各位大佬求助求助

cpahk

启动如下该如何处理！
.......................................................................................................................   Verifying Checksum ... Bad Data CRC
Verifying kernel2 uImage CRC, addr: 0xbc600000
   Image Name:          MI-R3P
   Image Type:   MIPS Linux Kernel Image (lzma compressed)
   Data Size:    25269958 Bytes = 24.1 MB
   Load Address: 80001000
   Entry Point:  802dc390
..................................................................................................................................................................................................................................................................................................................................................................................................   Verifying Checksum ... OK
Booting System 2
..Erasing NAND Flash...
ranand_erase: start:40000, len:20000
.Writing to NAND Flash...
done

3: System Boot system code via Flash.
## Booting image at bc600000 ...
   Image Name:          MI-R3P
   Image Type:   MIPS Linux Kernel Image (lzma compressed)
   Data Size:    25269958 Bytes = 24.1 MB
   Load Address: 80001000
   Entry Point:  802dc390
..................................................................................................................................................................................................................................................................................................................................................................................................   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
commandline uart_en=0 factory_mode=0 usb_u3=0
No initrd
## Transferring control to Linux (at address 802dc390) ...
## Giving linux memsize in MB, 256

Starting kernel ...


INUX started...
Linux version 3.4.113 (padavan@hms) (gcc version 7.4.0 (crosstool-NG 1.24.0) ) #4 SMP Thu Dec 10 06:50:02 UTC 2020

