|
H大,我的WDR3320刷砖了,能帮忙看看还能救不
ttl开机日志:
U-Boot 1.1.4 (Jan 17 2013 - 14:30:14)
U-Boot DB120
Wasp 1.3
DRAM: 64 MB
Flash Manuf Id 0x1, DeviceId0 0x2, DeviceId1 0x15
Flash: 4 MB
Using default environment
U-Boot 1.1.4 (Jan 17 2013 - 14:30:14)
U-Boot DB120
Wasp 1.3
DRAM: 64 MB
Flash Manuf Id 0x1, DeviceId0 0x2, DeviceId1 0x15
Flash: 4 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag934x_enet_initialize...
No valid address in Flash. Using fixed address
No valid address in Flash. Using fixed address
wasp reset mask:c03300
WASP ----> S27 PHY
GMAC: cfg1 0x80000000 cfg2 0x7114
eth0: ba:be:fa:ce:08:41
s27 reg init
athrs27_phy_setup ATHR_PHY_CONTROL 4 :0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 4 :0x10
eth0 up
WASP ----> S27 PHY
GMAC: cfg1 0xf cfg2 0x7214
eth1: ba:be:fa:ce:08:41
s27 reg init lan
ATHRS27: resetting s27
ATHRS27: s27 reset done
athrs27_phy_setup ATHR_PHY_CONTROL 0 :0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 0 :0x10
athrs27_phy_setup ATHR_PHY_CONTROL 1 :0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 1 :0x10
athrs27_phy_setup ATHR_PHY_CONTROL 2 :0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 2 :0x10
athrs27_phy_setup ATHR_PHY_CONTROL 3 :0x1000
athrs27_phy_setup ATHR_PHY_SPEC_STAUS 3 :0x10
eth1 up
eth0, eth1
Setting 0xb8116290 to 0x21422d0f
Autobooting in 1 seconds
## Booting image at 9f020000 ...
Uncompressing Kernel Image ... Not enough buffer for decompression
LZMA ERROR 1 - must RESET board to recover
主板图 |
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有账号?立即注册
×
|