找回密码
 立即注册

QQ登录

只需一步,快速开始

搜索
广告投放联系QQ68610888
楼主: bwq518

Tenda N80固件测试

[复制链接]
发表于 2014-3-18 11:04 | 显示全部楼层
谢谢518版主,测试后反馈。
发表于 2014-3-19 00:05 | 显示全部楼层
更新8M固件了啊   明天试试如何
发表于 2014-3-19 11:22 | 显示全部楼层
本帖最后由 antons 于 2014-3-19 11:24 编辑

CFE version 5.100.138.22 based on BBP 1.0.37 for BCM947XX (32bit,SP,LE)
Build Date: 2012骞?04鏈?19鏃?鏄熸湡鍥?19:49:40 CST (root@linux-svzy-cj)
Copyright (C) 2000-2008 Broadcom Corporation.

Init Arena
Init Devs.
Boot partition size = 131072(0x20000)
Found an ST compatible serial flash with 128 64KB blocks; total size 8MB
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.100.138.22
CPU type 0x19749: 600MHz
Tot mem: 131072 KBytes

CFE mem:    0x81000000 - 0x81098530 (623920)
Data:       0x8102E350 - 0x810315A0 (12880)
BSS:        0x810315A0 - 0x81032530 (3984)
Heap:       0x81032530 - 0x81096530 (409600)
Stack:      0x81096530 - 0x81098530 (8192)
Text:       0x81000000 - 0x8102E34C (189260)

Device eth0:  hwaddr C8-3A-35-0A-D3-B8, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
Loader:raw Filesys:tftp Dev:eth0 File:: Optionsnull)
Loading: Failed.
Could not load :: Timeout occured
Loader:raw Filesys:raw Dev:flash0.os File: Optionsnull)
Loading: .. 5192 bytes read
Entry at 0x80001000
Closing network.
Starting program at 0x80001000
Linux version 2.6.22.19 (root@tomato) (gcc version 4.2.4) #52 Mon Mar 17 22:08:49 CST 2014
CPU revision is: 00019749
Determined physical RAM map:
memory: 07fff000 @ 00000000 (usable)
Zone PFN ranges:
  Normal          0 ->    32767
  HighMem     32767 ->    32767
early_node_map[1] active PFN ranges
    0:        0 ->    32767
Built 1 zonelists.  Total pages: 32767
Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200
Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, linesize 32 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 512 (order: 9, 2048 bytes)
CPU: BCM5300 rev 1 pkg 0 at 600 MHz
Using 300.000 MHz high precision timer.
console [ttyS0] enabled
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 126648k/131068k available (33k kernel code, 4272k reserved, 2778k data, 128k init, 0k highmem)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
PCI: Initializing host
PCI: Reset RC
PCI: Initializing host
PCI: Reset RC
PCI: Fixing up bus 0
PCI/PCIe coreunit 0 is set to bus 1.
PCI: Fixing up bridge
PCI: Fixing up bridge
PCI: Enabling device 0000:01:00.1 (0004 -> 0006)
PCI: Fixing up bus 1
PCI/PCIe coreunit 1 is set to bus 2.
PCI: Fixing up bridge
PCI: Fixing up bridge
PCI: Enabling device 0000:02:00.1 (0004 -> 0006)
PCI: Fixing up bus 2
NET: Registered protocol family 2
Time: MIPS clocksource has been installed.
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
squashfs: version 3.0 (2006/03/15) Phillip Lougher
io scheduler noop registered (default)
HDLC line discipline: version $Revision: 4.8 $, maxframe=4096
N_HDLC line discipline registered.
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0xb8000300 (irq = 8) is a 16550A
serial8250: ttyS1 at MMIO 0xb8000400 (irq = 8) is a 16550A
PPP generic driver version 2.4.2
MPPE/MPPC encryption/compression module registered
NET: Registered protocol family 24
PPPoL2TP kernel driver, V0.18.3
PPTP driver version 0.8.5
pflash: found no supported devices
Found an ST compatible serial flash with 128 64KB blocks; total size 8MB
Creating 5 MTD partitions on "sflash":
0x00000000-0x00020000 : "pmon"
0x00020000-0x007f0000 : "linux"
0x0010c400-0x00660000 : "rootfs"
0x00660000-0x007f0000 : "jffs2"
0x007f0000-0x00800000 : "nvram"
_nvram_init: allocat header: 2150989824, size= 32768
u32 classifier
    OLD policer on
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (1024 buckets, 8192 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
ipt_account 0.1.21 : Piotr Gasidlo <quaker@barbara.eu.org>, http://www.barbara.eu.org/~quaker/ipt_account/
net/ipv4/netfilter/tomato_ct.c [Mar 17 2014 22:08:47]
NET: Registered protocol family 1
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 128k freed
Warning: unable to open an initial console.
emf: module license 'Proprietary' taints kernel.
eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.110.27.20012
wl_module_init: passivemode set to 0x0
PCI: Enabling device 0000:01:01.0 (0000 -> 0002)
eth1: Broadcom BCM4331 802.11 Wireless Controller 5.110.27.20012
PCI: Enabling device 0000:02:01.0 (0000 -> 0002)
eth2: Broadcom BCM4331 802.11 Wireless Controller 5.110.27.20012
/ # lo: File exists


