|
本帖最后由 andy_wsj 于 2015-4-20 15:11 编辑
EA4500的固件昨天有了一个更新,作者 Randy C.Will发布了他的带LuCI的固件,有两个版本,一个测试过,一个未测试
去年早些时候他就发布了EA4500的op固件,那时候还没有LuCI界面,全是命令行的,经过一段时间的开发,他把界面整合上来了
这下EA4500要涨价了...
我的EA4500貌似可以开始折腾了....
心动的快入手吧,晚了X宝就没这个价了
以下是原文:
OpenWRT
The OpenWRT folks have been working on Candyhouse support, but the process to get the image flashed is not exactly friendly. I've been hacking around a bit and I believe I've worked around most of the issues. Unfortunately, the OpenWRT team believes that adding a subtarget for Candyhouse routers under the Kirkwood target adds too much maintenance overhead and the "feature" of being able to flash the firmware onto the device without soldering on a serial header and reconfiguring the bootloader so none of the stock failsafe mechanisms work isn't worth it. Anyway, here are the images as of April 16, 2015:
• openwrt-kirkwood-ea4500-pri.ssa
md5sum: 1fefb4cd40f9d10268be88388f219ace
sha1sum: 5f78732f79223c71f944548e03ee00936d3a0d0a
• openwrt-kirkwood-ea4500-alt.ssa
md5sum: 1a25e03cbaab80a8c682a1a2b7d450e1
sha1sum: 93d3af5910d60421030c1e541195cf4b4fc4403e
There are two options because I had to hard code the rootfs partition into the kernel config and there's no way to know unless you have CLI access whether your current firmware is on the main or alternate partition pair. Try one of the SSAs and if it doesn't work, power cycle the router three times to get back to the Cisco firmware then try the other one.
I've tested pri as the stock firmware is on the alt partition set on my test router. I have not tested alt, but other than the block device in the kernel boot command line, the images are identical.
These SSAs include base OpenWRT as well as LuCI. You will need to connect via a LAN port as wireless is disabled by default. You can set the root password by connecting to 192.168.1.1 or on the command line. If you prefer CLI, telnet 192.168.1.1. You'll immediately get a root shell. Set your password and telnet will automatically be disabled and SSH enabled.
I've included wpad-mini in the build as well so all you have to do to get wireless working is go to the wireless menu and click Enable.
Check out Candyhouse-Linux on GitHub to download the build system and make your own SSAs.
原文地址和固件下载,作者还在不断更新中:
http://www.wolfteck.com/projects/candyhouse/openwrt/
|
|