|
今天在机器中刷了官网的固件,用了三个版本,出同样错,请指教下怎么回事
12.07
cap4200ag-jffs2-sysupgrade.bin
cap4200ag-kernel.bin
cap4200ag-rootfs-jffs2.bin
cap4200ag-rootfs-squashfs.bin
15.05
cap4200ag-kernel.bin
cap4200ag-rootfs-squashfs.bin
15.05我用kernel.bin和rootfs-squashfs.bin刷机
下面是信息
Starting kernel at 0x80060000...
[ 0.000000] Linux version 4.4.14 (buildbot@owrtbuild01) (gcc version 5.3.0 (OpenWrt GCC 5.3.0 12009) ) #1 Wed Dec 6 23:56:36 UTC 2017
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU0 revision is: 0001974c (MIPS 74Kc)
[ 0.000000] SoC: Atheros AR9344 rev 2
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 04000000 @ 00000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] No valid device tree found, continuing without
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x0000000000000000-0x0000000003ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x0000000000000000-0x0000000003ffffff]
[ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000003ffffff]
[ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
[ 0.000000] Kernel command line: board=CAP4200AG console=ttyS0,115200 mtdparts=spi0.0:256k(u-boot),64k(u-boot-env),320k(custom)ro,1536k(kernel),12096k(rootfs),2048k(failsafe),64k(art),13632k@0xa0000(firmware) rootfstype=squashfs,jffs2 noinitrd
[ 0.000000] PID hash table entries: 256 (order: -2, 1024 bytes)
[ 0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
[ 0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.000000] Writing ErrCtl register=00000000
[ 0.000000] Readback ErrCtl register=00000000
[ 0.000000] Memory: 59904K/65536K available (3134K kernel code, 174K rwdata, 784K rodata, 316K init, 206K bss, 5632K reserved, 0K cma-reserved)
[ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[ 0.000000] NR_IRQS:51
[ 0.000000] Clocks: CPU:560.000MHz, DDR:450.000MHz, AHB:225.000MHz, Ref:40.000MHz
[ 0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 6825930166 ns
[ 0.000009] sched_clock: 32 bits at 280MHz, resolution 3ns, wraps every 7669584382ns
[ 0.008696] Calibrating delay loop... 278.93 BogoMIPS (lpj=1394688)
[ 0.081657] pid_max: default: 32768 minimum: 301
[ 0.086936] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.094325] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.104991] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[ 0.117296] NET: Registered protocol family 16
[ 0.123807] MIPS: machine is Senao CAP4200AG
[ 0.131963] registering PCI controller with io_map_base unset
[ 0.358601] PCI host bridge to bus 0000:00
[ 0.363239] pci_bus 0000:00: root bus resource [mem 0x10000000-0x13ffffff]
[ 0.370904] pci_bus 0000:00: root bus resource [io 0x0000]
[ 0.377120] pci_bus 0000:00: root bus resource [??? 0x00000000 flags 0x0]
[ 0.384686] pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff]
[ 0.393608] pci 0000:00:00.0: invalid calibration data
[ 0.399824] pci 0000:00:00.0: BAR 0: assigned [mem 0x10000000-0x1001ffff 64bit]
[ 0.408028] pci 0000:00:00.0: BAR 6: assigned [mem 0x10020000-0x1002ffff pref]
[ 0.416086] pci 0000:00:00.0: using irq 40 for pin 1
[ 0.422583] clocksource: Switched to clocksource MIPS
[ 0.429612] NET: Registered protocol family 2
[ 0.435491] TCP established hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.443331] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.450426] TCP: Hash tables configured (established 1024 bind 1024)
[ 0.457612] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.464169] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.471472] NET: Registered protocol family 1
[ 0.477541] futex hash table entries: 256 (order: -1, 3072 bytes)
[ 0.503103] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.509623] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 0.523213] io scheduler noop registered
[ 0.527594] io scheduler deadline registered (default)
[ 0.533685] Serial: 8250/16550 driver, 16 ports, IRQ sharing enabled
[ 0.543661] console [ttyS0] disabled
[ 0.567740] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11, base_baud = 2500000) is a 16550A
[ 0.577370] console [ttyS0] enabled
[ 0.577370] console [ttyS0] enabled
[ 0.584797] bootconsole [early0] disabled
[ 0.584797] bootconsole [early0] disabled
[ 0.598893] m25p80 spi0.0: found w25q128, expected m25p80
[ 0.604453] m25p80 spi0.0: w25q128 (16384 Kbytes)
[ 0.609259] 8 cmdlinepart partitions found on MTD device spi0.0
[ 0.615277] Creating 8 MTD partitions on "spi0.0":
[ 0.620143] 0x000000000000-0x000000040000 : "u-boot"
[ 0.627456] 0x000000040000-0x000000050000 : "u-boot-env"
[ 0.634589] 0x000000050000-0x0000000a0000 : "custom"
[ 0.641312] 0x0000000a0000-0x000000220000 : "kernel"
[ 0.648103] 0x000000220000-0x000000df0000 : "rootfs"
[ 0.654919] mtd: device 4 (rootfs) set to be root filesystem
[ 0.660732] mtdsplit: no squashfs found in "rootfs"
[ 0.665755] 0x000000df0000-0x000000ff0000 : "failsafe"
[ 0.672769] 0x000000ff0000-0x000001000000 : "art"
[ 0.679263] 0x0000000a0000-0x000000df0000 : "firmware"
[ 0.697824] libphy: ag71xx_mdio: probed
[ 1.362862] ag71xx ag71xx.0: connected to PHY at ag71xx-mdio.0:00 [uid=004dd072, driver=Atheros 8035 ethernet]
[ 1.373751] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode:RGMII
[ 1.382365] NET: Registered protocol family 10
[ 1.391250] NET: Registered protocol family 17
[ 1.395910] bridge: automatic filtering via arp/ip/ip6tables has been deprecated. Update your scripts to load br_netfilter if you need this.
[ 1.408774] Bridge firewalling registered
[ 1.412994] 8021q: 802.1Q VLAN Support v1.8
[ 1.421305] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000000: 0x9fcc instead
[ 1.430994] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000004: 0x4576 instead
[ 1.440619] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000008: 0x88b6 instead
[ 1.450244] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0000000c: 0x6bd6 instead
[ 1.459871] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000010: 0xdc1f instead
[ 1.469499] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000014: 0x9264 instead
[ 1.479125] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000018: 0xa401 instead
[ 1.488753] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0000001c: 0xa3d8 instead
[ 1.498381] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000020: 0x5746 instead
[ 1.508007] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000024: 0xde33 instead
[ 1.517629] jffs2: Further such events for this erase block will not be printed
[ 1.540292] jffs2: Old JFFS2 bitmask found at 0x00008da4
似乎固件不完全??
来只老鸟看一下吧。。…。………
请不要胡乱输入以及粘贴、复制等方式灌水
请尊重作者、并共同维护网站的正常阅读,否则账户将会被限制发帖、回帖,并且积分可能会被清零,站内短信以及阅读权限等都会受到影响,谢谢。
具体限制方式:https://www.right.com.cn/forum/thread-8307840-1-1.html
|
|