小弟 941N 刷OP 变砖求大大们 帮忙啊

bini***

941n V2.2 连接ttl 正常信息如下 指示灯都亮 但是ping不同 网络连接异常 我该如何啊 请大大们帮帮小弟啊...搞了很久都没点希望 发现uboot 无法用tp停止 是不是我的uboot已经损坏？有大大有uboot分享下？

U-Boot 1.1.4 (Jun 18 2009 - 15:08:27)

AP81 (ar7100) U-boot
DRAM:  
sri
32 MB
id read 0x100000ff
flash size 8MB, sector count = 128
Flash:  8 MB
Using default environment

In:    serial
Out:   serial
Err:   serial
Net:   ag7100_enet_initialize...
Fetching MAC Address from 0x81fef270
eth0: 00:03:7f:e0:04:68
eth0 up
eth0
Autobooting in 1 seconds## Booting image at bf020000 ...
   Uncompressing Kernel Image ... OK

Starting kernel ...

Linux version 2.6.28.10 (fiona@ubuntu) (gcc version 4.1.2) #2 Wed Jun 24 23:04:35 CST 2009
console [early0] enabled
CPU revision is: 00019374 (MIPS 24Kc)
Atheros AR9132 rev 1 (id:0xb5), CPU:400.000 MHz, AHB:100.000 MHz, DDR:400.000 MHz
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
  Normal   0x00000000 -> 0x00002000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0: 0x00000000 -> 0x00002000
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd console=ttyS0,115200
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
PID hash table entries: 128 (order: 7, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 29592k/32768k available (1915k kernel code, 3176k reserved, 343k data, 136k init, 0k highmem)
SLUB: Genslabs=6, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200)
Mount-cache hash table entries: 512
net_namespace: 708 bytes
NET: Registered protocol family 16
MIPS: machine is TP-LINK TL-WR941ND
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 3.0 (2006/03/15) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY)  © 2001-2006 Red Hat, Inc.
yaffs Jun 24 2009 22:42:26 Installing.
msgmni has been set to 57
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver1 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
console handover: boot [early0] -> real [ttyS0]
ag71xx_mdio: probed
eth0: Atheros AG71xx at 0xb9000000, irq 4
Atheros AR71xx SPI Controller driver version 0.2.2
m25p80 spi0.0: m25p32 (4096 Kbytes)
Searching for RedBoot partition table in spi0.0 at offset 0x3e0000
Searching for RedBoot partition table in spi0.0 at offset 0x3f0000
No RedBoot partition table detected in spi0.0
Creating 5 MTD partitions on "spi0.0":
0x00000000-0x00020000 : "u-boot"
0x00020000-0x00140000 : "kernel"
0x00140000-0x003f0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=2D0000, len=120000
0x002d0000-0x003f0000 : "rootfs_data"
0x003f0000-0x00400000 : "art"
0x00020000-0x003f0000 : "firmware"
Atheros AR71xx hardware watchdog driver version 0.1.0
TCP westwood registered
NET: Registered protocol family 17
Bridge firewalling registered
Distributed Switch Architecture driver version 0.1
eth0: detected a Marvell 88E6060 switch
dsa slave smi: probed
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 136k freed
Please be patient, while OpenWrt loads ...
Algorithmics/MIPS FPU Emulator v1.5
- preinit -
Press CTRL-C for failsafe
switching to jffs2
mini_fo: using base directory: /
mini_fo: using storage directory: /jffs
- init -

Please press Enter to activate this console. eth0: link up (100Mbps/Full duplex)
cfg80211: Using static regulatory domain info
cfg80211: Regulatory domain: US
        (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
        (2402000 KHz - 2472000 KHz @ 40000 KHz), (600 mBi, 2700 mBm)
        (5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
        (5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
        (5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
        (5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
        (5735000 KHz - 5835000 KHz @ 40000 KHz), (600 mBi, 3000 mBm)
cfg80211: Calling CRDA for country: US
phy0: Atheros AR9100 MAC/BB Rev:0, AR2133 RF Rev:a1, mem=0xb80c0000, irq=2
cfg80211: Calling CRDA for country: US
PPP generic driver version 2.4.2
ip_tables: (C) 2000-2006 Netfilter Core Team
nf_conntrack version 0.5.0 (512 buckets, 2048 max)
CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Please use
nf_conntrack.acct=1 kernel paramater, acct=1 nf_conntrack module option or
sysctl net.netfilter.nf_conntrack_acct=1 to enable it.
gpio-buttons driver version 0.1.1
input: gpio-buttons as /devices/platform/gpio-buttons/input/input0

bini***

有人知道？大大们 在线等啊

7296***

用tpl停

bini***

用tpl停
729650915 发表于 2011-8-5 17:15

看帖子说是2009的 无法中断 同时按tpl?刚试了 还是不行 主要我的路由还ping不同 郁闷了

7296***

在auto booting in 1 seconds时点 依次按tpl 要快

bini***

在auto booting in 1 seconds时点 依次按tpl 要快
729650915 发表于 2011-8-5 23:10

这样啊 我再试试 这1S 还真难控制 但是我无法ping通我的路由 网络连接也正常 这个如何上传固件啊

x***

应该只是丢了dhcp

yas***

你按TPL停下来后就可以PING通路由了

bini***

希望如此吧 先试试再说吧

bini***

TPL 果真是进入boot了 但是进入之后TFTP还是无法建立 路由ping不通 这是什么情况啊 大大们

ar7100> printenv
bootargs=console=ttyS0,115200 root=31:02 rootfstype=jffs2 init=/sbin/init mtdparts=ar7100-nor0:256k(u-boot),64k(u-boot-env),5120k(rootfs),1024k(uImage)
bootcmd=bootm 0xbf020000
bootdelay=1
baudrate=115200
ethaddr=0x00:0xaa:0xbb:0xcc:0xdd:0xee
stdin=serial
stdout=serial
stderr=serial
ethact=eth0
ipaddr=192.168.1.2
serverip=192.168.1.10

set link to 100M full by lqm.
Using eth0 device
TFTP from server 192.168.1.10; our IP address is 192.168.1.2
Filename '192.168.1.10'.
Load address: 0x0
Loading: T
TFTP error: 'File not found' (1)
Starting again

bini***

config switch eth1
       option vlan0    '0 1 2 5*'
       option vlan1    '3 5*'
config interface loopback
        option ifname   lo
        option proto    static
        option ipaddr   127.0.0.1
        option netmask  255.0.0.0

        option ifname "eth0.1"
        option proto pppoe
        option username "00015"
        option password "a"

        option ifname "eth0.1"
        option proto   dhcp
        option hostname MyRoute
        option ifname "eth0.1"
        option proto static
        option ipaddr 192.168.1.2
        option netmask 255.255.255.0
        option gateway 192.168.1.1
        option dns 192.168.1.1

bini***

为什么我还是无法ping通路由 配置哪里有问题 还请大大们指点啊

bini***

有大大帮看看？小弟在线等啊...请大大们看看啊

bini***

有人知道怎么解决？大大们 帮帮啊