各位大侠帮我看看我的电信版 中兴 ZXV10 H108L V2.0 还有的救没有

tjh***

前段时间刷固件把这货刷坏了，这段时间研究了下，买了ttl线，连了下，显示如下， 然后就不动了，谁能告诉我到底还有没有救啊，没救我就不准备折腾了，开机灯全闪一下，然后只有一个灯亮着


Booting...
Press '1' to enter BOOT console...
Press '2' to enter DEBUG mode......
Using Int. PHY
Hardware or Otherway Reset!

To read reset key,if on,to update
Found image at 0xbd4e0000
Found image at 0xbd630000
Flash owned validImgNum: 2
****Try the first image...
para->BootParaCksum=     9a4
ok!
Linux version 2.6.20.16zte (xia@njzd) (gcc version 3.4.6-1.3.6) #2 Fri Dec 3 20:13:19 CST 2010
Check boot para cksum...
boot para cksum OK!
bootPara.runmode=3
SDRAM MTCR0: 0x54480000
CPU revision is: 0000ff00
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
Built 1 zonelists.  Total pages: 8128
Kernel command line: console=ttyS0,115200 root=31:4
Primary instruction cache 16kB, linesize 16 bytes.
Primary data cache 8kB, linesize 16 bytes.
Synthesized TLB refill handler (17 instructions).
Synthesized TLB load handler fastpath (31 instructions).
Synthesized TLB store handler fastpath (31 instructions).
Synthesized TLB modify handler fastpath (25 instructions).
PID hash table entries: 128 (order: 7, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 26988k/32768k available (3828k kernel code, 5780k reserved, 808k data, 132k init, 0k highmem)
Mount-cache hash table entries: 512
Checking for 'wait' instruction...  disabled.
pdt_cspkernel_init
NET: Registered protocol family 16
11930:22:53 [Klogctl][Info] [(1657)LogCtlInit] LogCtlInit begin
11930:22:53 [Klogctl][Info] [(1396)AddLogtab] AddLogtab: pLogTab=80484030,wLogTabNum=64,dwLogTabIDBase = 0X00000000
11930:22:53 [Klogctl][Info] [(1463)AddLogOutModule] AddLogOutModule:OutputMode=0X00000200,ptLogProcSet=81063c38
11930:22:53 [Klogstdio][Info] [(1080)LogStdioProcInit] LogStdioProcInit

11930:22:53 [Klogctl][Info] [(1463)AddLogOutModule] AddLogOutModule:OutputMode=0X00000100,ptLogProcSet=81063c38
11930:22:53 [Klogfile][Info] [(2924)LogFileProcInit] LogFileProcInit

11930:22:53 [Klogfile][Info] [(2936)LogFileProcInit] g_dwUptime is 946684800

11930:22:53 [Klogctl][Info] [(1396)AddLogtab] AddLogtab: pLogTab=80485620,wLogTabNum=2,dwLogTabIDBase = 0X00080000
11930:22:53 [Klogctl][Info] [(1512)SetLogOutputMode] SetLogOutputMode:bType=1,OutputMode=0X00000700
11930:22:53 [Klogctl][Info] [(1590)SetLogConf] SetLogConf OutputMode=0X00000100,pBuf=81063bb8,iLen=88
11930:22:53 [Klogfile][Info] [(2743)ProcLogConf] Set LOG_FILE_CONF_SET_PDTCONF

