|
这个都能砖头?如果刷的quashfs-factory.bin,不管出啥问题,接电源灯闪后按reset进Failsafe mode不就可以了么。
以下官网原话:
Failsafe mode
When the configuration no longer allows you to log in via any network connection (e.g. lost password), the OpenWrt failsafe mode can be entered via the single "Reset" button on the device. However, in contrast to the generic failsafe instructions, for the TL-WR703N you have to wait for ca. 12 seconds before pushing the "Reset" button after powering on the device. If the button is pushed immediately after powering on, the single blue LED will start blinking, supposedly indicating some failsafe firmware recovery mody of the embedded bootloader (not yet discovered how to use it). In this mode, the OpenWrt failsafe is not being started. Instead, wait for slightly longer than 10 seconds and - as soon as the LED starts blinking for the first time after powering on the device, push the "Reset" button for ca. 1-2 seconds. Immediately afterwards, the LED will blink rapidly (multiple Hz) and OpenWrt will be in failsafe mode. |
|