|
本帖最后由 wzzhen 于 2010-8-11 08:43 编辑
Linksys WRV54G
The linksys WRV54G is no Wrt, it does not use a broadcom chip, and runs on arm instead of mips.
For now, i recommend the openixp project if you have a wrv.
Hardware
CPU
Intel XScale 425 Part number: FWIXP425AB
Processor : XScale-IXP42x Family rev 1 (v5b)
BogoMIPS : 266.24
Features : swp half fastmult edsp
CPU implementer : 0x69
CPU architecture: 5TE
CPU variant : 0x0
CPU part : 0x41f
CPU revision : 1
Cache type : undefined 5
Cache clean : undefined 5
Cache lockdown : undefined 5
Cache format : Harvard
I size : 32768
I assoc : 32
I line length : 32
I sets : 32
D size : 32768
D assoc : 32
D line length : 32
D sets : 32
Hardware : Gemtek GTWX5715 (Linksys WRV54G)
Revision : 0000
Serial : 0000000000000000
RAM
32MB
Flash
Intel Strataflash 8MB Part Number: E28F640J3A120
WLAN Intersil Prism54
Serial Pinout (J11)
1: Txd
7: Rxd 2,4: +3.3V
6,8: GND
JTAG Pinout (J2) to EA253 parallel cable ('''100Ohm except GND''')
JTAG DB-25
3 (TRST-) 6
5 (TDI) 2
7 (TMS) 4
9 (TCK) 3
11 (GND) 25
more detail pinout
c[] LED5
+3.3V -- 1o o2 -- nc
nTRST -- 3o o4 -- GND
TDI -- 5o o6 -- GND
TMS -- 7o o8 -- GND
TCK -- 9o o10 - GND
GND - 11o o12 - GND
TDO - 13o o14 - GND
nRESET - 15o o16 - GND
nc - 17o o18 - GND
nc - 19o o20 - GND
booting openixp
Uncompressing Linux......................................... done, booting the kernel.
RGLoader Version: 2.4.4 Internal Version: 1.2
Press ESC to enter BOOT MENU mode.
Booting an active image in 0 seconds
Uncompressing Linux......................................... done, booting the kernel.
Linux version 2.6.13 (root@linux) (gcc version 3.4.4) #164
Fri Oct 28 14:00:15 CEST 2005
CPU: XScale-IXP42x Family [690541f1] revision 1 (ARMv5TE)
Machine: Gemtek GTWX5715 (Linksys WRV54G)
Memory policy: ECC disabled, Data cache writeback
On node 0 totalpages: 8192
DMA zone: 8192 pages, LIFO batch:3
Normal zone: 0 pages, LIFO batch:1
HighMem zone: 0 pages, LIFO batch:1
CPU0: D VIVT undefined 5 cache
CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
Built 1 zonelists
Kernel command line: mtdparts=IXP4XX:1280k(boot)ro,1024k@1280k(linux)ro,4608k@2304k(root) console=ttyS0,115200 root=/dev/mtdblock2 rootfstype=jffs2 init=/sbin/init
PID hash table entries: 256 (order: 8, 4096 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 32MB = 32MB total Memory: 30464KB available (1538K code, 329K data, 76K init)
Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
PCI: IXP4xx is host
PCI: IXP4xx Using direct access for memory space
PCI: bus0: Fast back to back transfers enabled
dmabounce: registered device 0000:00:01.0 on pci bus
dmabounce: registered device 0000:00:02.0 on pci bus
gtwx5715_map_irq: Mapped slot 1 pin 1 to IRQ 28
gtwx5715_map_irq: Mapped slot 2 pin 1 to IRQ 27
NetWinder Floating Point Emulator V0.97 (double precision)
JFFS2 version 2.2. (NAND) (C) 2001-2003 Red Hat, Inc.
Initializing Cryptographic API
creating /dev/console
IXP4xx Watchdog Timer: heartbeat 60 sec
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
platform: Matched Device serial8250.0 with Driver serial8250(irq = 13) is a XScale
io scheduler noop registered
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
loop: loaded (max 8 devices)
nbd: registered device at major 43
platform: Matched Device IXP4XX-LED.0 with Driver IXP4XX-LED
platform: Bound Device IXP4XX-LED.0 to Driver IXP4XX-LED
tun: Universal TUN/TAP device driver, 1.6 tun: (C) 1999-2004 Max Krasnyansky
platform: Matched Device IXP4XX-Flash.0 with Driver IXP4XX-Flash
IXP4XX-Flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
Intel/Sharp Extended Query Table at 0x0031
Using buffer write method cfi_cmdset_0001: Erase suspend on write enabled 0: offset=0x0,size=0x20000,blocks=64
MTD device IXP4XX-Flash.0
Creating 3 MTD partitions on "IXP4XX-Flash.
