|
https://item.taobao.com/item.htm ... 22&_u=48ull51b2,我买的这个,是不是有问题?
窗口内容复制部分如下
U-Boot 1.1.3 ( - )
Board: Ralink APSoC DRAM: 64 MB
MT7620 gpio init : WPS / RESET pin
GPIO#1 updated GPIOMODE register: 001a311c -> 001a311d
relocate_code Pointer at: 83fa4000
enable ephy clock...done. rf reg 29 = 5
SSC disabled.
spi_wait_nsec: 29
spi device id: c8 40 17 c8 40 (4017c840)
Warning: un-recognized chip ID, please update bootloader!
*** Warning - bad CRC, using default environment
============================================
Ralink UBoot Version: 4.3.0.0
--------------------------------------------
ASIC 7620_MP (Port5<->None)
DRAM component: 512 Mbits DDR, width 16
DRAM bus: 16 bit
Total memory: 64 MBytes
Flash component: SPI Flash
Date: Time:
============================================
icache: sets:512, ways:4, linesz:32 ,total:65536
dcache: sets:256, ways:4, linesz:32 ,total:32768
##### The CPU freq = 580 MHZ ####
estimate memory size =64 Mbytes
Press press hardware button for more than 4 seconds to run web failsafe mode
Catution: hardware button wasn't pressed or not long enough!
Continuing normal boot...
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP.
3: Boot system code via Flash (default).
4: Entr boot command line interface.
6: Load all then write to Flash via TFTP.
7: Load Boot Loader code then write to Flash via Serial.
9: Load Boot Loader code then write to Flash via TFTP.
You choosed 3
3: System Boot system code via Flash.
## Booting image at bc0a0000 ...
Image Name: OpenWrt-Linux-3.10.14
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 1259014 Bytes = 1.2 MB
Load Address: 80000000
Entry Point: 80000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 80000000) ...
## Giving linux memsize in MB, 64
Starting kernel ...
LINUX started...
THIS IS ASIC
SDK 5.0.S.0
|
|