TP-Link TL-WR841ND v8 国际版。。。刷砖了。。。求救。。。

cck***

1. Linux version 2.6.31--LSDK-9.2.0_U5.508 (root@CentOS) (gcc version 4.3.3 (GCC) ) #3 Tue May 29 14:41:21 HKT 2012
   
2. flash_size passed from bootloader = 4
   
3. Ram size passed from bootloader =33554432
   
4. CPU revision is: 0001974c (MIPS 74Kc)
   
5. ath_sys_frequency: cpu srif ddr srif cpu 535 ddr 400 ahb 200
   
6. Determined physical RAM map:
   
7. memory: 02000000 @ 00000000 (usable)
   
8. Zone PFN ranges:
   
9.   Normal   0x00000000 -> 0x00002000
   
10. Movable zone start PFN for each node
    
11. early_node_map[1] active PFN ranges
    
12.     0: 0x00000000 -> 0x00002000
    
13. Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
    
14. Kernel command line: console=ttyS0,115200 root=31:2 rootfstype=squashfs init=/sbin/init mtdparts=ath-nor0:128k(u-boot),1024k(kernel),2816k(rootfs),64k(config),64k(art) mem=32M
    
15. PID hash table entries: 128 (order: 7, 512 bytes)
    
16. Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
    
17. Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
    
18. Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
    
19. Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
    
20. Writing ErrCtl register=00000000
    
21. Readback ErrCtl register=00000000
    
22. Memory: 30132k/32768k available (1722k kernel code, 2636k reserved, 426k data, 112k init, 0k highmem)
    
23. NR_IRQS:128
    
24. plat_time_init: plat time init done
    
25. Calibrating delay loop... 267.26 BogoMIPS (lpj=534528)
    
26. Mount-cache hash table entries: 512
    
27. NET: Registered protocol family 16
    
28. bio: create slab <bio-0> at 0
    
29. usbcore: registered new interface driver usbfs
    
30. usbcore: registered new interface driver hub
    
31. usbcore: registered new device driver usb
    
32. NET: Registered protocol family 2
    
33. IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
    
34. TCP established hash table entries: 1024 (order: 1, 8192 bytes)
    
35. TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
    
36. TCP: Hash tables configured (established 1024 bind 1024)
    
37. TCP reno registered
    
38. NET: Registered protocol family 1
    
39. ATH GPIOC major 0
    
40. squashfs: version 4.0 (2009/01/31) Phillip Lougher
    
41. msgmni has been set to 58
    
42. io scheduler noop registered
    
43. io scheduler deadline registered (default)
    
44. Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
    
45. serial8250.0: ttyS0 at MMIO 0xb8020000 (irq = 19) is a 16550A
    
46. console [ttyS0] enabled
    
47. PPP generic driver version 2.4.2
    
48. NET: Registered protocol family 24
    
49. 5 cmdlinepart partitions found on MTD device ath-nor0
    
50. Creating 5 MTD partitions on "ath-nor0":
    
51. 0x000000000000-0x000000020000 : "u-boot"
    
52. 0x000000020000-0x000000120000 : "kernel"
    
53. 0x000000120000-0x0000003e0000 : "rootfs"
    
54. 0x0000003e0000-0x0000003f0000 : "config"
    
55. 0x0000003f0000-0x000000400000 : "art"
    
56. ->Oops: flash id 0xef4016 .
    
57. ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
    
58. Port Status 1c000004
    
59. ath-ehci ath-ehci.0: ATH EHCI
    
60. ath-ehci ath-ehci.0: new USB bus registered, assigned bus number 1
    
61. ehci_reset Intialize USB CONTROLLER in host mode: 13
    
62. ehci_reset Port Status 1c000000
    
63. ath-ehci ath-ehci.0: irq 3, io mem 0x1b000000
    
64. ehci_reset Intialize USB CONTROLLER in host mode: 13
    
65. ehci_reset Port Status 1c000000
    
66. ath-ehci ath-ehci.0: USB 2.0 started, EHCI 1.00
    
67. usb usb1: configuration #1 chosen from 1 choice
    
68. hub 1-0:1.0: USB hub found
    
69. hub 1-0:1.0: 1 port detected
    
70. TCP cubic registered
    
71. NET: Registered protocol family 17
    
72. 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
    
73. All bugs added by David S. Miller <davem@redhat.com>
    
74. athwdt_init: Registering WDT success
    
75. ath_otp_init: Registering OTP success
    
76. ath_clksw_init: Registering Clock Switch Interface success
    
77. VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
    
78. Freeing unused kernel memory: 112k freed
    
79. init started:  BusyBox v1.01 (2012.05.29-06:47+0000) multi-call binary
    
80. This Board use 2.6.31
    
81. xt_time: kernel timezone is -0000
    
82. nf_conntrack version 0.5.0 (512 buckets, 5120 max)
    
83. ip_tables: (C) 2000-2006 Netfilter Core Team
    
84. insmod: cannot open module `/lib/modules/2.6.31/kernel/iptable_raw.ko': No such file or directory
    
85. insmod: cannot open module `/lib/modules/2.6.31/kernel/flashid.ko': No such file or directory
    
86. PPPoL2TP kernel driver, V1.0
    
87. PPTP driver version 0.8.3
    
88. insmod: cannot open module `/lib/modules/2.6.31/kernel/harmony.ko': No such file or directory
    
89. unlzma/peek_old_byte: position 3465207 out of range
    
90. unlzma/peek_old_byte: position 347749 out of range
    
91. SQUASHFS error: crypto_decompress_update returned -124104, data probably corrupt
    
92. SQUASHFS error: squashfs_read_data failed to read block 0x1c279c
    
93. SQUASHFS error: Unable to read data cache entry [1c279c]
    
94. SQUASHFS error: Unable to read page, block 1c279c, size a1fa
    
95. SQUASHFS error: Unable to read data cache entry [1c279c]
    
96. SQUASHFS error: Unable to read page, block 1c279c, size a1fa
    
97. SQUASHFS error: Unable to read data cache entry [1c279c]
    
98. SQUASHFS error: Unable to read page, block 1c279c, size a1fa
    
99. SQUASHFS error: Unable to read data cache entry [1c279c]
    
100. SQUASHFS error: Unable to read page, block 1c279c, size a1fa
     
101. SQUASHFS error: Unable to read data cache entry [1c279c]
     
102. SQUASHFS error: Unable to read page, block 1c279c, size a1fa
     
103. 
     
104. (none) mips #3 Tue May 29 14:41:21 HKT 2012 (none)
     
105. (none) login:

复制代码