K3 spi 针脚 等位点求助

longalong

xxyt886

我知道YK-L2的，这个没量过

hackpascal

http://www.biosrepair.com/bios/TSSOP16.htm

书桩

1-7，2-8，3-9，4-10，5-15，6-16，7-1，8-2

weilong1523

第一脚能找到，后面的还用问???

longalong

谢谢大家，，已飞线OK。但是141en端接gnd后，在windows网络管理处提示以太网网络电缆被拔出，这时候用ttl查看，一直是下图的循环，，求指点

longalong

hackpascal 发表于 2019-1-20 11:56
http://www.biosrepair.com/bios/TSSOP16.htm

多谢，以飞线，但是又有遇新坑

longalong

CFE version 7.14.131.47 (r629548) based on BBP 1.0.37 for BCM947XX (32bit,SP,)
Build Date: Fri Mar 10 11:38:37 CST 2017 (jenkins@SOHO-OPWRT)
Copyright (C) 2000-2008 Broadcom Corporation.

Init Arena
Init Devs.
Boot partition size = 262144(0x40000)
Found a Samsung NAND flash:
Total size:  128MB
Block size:  128KB
Page Size:   2048B
OOB Size:    64B
Sector size: 512B
Spare size:  16B
ECC level:   4 (4-bit)
Device ID: 0xec 0xf1 0x00 0x95 0x42 0xc6
DDR Clock: 400 MHz
Info: DDR frequency set from clkfreq=1400,*800*
Warning: invalid DDR setting of 800 MHz ignored. DDR frequency will be set to 400 MHz.
Warning: invalid CPU setting of 1400 MHz ignored. armclock frequency will be set to 1000 MHz.
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 7.14.131.47 (r629548)
CPU type 0x0: 1000MHz
Tot mem: 524288 KBytes

CFE mem:    0x00F00000 - 0x017CB47C (9221244)
Data:       0x00F638DC - 0x00F63E64 (1416)
BSS:        0x00F63E70 - 0x00FC947C (415244)
Heap:       0x00FC947C - 0x017C947C (8388608)
Stack:      0x017C947C - 0x017CB47C (8192)
Text:       0x00F00000 - 0x00F57A40 (358976)

Committing NVRAM...done
!! Could not open boot device
Get default MAC address fail!
donDigital core power voltage set to 1.05V
Decompressing...done

longalong

已救活，感谢各位