用TTL线给DB120修砖 能进入miniweb页面 能刷进去 但还是砖

oppsuer

Board IP address                  : 192.168.1.1:ffffff00  
Host IP address                   : 192.168.1.159  
Gateway IP address                :   
Run from flash/host (f/h)         : h  
Default host run file name        : 308nfs6358  
Default host flash file name      : bcm963xx_fs_kernel  
Boot delay (0-9 seconds)          : 1  
Board Id (0-2)                    : 96358UR  
Number of MAC Addresses (1-32)    : 10  
Base MAC Address                  : 00:10:18:00:00:00  
PSI Size (1-64) KBytes            : 24  
Flash Block Size (1-128) in KBytes: 64  
Auxillary File System Size Percent: 0  
Main Thread Number [0|1]          : 0  

*** Press any key to stop auto run (1 seconds) ***
Auto run second count down: 0
Booting from only image (0xbe020000) ...
Code Address: 0x80010000, Entry Address: 0x80010000
Decompression OK!
Entry at 0x80010000
Closing network.
Starting program at 0x80010000
Linux version 2.6.32.55 (lintel@EmbeddedLab) (gcc version 4.3.3 (GCC) ) #6 Wed Feb 1 01:43:45 CST 2012
Detected Broadcom 0x6358 CPU revision a1
CPU frequency is 300 MHz
32MB of RAM installed
registering 40 GPIOs
board_bcm963xx: CFE version: 1.0.37-10.3
board_bcm963xx: unknown bcm963xx board: 96358UR
bootconsole [early0] enabled
CPU revision is: 0002a010 (Broadcom BCM6358)
Kernel panic - not syncing: unable to detect bcm963xx board
一开始刷的openwrt 但是不能PPPOE拨号  快速向导拨号也是失败的  路由获取不到IP 后来刷了好几个版本的openwrt  之后就成砖了  
求教啊  cfe和openwrt应该没问题啊  但怎么就无法正常启动呢  难得必须得用JTAG来救了吗

sniper99999

borad ID没选对，在CFE模式下按B去选，一个个试，哪个能正常启动就是哪个