大亚DB120-WG双USB闪存S29版刷OPENWRT带CFE版

andrew***

刷了之后只剩下电源红灯和双USB绿灯常亮了，不知是否变砖，CFE信息如下，请各位高手看下：
Boot Address 0xbe000000

Initializing Arena.
Initializing Devices.
Parallel flash device: name AM29LV320MT|S29GL128-A, id 0x2201, size 16384KB
Flash Layout: Boot[0,0xbe000000] Kern[1,0xbe020000]
              AuxFS[93,0xbeba0000] Misc[125,0xbefa0000] PSI[127,0xbefe0000]
Flash RootFS Partition Length: 12058624
error on Ethernet Switch setup
Failed initializing enet hardware
CPU type 0x2A010: 300MHz, Bus: 133MHz, Ref: 64MHz
CPU running TP0
Total memory: 33554432 bytes (32MB)

Total memory used by CFE:  0x80401000 - 0x80529860 (1214560)
Initialized Data:          0x8041E740 - 0x80421060 (10528)


** Flash image not found. **

Board IP address                  : 192.168.1.1:ffffff00  
Host IP address                   : 192.168.1.100  
Gateway IP address                :   
Run from flash/host (f/h)         : f  
Default host run file name        : vmlinux  
Default host flash file name      : bcm963xx_fs_kernel  
Boot delay (0-9 seconds)          : 1  
Board Id (0-8)                    : 96358VW2  
Number of MAC Addresses (1-32)    : 12  
Base MAC Address                  : 00:1e:40:53:df:ec  
PSI Size (1-64) KBytes            : 24  
Flash Block Size (1-128) in KBytes: 128  
Auxillary File System Size Percent: 25  
Main Thread Number [0|1]          : 0  

Could not activate network interface 'eth0': CFE error -1
udp_socket error
No answer .auto boot ...
CFE> web error -1: Could not create TCP socket.

andrew***

自己顶一下，在线等高手，OPENWRT论坛求不到答案，看恩山论坛是否更有爱！

andrew***

再顶一下，Failed initializing enet hardware什么意思，硬件故障？我都没动硬件