测试8M版OK   无线正常  官方固件改BIN后缀无法刷入 只能TFTP升级{:soso_e127:}



 楼主| 发表于 2014-3-19 13:35 | 显示全部楼层
antons 发表于 2014-3-19 11:22
CFE version 5.100.138.22 based on BBP 1.0.37 for BCM947XX (32bit,SP,LE)
Build Date: 2012骞?04鏈?19 ...

谢谢。8M用的是5.x的驱动,16M用的是6.x的驱动,不过应该都能用。
发表于 2014-3-20 01:34 | 显示全部楼层
B版主,我的N80已经换了16M的FLASH上去了,看见A大已经测试了,暂时不想换了。
 楼主| 发表于 2014-3-22 14:26 | 显示全部楼层
dahuhuzhu 发表于 2014-3-20 01:34
B版主,我的N80已经换了16M的FLASH上去了,看见A大已经测试了,暂时不想换了。

8M, 16M的都可以用。
发表于 2014-5-28 14:58 | 显示全部楼层
bwq518 发表于 2014-3-22 14:26
8M, 16M的都可以用。

tftp不出来,,,,
发表于 2014-5-28 14:58 | 显示全部楼层
貌似要火,js赶快囤货。
发表于 2014-5-28 15:59 | 显示全部楼层
版主好,等我也买个568快到手了。
发表于 2014-5-28 19:23 | 显示全部楼层
antren 发表于 2014-5-28 15:59
版主好,等我也买个568快到手了。

568能刷吗??我也下单了。还没付款
发表于 2014-5-28 20:29 | 显示全部楼层
W1800R是不是可以直接刷 机?
发表于 2014-6-2 22:07 | 显示全部楼层
qml 发表于 2014-5-28 19:23
568能刷吗??我也下单了。还没付款

能刷,但我最后没付款
发表于 2014-8-21 23:48 | 显示全部楼层
条LINE死了,{:soso_e109:}
下载链接:  http://pan.baidu.com/s/1kTsj0EV
无得试
您需要登录后才可以回帖 登录 | 立即注册

本版积分规则

关闭

欢迎大家光临恩山无线论坛上一条 /1 下一条

有疑问请添加管理员QQ86788181|手机版|小黑屋|Archiver|恩山无线论坛(常州市恩山计算机开发有限公司版权所有) ( 苏ICP备05084872号 )

GMT+8, 2024-6-14 13:27

Powered by Discuz! X3.5

© 2001-2024 Discuz! Team.

| 江苏省互联网有害信息举报中心 举报信箱:js12377 | @jischina.com.cn 举报电话:025-88802724 本站不良内容举报信箱:68610888@qq.com

快速回复 返回顶部 返回列表