找回密码
 立即注册

QQ登录

只需一步,快速开始

搜索
广告投放联系QQ68610888
查看: 13114|回复: 44

Tenda N80固件测试

[复制链接]
  下载链接:  http://pan.baidu.com/s/1kTsj0EV

   请在此跟帖反馈测试结果。多谢各位。

评分

参与人数 1恩山币 +3 收起 理由
jzm*** + 3 大大好棒,bcm4706的cpu,很1800差不多。

查看全部评分

我的恩山、我的无线 The best wifi forum is right here.
感谢B版主,请问可以直接在官方固件下升级还是需要在miniweb下刷?
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

518版主你好。你的固件太棒了。可否在116固件中加入PPPOE功能啊,或者教下方法安装,我今天百度一天了。未解决!

只能求助作者你了。
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

本帖最后由 antons 于 2014-3-15 20:28 编辑

已经成功刷入

顺便前排贴下
已经测试确定 LAN4的 IPTV口在TT  或者原厂固件下只能工作在100M 全双工  
不知道是否为个案  考虑到还有散热片不配套等问题  我的可能为工程机或者早期产品 请有机器的同学继续测试
MX25L256 型芯片已经测试  原厂CFE不识别此FLASH  请勿重复测试


TTL下中断原厂固件启动

进入MINI web

spiflash  太慢了  擦写16M 使用了5分24秒

重启 OK

Init Arena
Init Devs.
Boot partition size = 131072(0x20000)
Found an ST compatible serial flash with 256 64KB blocks; total size 16MB
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.100.138.22
CPU type 0x19749: 600MHz
Tot mem: 131072 KBytes

CFE mem:    0x81000000 - 0x81098530 (623920)
Data:       0x8102E350 - 0x810315A0 (12880)
BSS:        0x810315A0 - 0x81032530 (3984)
Heap:       0x81032530 - 0x81096530 (409600)
Stack:      0x81096530 - 0x81098530 (8192)
Text:       0x81000000 - 0x8102E34C (189260)

Device eth0:  hwaddr C8-3A-35-0A-D3-B8, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
Loader:raw Filesys:raw Dev:flash0.os File: Optionsnull)
Loading: ... 2965796 bytes read
Entry at 0x80001000
Closing network.
Starting program at 0x80001000
Linux version 2.6.22.19 (root@asus) (gcc version 4.2.4) #4 Fri Mar 14 15:27:53 CST 2014
CPU revision is: 00019749
Found an ST compatible serial flash with 256 64KB blocks; total size 16MB
Determined physical RAM map:
memory: 07fff000 @ 00000000 (usable)
Zone PFN ranges:
  Normal          0 ->    32767
  HighMem     32767 ->    32767
early_node_map[1] active PFN ranges
    0:        0 ->    32767
Built 1 zonelists.  Total pages: 32767
Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200
Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, linesize 32 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 512 (order: 9, 2048 bytes)
CPU: BCM5300 rev 1 pkg 0 at 600 MHz
Using 300.000 MHz high precision timer.
console [ttyS0] enabled
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 126392k/131068k available (2335k kernel code, 4516k reserved, 364k data, 196k init, 0k highmem)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
PCI: Initializing host
PCI: Reset RC
PCI: Initializing host
PCI: Reset RC
PCI: Fixing up bus 0
PCI/PCIe coreunit 0 is set to bus 1.
PCI: Fixing up bridge
PCI: Fixing up bridge
PCI: Enabling device 0000:01:00.1 (0004 -> 0006)
PCI: Fixing up bus 1
PCI/PCIe coreunit 1 is set to bus 2.
PCI: Fixing up bridge
PCI: Fixing up bridge
PCI: Enabling device 0000:02:00.1 (0004 -> 0006)
PCI: Fixing up bus 2
NET: Registered protocol family 2
Time: MIPS clocksource has been installed.
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
squashfs: version 3.2-r2 (2007/01/15) Phillip Lougher
io scheduler noop registered (default)
HDLC line discipline: version $Revision: 4.8 $, maxframe=4096
N_HDLC line discipline registered.
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0xb8000300 (irq = 8) is a 16550A
serial8250: ttyS1 at MMIO 0xb8000400 (irq = 8) is a 16550A
PPP generic driver version 2.4.2
MPPE/MPPC encryption/compression module registered
NET: Registered protocol family 24
PPPoL2TP kernel driver, V0.18.3
PPTP driver version 0.8.5
pflash: found no supported devices
Creating 5 MTD partitions on "sflash":
0x00000000-0x00020000 : "pmon"
0x00020000-0x00ff0000 : "linux"
0x001242d8-0x00fb0000 : "rootfs"
0x00ff0000-0x01000000 : "nvram"
0x00fb0000-0x00ff0000 : "jffs2"
dev_nvram_init: _nvram_init
_nvram_init: allocat size= 65536
u32 classifier
    OLD policer on
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (1024 buckets, 8192 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
ipt_account 0.1.21 : Piotr Gasidlo <quaker@barbara.eu.org>, http://www.barbara.eu.org/~quaker/ipt_account/
net/ipv4/netfilter/tomato_ct.c [Mar 14 2014 12:03:19]
NET: Registered protocol family 1
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 196k freed
Warning: unable to open an initial console.
emf: module license 'Proprietary' taints kernel.
et_module_init: passivemode set to 0x0
et_module_init: et_txq_thresh set to 0x0
bcm_robo_enable_switch: EEE is enabled
eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 6.30.39.31 (r341183)
PCI: Enabling device 0000:01:01.0 (0000 -> 0002)
eth1: Broadcom BCM4331 802.11 Wireless Controller 6.30.102.9 (r366174)
PCI: Enabling device 0000:02:01.0 (0000 -> 0002)
eth2: Broadcom BCM4331 802.11 Wireless Controller 6.30.102.9 (r366174)
/ # lo: File exists