11930:22:53 [Klogfile][Info] [(2831)ProcLogConf] Set LogFileFormatTimestamp
11930:22:53 [Klogctl][Info] [(1723)LogCtlInit] LogCtlInit end
11930:22:53 [KLogCtl][Notice] [oss_logctl.c(321)ProcLog] System start!
11930:22:53 [Klogfile][Info] [(475)InitLogSaveBuff] InitLogSaveBuff
11930:22:53 [KMONITOR][Notice] [monitor.c(199)MonitorInit]  cspmonitor init... !  
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
11930:22:53 [MIRROR][Notice] [cspmirror.c(674)MirrorInit]  CspMirror start init ...
11930:22:53 [KQOS][Info] [qos.c(167)CSPKernel_QC_In] Qos module init
NET: Registered protocol family 8
NET: Registered protocol family 20
NET: Registered protocol family 2
ip_rt_init() start call CSP_alloc_large_system_hash
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
ip_rt_init() call CSP_alloc_large_system_hash end
TCP established hash table entries: 1024 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 1024 bind 512)
TCP reno registered
squashfs: version 3.2 (2007/01/02) Phillip Lougher
JFFS2 version 2.2. (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
Serial: 8250/16550 driver $Revision: 1.90 $ 1 ports, IRQ sharing disabled
netlog start
serial8250: ttyS0 at MMIO 0x0 (irq = 12) is a 16550A
flash device: 0x1000000 at 0xbd000000
get SPI chip driver!
Physically mapped flash: Found an alies 0x1000000 for the chip at 0x0, spansion 16M device detect.
Creating 8 MTD partitions on "Physically mapped flash":
0x00000000-0x01000000 : "whole_flash"
0x00000000-0x00020000 : "bootloader"
0x00020000-0x00060000 : "userconfig"
0x004e0000-0x00630000 : "kernel"
0x00060000-0x004e0000 : "filesystem"
0x00630000-0x00780000 : "kernel2"
0x00780000-0x00c00000 : "filesystem2"
0x00c00000-0x01000000 : "ct-jffs2"
block2mtd: version $Revision: 1.30 $
RTL8192SU(for RTL867x platform) driver version 0.4.8 (2009-11-30 - 2009-12-21)
usbcore: registered new interface driver RTL8192SU(for RTL867x platform)
Enable 8671G 1 function
Enable 8671 0 function
Enable 8672 function
ratm: Realtek SAR v1.02 (Feb 17, 2009)
u32 classifier
    OLD policer on
nf_conntrack version 0.5.0 (256 buckets, 2048 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
netfilter PSD loaded - (c) astaro AG
NET: Registered protocol family 1
NET: Registered protocol family 10
6WIND/LSIIT IPv6 multicast forwarding 0.1 plus PIM-SM/SSM with *BSD API
ip6_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 17
af_packet.c packet_init call register_netdevice_notifier
Bridge firewalling registered
br_init call register_netdevice_notifier
Ebtables v2.0 registered
NET: Registered protocol family 24
PPP Deflate Compression module registered
11930:22:55 [LEDKEYDRV][Info] [ledkey_mod.c(1638)LedkeymodInit] Ledkey_mod Driver Version 0.0.1.
11930:22:55 [LEDKEYDRV][Info] [ledkey_mod.c(1689)LedkeymodInit] watchdog enable!
watchdog started
11930:22:55 [TAGPARAM][Info] [tagparam_mod.c(1383)TagaramodInit] Tagaram module Driver Version 0.0.1.
11930:22:55 [TAGPARAM][Info] [tagparam_mod.c(1423)TagaramodInit] parse tag param success
11930:22:55 [km255][Info] [ver_info.c(349)ver_info_init] ver_info_init
________________CspGetVerInfo____________________
bootPara.bootWhichImg=1
bootPara.img_info_tbl[0].flashOffset=0x  4e0000
g_MaxNumOfFirmWare =2
sHardVersion=V1.0.02
11930:22:55 [km255][Info] [ver_info.c(138)ReadInfoFromVer] ver_info_init
11930:22:55 [km255][Info] [ver_info.c(145)ReadInfoFromVer] ver_info_init
11930:22:55 [km255][Info] [ver_info.c(161)ReadInfoFromVer] wFirmwareForm is:0x1
11930:22:55 [KSWETH][Notice] [csp_ifinfo.c(191)csp_ifinfo_init] Initializing CSP IFinfo...
11930:22:55 [KSWETH][Warn] [csp_ifinfo.c(213)csp_ifinfo_init] No IFinfo in flash!
11930:22:55 [KSWETH][Notice] [sweth_core.c(2667)sweth_init] SW&ETH HAL driver initing!
11930:22:55 [KSWETH][Notice] [sweth_core.c(129)CreateSwEthObjs] Create SW & ETH objects
11930:22:55 [KSWETH][Info] [sweth_core.c(152)CreateSwEthObjs] nEmac = 1, nSw = 1, nEth=4.
11930:22:55 [KSWETH][Info] [sweth_core.c(221)CreateSwEthObjs] SW obj0: TypeId = 1, CpuEmac = 0, PortToCpu=4
11930:22:55 [KSWETH][Info] [sweth_core.c(311)CreateSwEthObjs] ETH obj0: PhyType = 4, Is_assoc_sw = 1, Emac = 0, Phy = 0
11930:22:55 [KSWETH][Info] [sweth_core.c(311)CreateSwEthObjs] ETH obj1: PhyType = 4, Is_assoc_sw = 1, Emac = 0, Phy = 1
11930:22:55 [KSWETH][Info] [sweth_core.c(311)CreateSwEthObjs] ETH obj2: PhyType = 4, Is_assoc_sw = 1, Emac = 0, Phy = 2
11930:22:55 [KSWETH][Info] [sweth_core.c(311)CreateSwEthObjs] ETH obj3: PhyType = 4, Is_assoc_sw = 1, Emac = 0, Phy = 3
REALTEK NIC Ethernet driver v0.1 (Feb 13, 2009)
eth0: RTL-8139C+ at 0xb8018000, d0:15:4a:6f:6e:c8, IRQ 0
eth1: RTL-8139C+ at 0xb8018000, d0:15:4a:6f:6e:c8, IRQ 0
eth2: RTL-8139C+ at 0xb8018000, d0:15:4a:6f:6e:c8, IRQ 0
eth3: RTL-8139C+ at 0xb8018000, d0:15:4a:6f:6e:c8, IRQ 0
11930:22:55 [KSWETH][Notice] [reltk_mac_adapt(242)Register_reltk_] Register reltk EMAC driver
11930:22:55 [KSWETH][Notice] [sweth_core.c(577)RegisterEmacDrv] Register EMAC driver
11930:22:55 [KSWETH][Notice] [sweth_core.c(418)InitSwEthObjs] Initialise SW & ETH objects
11930:22:55 [KSWETH][Notice] [sweth_core.c(461)InitSwEthObjs] SW obj connected with ETH0 is not initialised yet!
11930:22:55 [KSWETH][Notice] [sweth_core.c(461)InitSwEthObjs] SW obj connected with ETH1 is not initialised yet!
11930:22:55 [KSWETH][Notice] [sweth_core.c(461)InitSwEthObjs] SW obj connected with ETH2 is not initialised yet!
11930:22:55 [KSWETH][Notice] [sweth_core.c(461)InitSwEthObjs] SW obj connected with ETH3 is not initialised yet!
No filesystem could mount root, tried:  squashfs vfat
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,4)

tjh***

没人看到吗，求救