0, comcerto_gemac1
ethaddr=00:A0:26:7C:F8:78
sernum1=745/010701
sernum2=745/010701
Enter password - autoboot in 3 sec...
NAND read: device 0 offset 0x0, size 0x200000
Reading data from 0x1ff800 -- 100% complete.
2097152 bytes read: OK
## Booting image at 81000000 ...
Image Name: Linux-2.6.21.1-iR4-1.0.3
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1313876 Bytes = 1.3 MB
Load Address: 81408000
Entry Point: 81408000
Verifying Checksum ... OK
OK
Starting kernel ...
Uncompressing Linux................................................................................... done, booting the kernel.
Linux version 2.6.21.1-iR4-1.0.3 (cgarcia@orion) (gcc version 4.1.2) #11 Fri Mar 11 16:11:54 CET 2011
CPU: ARMv6-compatible processor [4117b361] revision 1 (ARMv6TEJ), cr=00c5387f
Machine: Comcerto 100 (Teldat board)
Memory policy: ECC disabled, Data cache writeback
CPU0: D VIPT write-back cache
CPU0: I cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets
CPU0: D cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets
Built 1 zonelists. Total pages: 62992
Kernel command line: init=/etc/preinit root=/dev/mtdblock6 rootfstype=yaffs2 ro console=ttyS0,115200 mtdparts=comcertoflash.0:256k(boot)ro,128k(env),128k(tldt)ro,1280k(kr)ro,-(fs)
ro;comcertonand:2M(kr1),100M(fs1),2M(kr2),100M(fs2),-(cfg) hwaddress=eth2,00:A0:26:7C:F8:78
PID hash table entries: 1024 (order: 10, 4096 bytes)
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 248MB = 248MB total
Memory: 248960KB available (2368K code, 274K data, 88K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
L2X0 cache controller enabled
SPI core: loaded version 0.2
Comcerto PCI: init
PCI: bus0: Fast back to back transfers enabled
Generic PHY: Registered new driver
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP reno registered
SPI core: add adapter comcerto-spi
arm1: Module loaded.
squashfs: version 3.0 (2006/03/15) Phillip Lougher
JFFS2 version 2.2. (NAND) (C) 2001-2006 Red Hat, Inc.
yaffs Mar 4 2011 11:40:32 Installing.
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x10090000 (irq = 41) is a 16550A
serial8250.0: ttyS1 at MMIO 0x10094000 (irq = 58) is a 16550A
loop: loaded (max 8 devices)
nbd: registered device at major 43
eth0: Comcerto Ethernet Controller 00:ed:cd:ef:aa:cc
eth2: Comcerto Ethernet Controller 00:a0:26:7c:f8:78
Comcerto MDIO Bus: probed
Comcerto MDIO Bus: probed
comcertoflash.0: Found 1 x16 devices at 0x0 in 16-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
5 cmdlinepart partitions found on MTD device comcertoflash.0
Creating 5 MTD partitions on "comcertoflash.0":
0x00000000-0x00040000 : "boot"
0x00040000-0x00060000 : "env"
0x00060000-0x00080000 : "tldt"
0x00080000-0x001c0000 : "kr"
0x001c0000-0x00400000 : "fs"
NAND device: Manufacturer ID: 0xad, Chip ID: 0xda (Hynix NAND 256MiB 3,3V 8-bit)
Scanning device for bad blocks
Bad eraseblock 248 at 0x01f00000
Bad eraseblock 595 at 0x04a60000
5 cmdlinepart partitions found on MTD device comcertonand
Creating 5 MTD partitions on "comcertonand":
0x00000000-0x00200000 : "kr1"
0x00200000-0x06600000 : "fs1"
0x06600000-0x06800000 : "kr2"
0x06800000-0x0cc00000 : "fs2"
0x0cc00000-0x10000000 : "cfg"
TCP westwood registered
NET: Registered protocol family 1
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
IPv6 over IPv4 tunneling driver
sit0: Disabled Privacy Extensions
NET: Registered protocol family 17
NET: Registered protocol family 15
Initializing NETLINK_KEY socket
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
yaffs: dev is 32505862 name is "mtdblock6"
yaffs: Attempting MTD mount on 31.6, "mtdblock6"
block 233 is bad
block 580 is bad
VFS: Mounted root (yaffs2 filesystem) readonly.
Freeing init memory: 88K
- preinit -
yaffs: dev is 32505865 name is "mtdblock9"
yaffs: Attempting MTD mount on 31.9, "mtdblock9"
- init -
Please press Enter to activate this console.
BusyBox v1.14.4 (2011-03-04 10:47:59 CET) built-in shell (ash)
Enter 'help' for a list of built-in commands.
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
M I N D S P E E D Technologies - Build v5.2 for Comcerto
----------------------
|
本帖子中包含更多资源
您需要 登录 才可以下载或查看，没有账号？立即注册
×
评分
-
查看全部评分
|
简体中文
繁體中文
English
日本語
Deutsch
한국 사람
بالعربية
TÜRKÇE
português
คนไทย
IP卡
狗仔卡
发表于 2014-7-11 21:37
置顶卡
沉默卡
喧嚣卡
顶贴卡
显身卡