H618B刷DD后变砖

lvhu***

我的H618B之前一直用的TTDW，今天想刷个DD玩玩，于是直接用tftp刷了dd-wrt.v24-17990_NEWD-2_big.bin，刷完重启正常，就在DD下清了一下NVRAM，清完重启后一切正常，设置了用户名和密码，因为之前也用H618B刷过这个版本的DD，也把设置备份了，所以就直接导入之前的设置，谁知导入完路由重启后就出问题了，出现两三行TTL=100后就timeout了，过了阵子又出现几行TTL=100，这样反复循环，后来又用tftp刷了几次miniDD，还是一样，按照网上的复位方法也试了，还是不行，没办法了，下面是TTL信息，麻烦大大们帮忙分析一下，要怎样才能救活
CFE version 1.0.37 for BCM947XX (32bit,SP,LE)
Build Date: Fri Mar 13 10:05:18 CST 2009 (root@localhost.localdomain)
Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.

Initializing Ar ena
Initializing Devices.
et0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 4.150.19.0
CPU type 0x29029: 240MHz
Total memory: 65536 KBytes

Total memory used by CFE:  0x80700000 - 0x80798210 (623120)
Initialized Data:          0x8072F230 - 0x80731990 (10080)
BSS Area:                  0x80731990 - 0x80732210 (2176)
Local Heap:                0x80732210 - 0x80796210 (409600)
Stack Area:                0x80796210 - 0x80798210 (8192)
Text (code) segment:       0x80700000 - 0x8072F230 (193072)
Boot area (physical):      0x00799000 - 0x007D9000
Relocation Factor:         I:00000000 - D:00000000



******backup nvram haven't valid data or the master nvram data is change ******

Device eth0:  hwaddr 00-90-4C-C0-04-51, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
Max TRX Image Supported: 0xFA0000
Loader:raw Filesys:tftp Dev:eth0 File:: Optionsnull)
Loading: Failed.
Could not load :: Timeout occured
Loader:raw Filesys:raw Dev:flash0.os File: Optionsnull)
Loading: .. 3856 bytes read
Entry at 0x80001000
Closing network.
Starting program at 0x80001000
CPU ProcId is: 0x00029029, options: 0x0000004d
Linux version 2.4.37 (eko@dd-wrt) (gcc version 3.4.6 (OpenWrt-2.0)) #4256 Wed Nov 25 18:41:16 CET 2009
Setting the PFC to its default value
Determined physical RAM map:
memory: 04000000 @ 00000000 (usable)
On node 0 totalpages: 16384
zone(0): 16384 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 noinitrd console=ttyS0,115200
CPU: BCM5354 rev 3 at 240 MHz
Using 120.000 MHz high precision timer.
Calibrating delay loop... 239.20 BogoMIPS
Dentry cache hash table entries: 8192 (order: 4, 65536 bytes)
Inode cache hash table entries: 4096 (order: 3, 32768 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 4096 (order: 2, 16384 bytes)
Page-cache hash table entries: 16384 (order: 4, 65536 bytes)
Checking for 'wait' instruction...  unavailable.
POSIX conformance testing by UNIFIX
PCI: no core
PCI: Fixing up bus 0
Initializing RT netlink socket
Starting kswapd
devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
squashfs: version 3.0 (2006/03/15) Phillip Lougher
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0xb8000300 (irq = 3) is a 16550A
ttyS01 at 0xb8000400 (irq = 3) is a 16550A
PCI: Setting latency timer of device 00:01.0 to 64
PCI: Setting latency timer of device 00:05.0 to 64
sb_doattach: incoming bus is PCI but it's a lie, switching to SB devid:0x4318
PCI: Setting latency timer of device 00:06.0 to 64
sb_doattach: incoming bus is PCI but it's a lie, switching to SB devid:0x4719
PPPoL2TP kernel driver, V0.13
Universal TUN/TAP device driver 1.5 (C)1999-2002 Maxim Krasnyansky
Physically mapped flash: Found an alias at 0x1000000 for the chip at 0x0
Amd/Fujitsu Extended Query Table v1.3 at 0x0040
number of CFI chips: 1
cfi_cmdset_0002: Disabling fast programming due to code brokenness.
Flash device: 0x1000000 at 0x1c000000
bootloader size: 131072
Physically mapped flash: Filesystem type: squashfs, size=0x245e37
partition size = 2469888
Creating 5 MTD partitions on "hysically mapped flash":
0x00000000-0x00020000 : "cfe"
0x00020000-0x00fe0000 : "linux"
0x00125000-0x00380000 : "rootfs"
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
0x00fe0000-0x01000000 : "nvram"
0x00380000-0x00fe0000 : "ddwrt"
sflash not supported on this router
Initializing Cryptographic API
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 4096 bind 8192)
ip_conntrack version 2.1 (512 buckets, 4096 max) - 336 bytes per conntrack
ip_tables: (C) 2000-2002 Netfilter core team
ipt_random match loaded
netfilter PSD loaded - (c) astaro AG
ipt_osf: Startng OS fingerprint matching module.
ipt_IPV4OPTSSTRIP loaded
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Mounted devfs on /dev
start service
starting Architecture code for broadcom
Booting device: Linksys WRT54G/GL/GS
loading sysinit
boardflags are 0x0750
sh: can't create /proc/switch/eth1/reset: nonexistent directory
sh: can't create /proc/sys/net/ipv4/tcp_congestion_control: nonexistent directory
Unlocking ddwrt ...

到这停了大概30秒后就出现

Decompressing..........done

然后马上又重启了，这样反复循环

lvhu***

沉得真快啊，自己先顶起来

chka***

没听说过H618B能用NEWD-2

lvhu***

chkai1981 发表于 2012-7-25 20:28
没听说过H618B能用NEWD-2

我之前确实刷过这个版本，而且很正常的用了两天

lvhu***

zxc***

H618B刷DD 按WPS和WLAN 开机 30秒 再关机 ，再 开机。