|
|
这个是内存改了2块64M SDRAM组合成128M的 TTL信息
U-Boot 1.1.3 (Jan 13 2015 - 23:32:23)
SoC:Ralink RT3052
DRAM: Found SDRAM.
TEST-32Bit-0 128M:
CFG0:0xD1825272
CFG1:0xA1220600
CFG2:0x00000000
CFG3:0x00000000
CFG4:0x00000000
TEST-32Bit-1 64M:
CFG0:0xD1825272
CFG1:0xA1120300
CFG2:0x00000000
CFG3:0x00000000
CFG4:0x00000000
Done,SDR is 64 MB
relocate_code Pointer at: 83fa4000
config usb..
Flash JEDEC Info:
Manufacturer ID:0x00000001
Device ID:0x0000227E
Mode ID:0x00002221
Part ID:0x00002201
FLASH:S29GL128P/N, SIZE:16 MBytes SECTOR:128
S29GLXXX:set sect_size =0x20000
flash_protect ON: from 0xBF000000 to 0xBF024A27
flash_protect ON: from 0xBF040000 to 0xBF040FFF
*** Warning - bad CRC, using default environment
_______________________________________________________________
| ____ _ ____ |
| | _ \ __ _ _ __ __| | ___ _ __ __ _| __ ) _____ __ |
| | |_) / _` | '_ \ / _` |/ _ \| '__/ _` | _ \ / _ \ \/ / |
| | __/ (_| | | | | (_| | (_) | | | (_| | |_) | (_) > < |
| |_| \__,_|_| |_|\__,_|\___/|_| \__,_|____/ \___/_/\_\ |
| |
| PandoraBox Ralink/MTK Platform |
| Copyright 2014 D-Team Technology Co.,Ltd. SZ |
| Board:HuaWei HG255D |
| |
| lintel<lintel.huang@gmail.com> |
|______________________________________________________________|
===============Board Info==================
CPU Frequency:384MHz
Detected Memory:64MiB
Bootloader Version:4.3.0.0
icache: sets:256, ways:4, linesz:32 ,total:32KiB
dcache: sets:128, ways:4, linesz:32 ,total:16KiB
============================================
GSW VLAN:WLLL
GPIO_MODE init:
I2C:GPIO
SPI:GPIO
UART_F:GPIO
GPIO_MODE_REGs: 0x29f
READY_LED_BIT:8.
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP.
3: Boot system code via Flash (default).
4: Entr boot command line interface.
7: Load Boot Loader code then write to Flash via Serial.
9: Load Boot Loader code then write to Flash via TFTP.
0
3: System Boot system code via Flash.
Press Reset button enter upgrade mode!
## Booting image at bf080000 ...
Image Name: PandoraBox Linux-3.4.88
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 976812 Bytes = 953.9 kB
Load Address: 80000000
Entry Point: 80000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 80000000) ...
## Giving linux memsize in MB, 64
Starting kernel ...
PandoraBox For Ralink SoC. Copyright 2005-2013 Lintel<lintel.huang@gmail.com>
Linux Kernel started...
THIS IS ASIC
[ 0.000000] Linux version 3.4.88 (lintel@EmbeddedLab-Server) (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #1 Mon May 5 19:40:51 CST 2014
[ 0.000000] CPU Running in Little-Endian Mode !
[ 0.000000] Ralink RT3052 CPU:384MHz, Bus:128MHz Uart:128MHz
[ 0.000000] Boot form:NOR FLASH
[ 0.000000] Detecting memory...64 MB!
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU revision is: 0001964c (MIPS 24KEc)
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 04000000 @ 00000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] Zone PFN ranges:
[ 0.000000] Normal 0x00000000 -> 0x00004000
[ 0.000000] Movable zone start PFN for each node
[ 0.000000] Early memory PFN ranges
[ 0.000000] 0: 0x00000000 -> 0x00004000
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
[ 0.000000] Kernel command line: console=ttyS1,115200n8 board=HG255D rootfstype=squashfs
[ 0.000000] PID hash table entries: 256 (order: -2, 1024 bytes)
[ 0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
[ 0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.000000] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 32 bytes
[ 0.000000] Writing ErrCtl register=0007e072
[ 0.000000] Readback ErrCtl register=0007e072
[ 0.000000] Memory: 61808k/65536k available (2366k kernel code, 3728k reserved, 376k data, 172k init, 0k highmem)
[ 0.000000] SLUB: Genslabs=9, HWalign=16, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[ 0.000000] NR_IRQS:128
[ 0.000000] console [ttyS1] enabled, bootconsole disabled
[ 0.000000] console [ttyS1] enabled, bootconsole disabled
[ 0.010000] Calibrating delay loop... 255.59 BogoMIPS (lpj=1277952)
[ 0.090000] pid_max: default: 32768 minimum: 301
[ 0.090000] Mount-cache hash table entries: 512
[ 0.100000] NET: Registered protocol family 16
[ 0.100000] Ralink/MTK BootROM maped.
