wrt150n v1.1 ttl 信息求助

zhangr***

TTl看到如下信息，好像能进linux系统，还可以使用一些linux命令，如ls等，路由器启动后看不见无线网，插有线网可以看见对应的端口灯亮，但是不能获取到ip，手动设置固定的ip也ping不通，希望坛子里的大侠们能帮助解决，谢谢！！！！

Start to blink diag led ...


CFE version 1.0.37 for BCM947XX (32bit,SP,LE)
Build Date: Sat Jun 23 20:55:25 CST 2007 (root@localhost.localdomain)
Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.

Initializing Arena
Initializing Devices.

No DPN
This is a Parallel Flash
Boot partition size = 262144(0x40000)
Partition information:
boot    #00   00000000 -> 0003FFFF  (262144)
trx     #01   00040000 -> 0004001B  (28)
os      #02   0004001C -> 003F7FFF  (3899364)
nvram   #03   003F8000 -> 003FFFFF  (32768)
Partition information:
boot    #00   00000000 -> 0003FFFF  (262144)
trx     #01   00040000 -> 003F7FFF  (3899392)
nvram   #02   003F8000 -> 003FFFFF  (32768)
et0: chipattach: NVRAM_GET(et0phyaddr) not found
et0: chipattach error
et0: etc_attach failed
et1: chipattach: NVRAM_GET(et1phyaddr) not found
et1: chipattach error
et1: etc_attach failed
CPU type 0x29006: 200MHz
Total memory: 16384 KBytes

Total memory used by CFE:  0x80700000 - 0x80796350 (615248)
Initialized Data:          0x8072D1A0 - 0x8072F900 (10080)
BSS Area:                  0x8072F900 - 0x80730350 (2640)
Local Heap:                0x80730350 - 0x80794350 (409600)
Stack Area:                0x80794350 - 0x80796350 (8192)
Text (code) segment:       0x80700000 - 0x8072D1A0 (184736)
Boot area (physical):      0x00797000 - 0x007D7000
Relocation Factor:         I:00000000 - D:00000000