MediaTek SoC: MT7621A, RevID: 0103, RAM: DDR3, XTAL: 40MHz
CPU/OCP/SYS frequency: 880/293/220 MHz
prom memory:256MB
CPU revision is: 0001992f (MIPS 1004Kc)
Determined physical RAM map:
memory: 10000000 @ 00000000 (usable)
Zone PFN ranges:
  Normal   0x00000000 -> 0x00010000
Movable zone start PFN for each node
Early memory PFN ranges
    0: 0x00000000 -> 0x00010000
Detected 3 available secondary CPU(s)
Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
MIPS secondary cache 256kB, 8-way, linesize 32 bytes.
PERCPU: Embedded 7 pages/cpu @81203000 s5952 r8192 d14528 u32768
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 65024
Kernel command line: console=ttyS0,115200n8 root=/dev/mtdblock4 rootfstype=squashfs
PID hash table entries: 1024 (order: 0, 4096 bytes)
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Writing ErrCtl register=00006950
Readback ErrCtl register=00006950
Memory: 255872k/262144k available (2963k kernel code, 6272k reserved, 579k data, 228k init, 0k highmem)
Hierarchical RCU implementation.
NR_IRQS:72
MIPS GIC RevID: 3.0
Setting up vectored interrupts
console [ttyS0] enabled
Calibrating delay loop... 577.53 BogoMIPS (lpj=1155072)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
MIPS secondary cache 256kB, 8-way, linesize 32 bytes.
CPU revision is: 0001992f (MIPS 1004Kc)
Synchronize counters for CPU 1: done.
Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
MIPS secondary cache 256kB, 8-way, linesize 32 bytes.
CPU revision is: 0001992f (MIPS 1004Kc)
Synchronize counters for CPU 2: done.
Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
MIPS secondary cache 256kB, 8-way, linesize 32 bytes.
CPU revision is: 0001992f (MIPS 1004Kc)
Synchronize counters for CPU 3: done.
Brought up 4 CPUs
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
PCI host bridge to bus 0000:00
pci_bus 0000:00: root bus resource [mem 0x60000000-0x6fffffff]
pci_bus 0000:00: root bus resource [io  0x1e160000-0x1e16ffff]
pci 0000:00:00.0: bridge configuration invalid ([bus 00-00]), reconfiguring
pci 0000:00:01.0: bridge configuration invalid ([bus 00-00]), reconfiguring
pci 0000:00:00.0: BAR 0: can't assign mem (size 0x80000000)
pci 0000:00:01.0: BAR 0: can't assign mem (size 0x80000000)
pci 0000:00:00.0: BAR 8: assigned [mem 0x60000000-0x600fffff]
pci 0000:00:01.0: BAR 8: assigned [mem 0x60100000-0x601fffff]
pci 0000:01:00.0: BAR 0: assigned [mem 0x60000000-0x600fffff 64bit]
pci 0000:00:00.0: PCI bridge to [bus 01-01]
pci 0000:00:00.0:   bridge window [mem 0x60000000-0x600fffff]
pci 0000:02:00.0: BAR 0: assigned [mem 0x60100000-0x601fffff 64bit]
pci 0000:00:01.0: PCI bridge to [bus 02-02]
pci 0000:00:01.0:   bridge window [mem 0x60100000-0x601fffff]
PCI: Enabling device 0000:00:00.0 (0000 -> 0002)
PCI: Enabling device 0000:00:01.0 (0000 -> 0002)
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 4, 65536 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP: reno registered
UDP hash table entries: 128 (order: 0, 4096 bytes)
NET: Registered protocol family 1
4 CPUs re-calibrate udelay (lpj = 1167360)
squashfs: version 4.0 (2009/01/31) Phillip Lougher
fuse init (API version 7.18)
msgmni has been set to 499
io scheduler noop registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x1e000c00 (irq = 34) is a 16550A
Ralink GPIO driver initialized. Number of GPIO: 64, GPIO mode: 000A05A8
loop: module loaded
MediaTek NAND driver init, version v2.1
MTK NFI: NAND ID [C8 DA, 90 95 44 7F]
MTK NFI: NAND chip found in MTK table: F59L2G81A
NAND device: Manufacturer ID: 0xc8, Chip ID: 0xda (ESMT NAND 256MiB 3,3V 8-bit), 256MiB, page size: 2048, OOB size: 64
Scanning device for bad blocks
MTK NFI: success load FACT_BBT from block 2047
Creating 9 MTD partitions on "MT7621-NAND":
0x000000000000-0x000000040000 : "Bootloader"
0x000000040000-0x0000000c0000 : "BootEnv"
0x0000000c0000-0x000000200000 : "Factory"
0x000000200000-0x000000360000 : "Kernel"
0x000000360000-0x000003200000 : "RootFS"
0x000003200000-0x000003280000 : "Config"
0x000003280000-0x000003300000 : "Storage"
0x000003300000-0x00000ff80000 : "RWFS"
0x000000200000-0x000003200000 : "Firmware_Stub"
tun: Universal TUN/TAP device driver, 1.6
tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
Ralink APSoC Ethernet Driver v3.2.4 (raeth)
raeth: PDMA RX ring 512, QDMA TX pool 1024. Max packet size 1536
raeth: NAPI & GRO support, weight 64
raeth: Byte Queue Limits (BQL) support
PPP generic driver version 2.4.2
PPP MPPE Compression module registered
NET: Registered protocol family 24
PPTP driver version 0.8.5
usbcore: registered new interface driver libusual
nf_conntrack version 0.5.0 (32768 buckets, 32768 max)
xt_time: kernel timezone is -0000
Bridge firewalling registered
gre: GRE over IPv4 demultiplexor driver
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP: cubic registered
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
L2TP core driver, V2.0
PPPoL2TP kernel driver, V2.0
8021q: 802.1Q VLAN Support v1.8
ASUS NVRAM, v0.08. Available space: 131072. Integrity: OK
SQUASHFS error: unable to read id index table
List of all partitions:
1f00             256 mtdblock0  (driver?)
1f01             512 mtdblock1  (driver?)
1f02            1280 mtdblock2  (driver?)
1f03            1408 mtdblock3  (driver?)
1f04           47744 mtdblock4  (driver?)
1f05             512 mtdblock5  (driver?)
1f06             512 mtdblock6  (driver?)
1f07          209408 mtdblock7  (driver?)
1f08           49152 mtdblock8  (driver?)
No filesystem could mount root, tried:  squashfs
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,4)

rapidkoku

我也遇到这个问题，不知道如何解决