[ 0.110000] General GPIO Driver for Ralink RT3052 Board. Copyright lintel 2005-2013
[ 0.120000] gpiochip_add: registered GPIOs 0 to 23 on device: RT305X-GPIO0
[ 0.120000] gpiochip_add: registered GPIOs 24 to 39 on device: RT305X-GPIO1
[ 0.130000] gpiochip_add: registered GPIOs 40 to 51 on device: RT305X-GPIO2
[ 0.130000] MIPS: machine is HuaWei HG255D
[ 0.140000] Ralink Board GPIO_MODE init:
[ 0.140000] I2C:GPIO
[ 0.140000] SPI:GPIO
[ 0.140000] UART_F:GPIO
[ 0.150000] JTAG:GPIO
[ 0.150000] GPIO_MODE_REGs: 0x2df
[ 0.150000] ralink_register_flash:NOR Flash.
[ 0.170000] bio: create slab <bio-0> at 0
[ 0.180000] Switching to clocksource MIPS
[ 0.190000] NET: Registered protocol family 2
[ 0.190000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.190000] TCP established hash table entries: 2048 (order: 2, 16384 bytes)
[ 0.200000] TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.210000] TCP: Hash tables configured (established 2048 bind 2048)
[ 0.210000] TCP: reno registered
[ 0.220000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.220000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.230000] NET: Registered protocol family 1
[ 0.230000] Ralink SoC clocks api init.
[ 0.240000] Ralink GPIODEV resource maped.
[ 0.240000] Load Kernel WDG Timer Module
[ 0.250000] Load Ralink Timer0 Module
[ 0.280000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.290000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) 漏 2001-2006 Red Hat, Inc.
[ 0.300000] msgmni has been set to 120
[ 0.300000] io scheduler noop registered
[ 0.310000] io scheduler deadline registered (default)
[ 0.310000] io scheduler cfq registered
[ 0.320000] Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
[ 0.320000] serial8250: ttyS0 at MMIO 0x10000500 (irq = 37) is a 16550A
[ 0.330000] serial8250: ttyS1 at MMIO 0x10000c00 (irq = 12) is a 16550A
[ 0.340000] Enable Ralink GDMA Controller Module
[ 0.370000] brd: module loaded
[ 0.370000] physmap platform flash device: 01000000 at bf000000
[ 0.380000] physmap-flash: Found 1 x16 devices at 0x0 in 16-bit bank. Manufacturer ID 0x000001 Chip ID 0x002101
[ 0.390000] Amd/Fujitsu Extended Query Table at 0x0040
[ 0.390000] Amd/Fujitsu Extended Query version 1.3.
[ 0.400000] number of CFI chips: 1
[ 0.400000] Creating 5 MTD partitions on "physmap-flash":
[ 0.410000] 0x000000000000-0x000000040000 : "U-Boot"
[ 0.420000] 0x000000040000-0x000000060000 : "U-Boot-Env"
[ 0.420000] 0x000000060000-0x000000080000 : "Factory"
[ 0.430000] 0x000000000000-0x000001000000 : "fullflash"
[ 0.440000] 0x000000080000-0x000001000000 : "firmware"
[ 0.450000] Creating 2 MTD partitions on "physmap-flash":
[ 0.450000] 0x000000080000-0x000000180000 : "kernel"
[ 0.460000] 0x000000180000-0x000001000000 : "rootfs"
[ 0.470000] mtd: partition "rootfs" set to be root filesystem
[ 0.470000] mtd: partition "rootfs_data" created automatically, ofs=940000, len=6C0000
[ 0.480000] 0x000000940000-0x000001000000 : "rootfs_data"
[ 0.490000] EEPROM:Read from [Factory] offset 0x28,length 0x6.
[ 0.500000] GMAC1_MAC_ADRH -- : 0x0000000c
[ 0.500000] GMAC1_MAC_ADRL -- : 0x43305277
[ 0.510000] Ralink APSoC Ethernet Driver Initilization. v3.0.1 256 rx/tx descriptors allocated, mtu = 1500!
[ 0.520000] NAPI enable, Tx Ring = 256, Rx Ring = 256
[ 0.520000] Feature:{NAPI} {HW_CSO} {HW_VLAN_TX} {SKB_RECYCLE_2K}
[ 0.530000] EEPROM:Read from [Factory] offset 0x28,length 0x6.
[ 0.530000] warning: ra_mtd_read_nm: rdlen is not equal to len
[ 0.540000] GMAC1_MAC_ADRH -- : 0x0000000c
[ 0.540000] GMAC1_MAC_ADRL -- : 0x43305277
[ 0.550000] PROC INIT OK!
[ 0.550000] rt305x switch driver registered.
[ 0.560000] TCP: cubic registered
[ 0.560000] NET: Registered protocol family 17
[ 0.560000] Bridge firewalling registered
[ 0.570000] 8021q: 802.1Q VLAN Support v1.8
[ 0.580000] VFS: Mounted root (squashfs filesystem) readonly on device 31:6.
[ 0.590000] Freeing unused kernel memory: 172k freed
[ 2.920000] Button Hotplug driver version 0.4.1
- preinit -
Press the [f] key and hit [enter] to enter failsafe mode
- regular preinit -
[ 5.390000] jffs2: notice: (427) jffs2_build_xattr_subsystem: complete building xattr subsystem, 1 of xdatum (1 unchecked, 0 orphan) and 39 of xref (0 dead, 10 orphan) found.
switching to jffs2
- init - |
|
/1 
简体中文
繁體中文
English
日本語
Deutsch
한국 사람
بالعربية
TÜRKÇE
português
คนไทย
IP卡
狗仔卡
置顶卡
沉默卡
喧嚣卡
顶贴卡
显身卡