|
Decompressing...done
CFE version 5.100.138.3 based on BBP 1.0.37 for BCM947XX (32bit,SP,LE)
Build Date: 2011-05-26 10:33:50 4 (richard@aeteam.com)
Copyright (C) 2000-2008 Broadcom Corporation.
Init Arena
Init Devs.
Boot partition size = 131072(0x20000)
Found an ST compatible serial flash with 32 64KB blocks; total size 2MB
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.100.138.3
CPU type 0x19749: 300MHz
Tot mem: 16384 KBytes
CFE mem: 0x80700000 - 0x80798550 (623952)
Data: 0x8072E3A0 - 0x807315C0 (12832)
BSS: 0x807315C0 - 0x80732550 (3984)
Heap: 0x80732550 - 0x80796550 (409600)
Stack: 0x80796550 - 0x80798550 (8192)
Text: 0x80700000 - 0x8072E39C (189340)
Device eth0: hwaddr C8-3A-35-0E-78-88, ipaddr 192.168.18.18, mask 255.255.255.0
gateway not set, nameserver not set
Loader:raw Filesys:raw Dev:flash0.os File: Optionsnull)
Loading: ..... 2767828 bytes read
Entry at 0x80001000
Closing network.
Starting program at 0x80001000
IP Filter: v3.4.35 initialized. Default = pass all, Logging = disabled
PCI: no core
PCI: no core
PCI: Fixing up bus 0
wl_pci_probe: find [14e4:4329] bus 0 slot 1 func 0 irq 1
eCos Router/AP V5.110.27.21 (Compiled at 11:35:17 on Aug 1 2012)
sys_led_test_gpio=6
Using pin 6 for sys_led output
wps_led_test_gpio=7
System start
vlan1: VLAN interface created
vlan2: VLAN interface created
wlconf: PHYTYPE: 4
COEX: downgraded chanspec 0x2d03 to 0x2b01: channel 2 used by exiting BSSs
EAPD task started
initWebs: lanip=[192.168.18.18]
NAS task started
CLI>
initWebs: lanip=[192.168.18.18]
NAS task started
CLI> |
|