|
|
一台水星1200，固件是协成的店铺无线，目前故障是不分配ip地址，进不去路由，本着研究一下的目的，买
来ttl线，串口连接到路由器，出现以下信息。本人才疏学浅，看不懂，请教格位大侠。
1 路由器用ttl线连接后，SecureCRTPortable软件不显示任何信息，只有先接通路由器电源，再快速的插上ttl
线，才出现下列信息，不知道什么原因
2 这个路由器目前不能分配ip地址，无线和有线都不分配，从下列信息能看出什么原因吗？
[ 0.510000] PCI host bridge to bus 0000:00
[ 0.520000] pci_bus 0000:00: root bus resource [mem 0x10000000-0x13ffffff]
[ 0.520000] pci_bus 0000:00: root bus resource [io 0x0000]
[ 0.530000] pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff]
[ 0.530000] pci 0000:00:00.0: invalid calibration data
[ 0.540000] pci 0000:00:00.0: BAR 0: assigned [mem 0x10000000-0x101fffff 64bit]
[ 0.540000] pci 0000:00:00.0: BAR 6: assigned [mem 0x10200000-0x1020ffff pref]
[ 0.550000] pci 0000:00:00.0: using irq 40 for pin 1
[ 0.550000] Switching to clocksource MIPS
[ 0.560000] NET: Registered protocol family 2
[ 0.560000] TCP established hash table entries: 1024 (order: 1, 8192 bytes)
[ 0.560000] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.570000] TCP: Hash tables configured (established 1024 bind 1024)
[ 0.570000] TCP: reno registered
[ 0.570000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.580000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.590000] NET: Registered protocol family 1
[ 0.610000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.610000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 0.620000] msgmni has been set to 246
[ 0.630000] io scheduler noop registered
[ 0.630000] io scheduler deadline registered (default)
[ 0.630000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[ 0.660000] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
[ 0.670000] console [ttyS0] enabled, bootconsole disabled
[ 0.670000] console [ttyS0] enabled, bootconsole disabled
[ 0.680000] ath79-spi ath79-spi: master is unqueued, this is deprecated
[ 0.690000] m25p80 spi0.0: found s25fl064k, expected m25p80
[ 0.700000] m25p80 spi0.0: s25fl064k (8192 Kbytes)
[ 0.700000] 5 tp-link partitions found on MTD device spi0.0
[ 0.710000] Creating 5 MTD partitions on "spi0.0":
[ 0.710000] 0x000000000000-0x000000020000 : "u-boot"
[ 0.720000] 0x000000020000-0x0000001233e4 : "kernel"
[ 0.720000] mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
[ 0.740000] 0x0000001233e4-0x0000007f0000 : "rootfs"
[ 0.740000] mtd: partition "rootfs" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
[ 0.760000] mtd: device 2 (rootfs) set to be root filesystem
[ 0.760000] 1 squashfs-split partitions found on MTD device rootfs
[ 0.770000] 0x000000380000-0x0000007f0000 : "rootfs_data"
[ 0.780000] 0x0000007f0000-0x000000800000 : "art"
[ 0.780000] 0x000000020000-0x0000007f0000 : "firmware"
[ 0.800000] libphy: ag71xx_mdio: probed
[ 1.360000] ag71xx-mdio.1: Found an AR934X built-in switch
[ 2.390000] eth0: Atheros AG71xx at 0xba000000, irq 5, mode:GMII
[ 2.940000] ag71xx ag71xx.0: connected to PHY at ag71xx-mdio.1:04 [uid=004dd042, driver=Generic PHY]
[ 2.950000] eth1: Atheros AG71xx at 0xb9000000, irq 4, mode:MII
[ 2.960000] TCP: cubic registered
[ 2.960000] NET: Registered protocol family 17
[ 2.970000] 8021q: 802.1Q VLAN Support v1.8
[ 2.980000] VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
[ 2.990000] Freeing unused kernel memory: 284K (80329000 - 80370000)
procd: Console is alive
procd: - watchdog -
[ 5.180000] usbcore: registered new interface driver usbfs
[ 5.190000] usbcore: registered new interface driver hub
[ 5.190000] usbcore: registered new device driver usb
[ 5.200000] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
[ 5.210000] ehci-platform: EHCI generic platform driver
[ 5.220000] ehci-platform ehci-platform: EHCI Host Controller
[ 5.220000] ehci-platform ehci-platform: new USB bus registered, assigned bus number 1
[ 5.230000] ehci-platform ehci-platform: irq 3, io mem 0x1b000000
[ 5.260000] ehci-platform ehci-platform: USB 2.0 started, EHCI 1.00
[ 5.260000] hub 1-0:1.0: USB hub found
[ 5.270000] hub 1-0:1.0: 1 port detected
[ 5.270000] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
procd: - preinit -
Press the [f] key and hit [enter] to enter failsafe mode
Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level
jffs2 is ready
jffs2 is ready
[ 10.120000] jffs2: notice: (320) jffs2_build_xattr_subsystem: complete building xattr subsystem, 1 of xdatum (1 unchecked, 0 orphan) and 127 of xref (0 dead, 112 orphan) found.
switching to overlay
6+0 records in
6+0 records out
2104+0 records in
2104+0 records out
cp: can't create '/lib/firmware/ath10k/QCA988X/hw2.0/board.bin': No such file or directory
procd: - early -
procd: - watchdog -
procd: - ubus -
procd: - init -
Please press Enter to activate this console.