0x00000000-0x00140000 : "boot"
0x00140000-0x00240000 : "linux"
0x00240000-0x006c0000 : "root"
platform: Bound Device IXP4XX-Flash.0 to Driver IXP4XX-Flash
i2c /dev entries driver
platform: Matched Device IXP4XX-SPI.0 with Driver IXP4XX-SPI
platform: Bound Device IXP4XX-SPI.0 to Driver IXP4XX-SPI
KS8995M: Family ID: 95, Chip ID: 00, Revision ID: 01
NET: Registered protocol family 2
IP route cache hash table entries: 512 (order: -1, 2048 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
VFS: Mounted root (jffs2 filesystem) readonly.
Freeing init memory: 76K
802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller
Loaded prism54 driver, version 1.2
pci: Matched Device 0000:00:01.0 with Driver prism54
pci: Bound Device 0000:00:01.0 to Driver prism54
eth0: resetting device... eth0: uploading firmware... eth0: firmware version: eth0: firmware upload complete eth0: interface reset complete
ixp400: module license 'IPL' taints kernel.
ixp400: Module init.
ixp400_eth: Initializing IXP400 NPE Ethernet driver software v. 1.4
ixp400_eth: CPU clock speed (approx) = 266 MHz
ixp400_eth: ixp0 is using NPEB and the PHY at address 4
ixp400_eth: ixp1 is using NPEC and the PHY at address 5
ixp400_eth: Use default MAC address 00:02:b3:01:01:01 for port 0
ixp400_eth: Use default MAC address 00:02:b3:02:02:02 for port 1
ixp0.1: add 01:00:5e:00:00:01 mcast address to master interface
ixp0.2: add 01:00:5e:00:00:01 mcast address to master interface
ixp400_eth: ixp1,PHY:5 link up->down
ath_hal: 0.9.15.1 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413, REGOPS_FUNC)
wlan: 0.8.4.2 (Atheros/multi-bss) ath_rate_onoe: 1.0 ath_pci: 0.9.4.5 (Atheros/multi-bss)
pci: Matched Device 0000:00:02.0 with Driver
ath_pci PCI: enabling device 0000:00:02.0 (0340 -> 0342)
wifi0: 11a rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
wifi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
wifi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
wifi0: turboG rates: 6Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
SVN $Revision: 1200 $
wifi0: mac 5.9 phy 724.14 radio 3.6
wifi0: Use hw queue 1 for WME_AC_BE traffic
wifi0: Use hw queue 0 for WME_AC_BK traffic
wifi0: Use hw queue 2 for WME_AC_VI traffic
wifi0: Use hw queue 3 for WME_AC_VO traffic
wifi0: Use hw queue 8 for CAB traffic
wifi0: Use hw queue 9 for beacons
wifi0: Atheros 5212: mem=0x48000000, irq=27
pci: Bound Device 0000:00:02.0 to Driver
ath_pci wlan: mac acl policy registered
lspci
lspci:
00:01.0 Class 0280: 1260:3890 (rev 01)
Subsystem: 1260:0000
Flags: bus master, fast Back2Back, medium devsel, latency 128, IRQ 28
Memory at 48010000 (32-bit, non-prefetchable) [size=8K]
Capabilities: [dc] Power Management version 1
00:02.0 Class 0200: 168c:0013 (rev 01)
Subsystem: 168c:2042
Flags: bus master, fast Back2Back, medium devsel, latency 168, IRQ 27
Memory at 48000000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [44] Power Management version 2
/proc/diag
Bit 0 1
0 power LED constant yellow power LED blinking green
1 wireless LED yellow, more light when working wireless LED dark, green when working
2 wireless2 LED yellow, more light when working wireless2 LED dark, green when working
3 Internet LED yellow, more light when working Internet LED green, dark when working
4 DMZ LED green DMZ LED dark |
|