|
本帖最后由 sowxf 于 2014-1-25 12:53 编辑
CFE version 1.13.0-104.4 for BCM96368 (32bit,SP,BE)
Build Date: 08/17/2010 (kuanjung@MSGSW4-server2)
Copyright (C) 2000-2009 Broadcom Corporation.
Parallel flash device: name S29GL256P90, id 0x2222 size 32768KB
Total Flash size: 32768K with 256 sectors
ethsw: found bcm53115!
Chip ID: BCM6368B2, MIPS: 400MHz
Main Thread: TP0
Total Memory: 67108864 bytes (64MB)
Boot Address: 0xb8000000
Board IP address : 192.168.0.1:ffffff00
Host IP address : 192.168.0.100
Gateway IP address :
Run from flash/host (f/h) : f
Default host run file name : vmlinux
Default host flash file name : bcm963xx_fs_kernel
Boot delay (0-9 seconds) : 3
Board Id (0-11) : 96368MVWG
Number of MAC Addresses (1-32) : 4
Base MAC Address : 40:4a:03:f2:9f:60
PSI Size (1-128 KBytes : 128
Enable Backup PSI [0|1] : 0
System Log Size (0-256) KBytes : 0
Main Thread Number [0|1] : 0
*** Press any key to stop auto run (3 seconds) ***
Auto run second count down: 2
web info: Waiting for connection on socket 0.
CFE> ?
Invalid command: "?"
Available commands:
ATSE, ATEN, ATCR, ATSH, ATUR, ATUW, ATBL, ATDU, ATBR, ATGO, ATSR, ATMB, ATHE
*** command status = -1
CFE> athe
Available commands:
ATSE show the seed of password generator
ATEN set BootExtension Debug Flag
ATCR Clear console screen
ATSH dump manufacturer related data in ROM
ATUR xmodem upload router firmware to flash ROM
ATUW xmodem upload flash image to flash ROM
ATBL Print boot line and board parameter info
ATDU Dump memory or registers.
ATBR Reset to default Romfile
ATGO boot router
ATSR system reboot
ATMB Use for multiboot.
ATHE print help
For more information about a command, enter 'help command-name'
*** command status = 0
CFE>
我想改个Board Id 都不知道怎改
|
|