[ 11.900000] NET: Registered protocol family 10
[ 11.920000] nf_conntrack version 0.5.0 (1976 buckets, 7904 max)
[ 11.940000] ip6_tables: (C) 2000-2006 Netfilter Core Team
[ 11.960000] u32 classifier
[ 11.960000] input device check on
[ 11.970000] Actions configured
[ 11.980000] Mirror/redirect action on
[ 11.980000] Failed to load ipt action
[ 12.060000] Loading modules backported from Linux version master-2014-05-22-0-gf2032ea
[ 12.070000] Backport generated by backports.git backports-20140320-37-g5c33da0
[ 12.090000] ip_tables: (C) 2000-2006 Netfilter Core Team
[ 12.210000] xt_time: kernel timezone is -0000
[ 12.270000] cfg80211: Calling CRDA to update world regulatory domain
[ 12.270000] cfg80211: World regulatory domain updated:
[ 12.280000] cfg80211: DFS Master region: unset
[ 12.280000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp), (dfs_cac_time)
[ 12.290000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A, 2000 mBm), (N/A)
[ 12.300000] cfg80211: (2457000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm), (N/A)
[ 12.310000] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (N/A, 2000 mBm), (N/A)
[ 12.320000] cfg80211: (5170000 KHz - 5250000 KHz @ 160000 KHz), (N/A, 2000 mBm), (N/A)
[ 12.330000] cfg80211: (5250000 KHz - 5330000 KHz @ 160000 KHz), (N/A, 2000 mBm), (0 s)
[ 12.330000] cfg80211: (5490000 KHz - 5730000 KHz @ 160000 KHz), (N/A, 2000 mBm), (0 s)
[ 12.340000] cfg80211: (5735000 KHz - 5835000 KHz @ 80000 KHz), (N/A, 2000 mBm), (N/A)
[ 12.350000] cfg80211: (57240000 KHz - 63720000 KHz @ 2160000 KHz), (N/A, 0 mBm), (N/A)
[ 12.460000] PPP generic driver version 2.4.2
[ 12.490000] NET: Registered protocol family 24
[ 12.610000] cfg80211: Calling CRDA for country: US
[ 12.610000] cfg80211: Regulatory domain changed to country: US
[ 12.620000] cfg80211: DFS Master region: FCC
[ 12.630000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp), (dfs_cac_time)
[ 12.630000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A, 3000 mBm), (N/A)
[ 12.640000] cfg80211: (5170000 KHz - 5250000 KHz @ 80000 KHz), (N/A, 1700 mBm), (N/A)
[ 12.650000] cfg80211: (5250000 KHz - 5330000 KHz @ 80000 KHz), (N/A, 2300 mBm), (0 s)
[ 12.660000] cfg80211: (5735000 KHz - 5835000 KHz @ 80000 KHz), (N/A, 3000 mBm), (N/A)
[ 12.670000] cfg80211: (57240000 KHz - 63720000 KHz @ 2160000 KHz), (N/A, 4000 mBm), (N/A)
[ 12.680000] ieee80211 phy0: Atheros AR9340 Rev:0 mem=0xb8100000, irq=47
[ 19.410000] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready
[ 22.460000] IPv6: ADDRCONF(NETDEV_UP): wlan0-1: link is not ready
[ 22.480000] IPv6: ADDRCONF(NETDEV_UP): wlan0-2: link is not ready
[ 22.880000] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 23.340000] wifidog uses obsolete (PF_INET,SOCK_PACKET)
[ 25.410000] wlan0: authenticate with f0:eb:d0:63:63:63
[ 25.420000] wlan0: send auth to f0:eb:d0:63:63:63 (try 1/3)
[ 25.430000] wlan0: authenticated
[ 25.440000] wlan0: associate with f0:eb:d0:63:63:63 (try 1/3)
[ 25.450000] wlan0: RX AssocResp from f0:eb:d0:63:63:63 (capab=0x411 status=0 aid=3)
[ 25.450000] wlan0: associated
[ 25.460000] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 25.490000] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0-1: link becomes ready
[ 25.500000] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0-2: link becomes ready
procd: - init complete -
|
|
/1 
IP卡
狗仔卡
发表于 2014-10-26 11:31
置顶卡
沉默卡
喧嚣卡
顶贴卡
显身卡