本帖子中包含更多资源

您需要 登录 才可以下载或查看,没有账号?立即注册

×
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

 楼主| 来自手机 | 显示全部楼层
dahuhuzhu 发表于 2014-3-14 23:37
感谢B版主,请问可以直接在官方固件下升级还是需要在miniweb下刷?

直刷
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报


518版主你好。你的固件太棒了。可否在116固件中加入PPPOE功能啊,或者教下方法安装,我今天百度一天了。未解决!

只能求助作者你了。
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

来自手机 | 显示全部楼层
老大能不能支持下r6300 v1啊
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

请问网盘里的两个固件有什么区别啊?
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

来自手机 | 显示全部楼层
能否出一个q3的固件
期待你的估计支持多wan
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

antons 发表于 2014-3-15 02:08
已经成功刷入

TTL下中断原厂固件启动

请问N80是怎么在TTL里中断,我按CTRL+C中断不了,官方固件下直刷报告格式错误。
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

dahuhuzhu 发表于 2014-3-15 11:35
请问N80是怎么在TTL里中断,我按CTRL+C中断不了,官方固件下直刷报告格式错误。

先按住C +ctrl   再开机
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

本帖最后由 dahuhuzhu 于 2014-3-15 13:38 编辑
antons 发表于 2014-3-15 11:40
先按住C +ctrl   再开机
进到miniweb了,但显示上传楼主的固件容量错误,如何解决?
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

貌似要火,js赶快囤货。
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

asrock2006 发表于 2014-3-15 12:55
貌似要火,js赶快囤货。

腾达生产了一批又一批,屯个毛线
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

除了A大,还有刷成功的吗?我的miniweb上传不了,能给详细些的教程吗?
我的恩山、我的无线 The best wifi forum is right here.
回复

使用道具 举报

您需要登录后才可以回帖 登录 | 立即注册

本版积分规则

有疑问请添加管理员QQ86788181|手机版|小黑屋|Archiver|恩山无线论坛(常州市恩山计算机开发有限公司版权所有) ( 苏ICP备05084872号 )

GMT+8, 2024-4-28 05:23

Powered by Discuz! X3.5

© 2001-2024 Discuz! Team.

| 江苏省互联网有害信息举报中心 举报信箱:js12377 | @jischina.com.cn 举报电话:025-88802724 本站不良内容举报信箱:68610888@qq.com 举报电话:0519-86695797

快速回复 返回顶部 返回列表