|
能给一份factory.bin文件吗?我的ax1800t已经变砖了,进不去系统,ttl信息:
U-Boot SPL 2018.09-g6c1f25b (Mar 29 2021 - 10:59:27 +0800)
Trying to boot from NAND
U-Boot 2018.09-g6c1f25b (Mar 29 2021 - 10:59:27 +0800)
CPU: MediaTek MT7621AT ver 1, eco 3
Clocks: CPU: 1100MHz, DDR: 1200MHz, Bus: 275MHz, XTAL: 40MHz
Model: MediaTek MT7621 reference board (NAND)
DRAM: 256 MiB
NAND: 128 MiB
Loading Environment from NAND... OK
In: uartlite0@1e000c00
Out: uartlite0@1e000c00
Err: uartlite0@1e000c00
Net: Factory: using factory mac
NAND read: device 0 offset 0x100000, size 0x20000
131072 bytes read: OK
Warning: eth@1e100000 (eth0) using random MAC address - 32:95:e3:5f:47:97
eth0: eth@1e100000
Hit any key to stop autoboot: 0
gpio: pin 7 (gpio 7) value is 1
gpio: pin 8 (gpio 8) value is 1
gpio: pin 6 (gpio 6) value is 1
gpio: pin 8 (gpio 8) value is 0
*** U-Boot Boot Menu ***
1. Factory Network Boot
2. Auto Dual System Boot
3. Upgrade firmware
4. Upgrade bootloader
5. Upgrade bootloader (advanced mode)
6. Load image
7. Main system
8. Boot From Firmware2
0. U-Boot console
Press UP/DOWN to move, ENTER to select
Factory: go as factory_boot=1
NAND read: device 0 offset 0x100000, size 0x20000
131072 bytes read: OK
Factory: using ipaddr 192.168.1.97
Using eth@1e100000 device
TFTP from server 192.168.1.254; our IP address is 192.168.1.97
Filename 'factory.bin'.
Load address: 0x80010000
Loading: ## Warning: gatewayip needed but not set
## Warning: gatewayip needed but not set
## Warning: gatewayip needed but not set
## Warning: gatewayip needed but not set
ARP Retry count exceeded; starting again
Factory: tftp download fail
Select Firmware1 to start
Loading from nand0, offset 0x180000
Image Name: NAND Flash I
Image Type: MIPS Linux Standalone Program (uncompressed)
Data Size: 172292 Bytes = 168.3 KiB
Load Address: a0200000
Entry Point: a0200000
Automatic boot of image at addr 0x80010000 ...
## Booting kernel from Legacy Image at 80010000 ...
Image Name: NAND Flash I
Image Type: MIPS Linux Standalone Program (uncompressed)
Data Size: 172292 Bytes = 168.3 KiB
Load Address: a0200000
Entry Point: a0200000
Verifying Checksum ... OK
Loading Standalone Program ... OK |
|