Boot version: v4.5
The boot is CFE
mac_init(): Find mac [00:1d:7e:44:01:76] in location 0
Nothing...
CMD: [go;]
Check CRC of image1
  Len:     0x2AF000     (2813952)       (0xBC040000)
  Offset0: 0x1C         (28)            (0xBC04001C)
  Offset1: 0x8A4        (2212)  (0xBC0408A4)
  Offset2: 0x82E0C      (536076)        (0xBC0C2E0C)
  Header CRC:    0xC990B84F
  Calculate CRC: 0xC990B84F
Image 1 is OK
Try to load image 1.
CMD: [boot -raw -z -addr=0x80001000 -max=0x770000 flash0.os:]
Loader:raw Filesys:raw Dev:flash0.os File: Optionsnull)
Loading: .. 3560 bytes read
Entry at 0x80001000
Starting program at 0x80001000
CPU revision is: 00029006
Primary instruction cache 16kb, linesize 16 bytes (2 ways)
Primary data cache 16kb, linesize 16 bytes (2 ways)
Linux version 2.4.20 (root@localhost.localdomain) (gcc version 3.2.3 with Broadc
om modifications) #14 Sat Jun 23 20:55:05 CST 2007
Setting the PFC to its default value
Determined physical RAM map:
memory: 01000000 @ 00000000 (usable)
On node 0 totalpages: 4096
zone(0): 4096 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200
CPU: BCM4704 rev 9 at 200 MHz
Calibrating delay loop... 199.47 BogoMIPS
Memory: 14328k/16384k available (1452k kernel code, 2056k reserved, 108k data, 7
2k init, 0k highmem)
Dentry cache hash table entries: 2048 (order: 2, 16384 bytes)
Inode cache hash table entries: 1024 (order: 1, 8192 bytes)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 4096 (order: 2, 16384 bytes)
Checking for 'wait' instruction...  unavailable.
POSIX conformance testing by UNIFIX
PCI: Initializing host
PCI: Fixing up bus 0
PCI: Fixing up bridge
PCI: Fixing up bus 1
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
squashfs: version 3.0 (2006/03/15) Phillip Lougher
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI en
abled
ttyS00 at 0xb8000300 (irq = 3) is a 16550A
ttyS01 at 0xb8000400 (irq = 0) is a 16550A
HDLC line discipline: version $Revision: 1.1.1.4 $, maxframe=4096
N_HDLC line discipline registered.
Register DIAG LED in /proc/sys/diag_blink.
The DIAG LED GPIO is 1.
PPP generic driver version 2.4.2
Amd/Fujitsu Extended Query Table v3.3 at 0x0040
cfi_cmdset_0002(): cfi->mfr=ec, cfi->id=a2 topbottom=2
cfi_cmdset_0002(): bootloc=2
cfi_cmdset_0002(): Region=0 BlockSize 0x2000 bytes, 8 blocks
cfi_cmdset_0002(): Region=1 BlockSize 0x10000 bytes, 63 blocks
number of CFI chips: 1
Flash device: 0x400000 at 0x1c000000
Physically mapped flash: squashfs filesystem found at block 779
(Not Found Lang Block)off=0xc2e0c off1=0x3a0000 size=0x400000
Creating 5 MTD partitions on "hysically mapped flash":
0x00000000-0x00040000 : "pmon"
0x00040000-0x003a0000 : "linux"
0x000c2e0c-0x003a0000 : "rootfs"
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-o
nly
0x003a0000-0x003f0000 : "lang"
0x003f0000-0x00400000 : "nvram"
sflash: found no supported devices
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 1024 bind 2048)
Linux IP multicast router 0.06 plus PIM-SM
ip_conntrack version 2.1 (128 buckets, 1024 max) - 368 bytes per conntrack
Register conntrack protocol helper for ESP...
IPSEC ESP conntrack protocol max_pass-through[50]...
init IP_nat_proto_esp register.
ip_conntrack_pptp version 1.9 loaded
IPSEC isakmp Support Max Pass-through [50].
ip_conntrack_rtsp v0.01 loading
ip_conntrack_l2tp: registering helper for port [1701].
L2TP Support Max Pass-through [50].
ip_nat_pptp version 1.5 loaded
Register NAT helper for port [1701] name [l2tp].
ip_nat_rtsp v0.01 loading
ip_tables: (C) 2000-2002 Netfilter core team
ipt_time loading
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Ethernet Bridge 008 for NET4.0
802.1Q VLAN Support v1.7 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 72k freed
find "lang" in MTD 3 (/dev/mtdblSQUASHFS error: Can't find a SQUASHFS superblock
on mtdblock(31,3)
ock/3)
ret = -1
www -> /www
mount: Inappropriate ioctl for device
Language Package: EN
modules[0]=et buf=[et ]
modules[1]=ctmisc buf=[et ctmisc ]
modules[2]=wl buf=[et ctmisc wl ]
Needed modules: et ctmisc wl
cmd=[insmod et ]
Using /lib/modules/2.4.20/kernel/drivers/net/et/et.o
insmod: init_module: et: No such device
cmd=[insmod ctmisc ]
Using /lib/modules/2.4.20/kernel/drivers/net/ctmisc/ctmisc.o
cmd=[insmod wl ]
Using /lib/modules/2.4.20/kernel/drivers/net/wl/wl.o
insmod: init_module: wl: No such device
Hit enter to continue...The chipset is BCM4704 + BCM5325F for EWC
cmd=[misc -t get_mac -w 3 ]
type = [get_mac]
get_data(): cmd=0x11 count=8 len=18
get_data(): Get MAC count is [1]
get_data(): MAC 0: [00:1d:7e:44:01:76]
get_data(): done
cmd=[misc -t get_sn -w 3 ]
type = [get_sn]
get_data(): cmd=0x15 count=8 len=20
get_data(): Get SN count is [1]
get_data(): SN 0: [CQ611GA51932

wiza***

可以帮你修，QQ：68364143