|
本帖最后由 thgircomcn 于 2012-2-12 19:47 编辑
1.线应该没有接错,因为能正常输出启动过程,启动信息结束后也能输入字符,就是启动过程中按ctr+c没用
2.超级终端和PUTTY都试过了没用
TTL输入如下:
UART1 output test ok
Uart init
mfid=00000001 devid=00002249
Found 1 x 2M flash memory
---RealTek(RTL8186)at 2006.09.28-17:00+0800 version 1.4 [16bit](180MHz)
no sys signature at 00010000!
no sys signature at 00020000!
Jump to image start=0x80300000...
decompressing kernel:
Uncompressing Linux... done, booting the kernel.
done decompressing kernel.
Realtek FastPath v1.07a
serial console detected. Disabling virtual terminals.
init started: BusyBox v1.00-pre8 (2007.09.24-02:32+0000) multi-call binary
BusyBox v1.00-pre8 (2007.09.24-02:32+0000) Built-in shell (msh)
Enter 'help' for a list of built-in commands.
this time is gw
killall: pptp.sh: no process killed
killall: pppoe.sh: no process killed
start wlan interface
Initialize wlan0 interface
SIOCGIFFLAGS: No such device
Using wlan script...
232
233
/proc/sys/net/ipv4/: cannot create
# help
Built-in commands:
-------------------
. : break cd continue eval exec exit export help login newgrp
read readonly set shift times trap umask wait
#
#
#
|
|