7620n ttl输出 开始输出breed是正常的 后面乱码 怎么破

liukun3389

Boot and Recovery Environment for Embedded Devices
Copyright (C) 2015 HackPascal <hackpascal@gmail.com>
Build date 2015-12-07 [git-1e17c2e]
Version 1.0 (r802)

DRAM: 64MB
Platform: MediaTek MT7620N ver 2, eco 3
Board: Reference design
Clocks: CPU: 580MHz, Bus: 193MHz
Flash: Winbond W25Q128 (16MB) on rt2880-spi
rt2880-eth: MAC address from EEPROM is invalid, using default settings.
rt2880-eth: Using MAC address 00:0c:43:00:00:01
eth0: MediaTek MT7620N built-in 5-port 10/100M switch

Network started on eth0, inet addr 192.168.1.1, netmask 255.255.255.0

Press any key to interrupt autoboot ... 0   

Trying to boot firmware from 0x00050000 in flash bank 0 ...
Reading data into memory ...
U-Boot firmware image header detected.
    Image Name:         RT-N14U-GPIO-26-ZTEQ7-6
    Data Size:    10543284 Bytes
    Load Address: 80000000
    Entry Point:  802bece0
Uncompressing data (LZMA) ... done.
Flushing cache ... done.

Starting kernel at 0x802bece0...


責頺文艒幙揶豬Y鰎L╆瀆垑g0
厔阧蘯3

liukun3389

Starting kernel at 0x802bece0...


責頺文艒幙揶豬Y鰎L╆瀆垑g0
厔阧蘯3

liukun3389

只能贴图片了

小茅

说明固件用的码率和Breed用的不一样，你要是调成固件的码率，那Breed部分就是乱码，调成Breed的码率，固件部分就是乱码。H大的帖子里面标注了每种Breed的码率，你可以看看你的设备是否有专用版