请问各位高人 whr g300n ttl刷机出现下面问题是什么原因 在线等

宝***

U-Boot 1.1.3 (Oct 13 2009 - 10:17:55)
Board: Ralink APSoC DRAM:  32 MB
relocate_code Pointer at: 81fb0000
flash_protect ON: from 0xBF000000 to 0xBF01D3F3
flash_protect ON: from 0xBF030000 to 0xBF030FFF
*** Warning - bad CRC, using default environment
============================================
Ralink UBoot Version: 3.3
--------------------------------------------
ASIC 3052_MP2 (Port5<->None)
DRAM component: 128 Mbits SDR
DRAM bus: 32 bit
Total memory: 32 MBytes
Flash component: NOR Flash
Date:Oct 13 2009  Time:10:17:55
============================================
icache: sets:256, ways:4, linesz:32 ,total:32768
dcache: sets:128, ways:4, linesz:32 ,total:16384
##### The CPU freq = 384 MHZ ####
SDRAM bus set to 32 bit
SDRAM size =32 Mbytes
Please choose the operation:
   1: Load system code to SDRAM via TFTP.
   2: Load system code then write to Flash via TFTP.
   3: Boot system code via Flash (default).
   4: Entr boot command line interface.
   9: Load Boot Loader code then write to Flash via TFTP.
You choosed 3
0
   
3: System Boot system code via Flash.
## Booting image at bf050000 ...
   Image Name:   MIPS Linux Kernel Image
   Created:      2011-12-14   5:01:37 UTC
   Image Type:   MIPS Linux Kernel Image (lzma compressed)
   Data Size:    856379 Bytes = 836.3 kB
   Load Address: 80002000
   Entry Point:  801e7330
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 801e7330) ...
## Giving linux memsize in MB, 32
Starting kernel ...


到这就没动静 请各位高手帮忙

宝***

机子是 whr g300n
不是 v2版本的

宝***

没有人吗？

宝***

各位高人 帮个忙

宝***

还是没人呀

漫天***

WHR-300HP 300m  TTL接法是什么呢