941v5刷【U-Boot】不死 软重启灯全亮 必须拔电源

sod***

Port 0, Neg Success
Port 1, Neg Success
Port 2, Neg Success
Port 3, Neg Success
device ath0 entered promiscuous mode
br0: port 2(ath0) entering learning state
br0: topology change detected, propagating
br0: port 2(ath0) entering forwarding state
br0: port 2(ath0) entering disabled state
Country ie is CN
br0: port 2(ath0) entering learning state
br0: topology change detected, propagating
br0: port 2(ath0) entering forwarding state
++++ phy_up is 1, fdx is 1, speed is 1
AG7240: enet unit:1 phy:3 is up...Mii 100Mbps full duplex
AG7240: enet unit 1 phy 3 mode 0x4c04
br0: port 1(eth0) entering learning state
br0: topology change detected, propagating
br0: port 1(eth0) entering forwarding state
br0: port 2(ath0) entering disabled state

TP_Flags:0****

TP_Flags:0****
Country ie is CN
br0: port 2(ath0) entering learning state
br0: topology change detected, propagating
br0: port 2(ath0) entering forwarding state
+++ GE0 RX DMA ENABLE
umount: /var: Device or resource busy
umount: /tmp: Device or resource busy
The systCountry ie is CN
br0: port 2(ath0) entering disabled state
Sending SIGKILL to all processes.
Please stand by while rebooting the system.
Restarting system.
.
ttl信息到这里就死机了 必须拔掉电源 这要命令软重启怎么搞 有解决方法吗？

rws***

我有一台 941v4 刷的【U-Boot】不死，后刷的UBNT也出现如此问题

sod***

rwshui 发表于 2015-3-2 12:16
我有一台 941v4 刷的【U-Boot】不死，后刷的UBNT也出现如此问题

看样子还是uboot的问题 我去大神那里问问