D-LINK DI524M 固件问题

qe***

不能让这个帖子沉了，我的也是黑色版的，现在输入192.168.0.1 进去后提示这个：
  
不知道怎么操作，点上传固件，选择固件后点升级后也没反应！
现在接TTL后信息如下：
U-Boot 1.1.3 (Oct  8 2009 - 11:11:53) - SVN revision : 207

Model: WRGN23M

Board: Ralink APSoC DRAM:   8 MB
spi_wait_nsec: 3e
spi deice id: c2 20 15 c2 20 (2015c220)
find flash: mx25l1605d
raspi_read: from:30000 len:1000
raspi_read: from:30000 len:1000
============================================
Ralink UBoot Version: 3.3 Alpha
--------------------------------------------
ASIC 3052_MP2 (Port5<->None)
DRAM component: 64 Mbits SDR
DRAM bus: 16 bit
Total memory: 8 MBytes
Flash component: SPI Flash
Date:Oct  8 2009  Time:11:11:53
============================================
icache: sets:256, ways:4, linesz:32 ,total:32768
dcache: sets:128, ways:4, linesz:32 ,total:16384
## Powering down port 0 ~ 4.

Please choose the operation:
   1: Load system code to SDRAM via TFTP.
   2: Load system code then write to Flash via TFTP.
   3: Boot system code via Flash (default).
   4: Entr boot command line interface.
   9: Load Boot Loader code then write to Flash via TFTP.
0
   
3: System Boot system code via Flash.
## Booting image at bf050000 ...
raspi_read: from:50000 len:40
raspi_read: from:50000 len:ca64d
We have SEAMA, Image Size = 828926
Verifying Checksum ...
Bad Header Checksum.
## Powering up port 0 ~ 4.


Entering HTTP server.

KSEG1ADDR(NetTxPacket) = 0xA07E6BC0

NetLoop,call eth_halt !

NetLoop,call eth_init !

Waitting for RX_DMA_BUSY status Start... done

Header Payload scatter function is Disable !!

ETH_STATE_ACTIVE!!
Using Eth0 (10/100-M) device
Start HTTP server on port 80, 192.168.0.1
Running ...
checksum bad
checksum bad
checksum bad
checksum bad
checksum bad
checksum bad
Got ARP REQUEST, return our IP
checksum bad


请问高手们，这个路由器是多大闪存的，多大缓存的？应该怎样刷固件!

zhang***

固件丢失,看一下你的是A版还是B版,选择相应的版本,更新就可以了,还有一个事就是有时电源电压不足也会出现这样的现象

明***

刷一下就好了吧

nasa2***

刷B版固件

qe***

哦！谢谢大家！

x***

这个uboot还带httpd的？

qiy***

这个B1的破货，每5天就得重启一次，你还别说真有mini的界面，这个想折腾得换32M内存 4Mflash 改电阻 刷DD或者OP

gll***

多谢楼主的帖子   救活了我的DIR600B2