|
# dmesg | more
<4>CPU revision is: 00029007
<4>Primary instruction cache 8kb, linesize 16 bytes (2 ways)
<4>Primary data cache 4kb, linesize 16 bytes (2 ways)
<4>Linux version 2.4.20 (root@etch) (gcc version 3.2.3 with Broadcom modificatio
ns) #43 Sun May 20 18:08:39 PDT 2007
<4>Setting the PFC value as 0x15
<4>Determined physical RAM map:
<4> memory: 02000000 @ 00000000 (usable)
<4>On node 0 totalpages: 8192
<4>zone(0): 8192 pages.
<4>zone(1): 0 pages.
<4>zone(2): 0 pages.
<4>Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200
<4>CPU: BCM4712 rev 2 at 216 MHz
<4>Calibrating delay loop... 215.44 BogoMIPS
<6>Memory: 30684k/32768k available (1320k kernel code, 2084k reserved, 108k data
, 64k init, 0k highmem)
<6>Dentry cache hash table entries: 4096 (order: 3, 32768 bytes)
<6>Inode cache hash table entries: 2048 (order: 2, 16384 bytes)
<4>Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
<4>Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)
<4>Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
<4>Checking for 'wait' instruction... unavailable.
<4>POSIX conformance testing by UNIFIX
<4>PCI: Disabled
<4>PCI: Fixing up bus 0
<6>Linux NET4.0 for Linux 2.4
<6>Based upon Swansea University Computer Society NET3.039
<4>Initializing RT netlink socket
<4>Starting kswapd
<6>devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
<6>devfs: boot_options: 0x1
<6>Squashfs 2.2-r2 (released 2005/09/08) (C) 2002-2005 Phillip Lougher
<4>pty: 256 Unix98 ptys configured
<6>Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI
enabled
<6>ttyS00 at 0xb8000300 (irq = 3) is a 16550A
<6>ttyS01 at 0xb8000400 (irq = 0) is a 16550A
<4>HDLC line discipline: version $Revision: 1.1.1.4 $, maxframe=4096
<6>N_HDLC line discipline registered.
<6>PPP generic driver version 2.4.2
<7>Physically mapped flash: Found an alias at 0x800000 for the chip at 0x0
<7>Physically mapped flash: Found an alias at 0x1000000 for the chip at 0x0
<7>Physically mapped flash: Found an alias at 0x1800000 for the chip at 0x0
<7>number of CFI chips: 1
<7>0: offset=0x0,size=0x20000,blocks=64
<5>Flash device: 0x800000 at 0x1c000000
<5>Creating 5 MTD partitions on "Physically mapped flash":
<5>0x00000000-0x00040000 : "pmon"
<5>0x00040000-0x007e0000 : "linux"
<5>0x000e1980-0x00300000 : "rootfs"
<5>0x00300000-0x007e0000 : "jffs2"
<5>0x007e0000-0x00800000 : "nvram"
<3>sflash: found no supported devices
<6>NET4: Linux TCP/IP 1.0 for NET4.0
<6>IP Protocols: ICMP, UDP, TCP, IGMP
<6>IP: routing cache hash table of 512 buckets, 4Kbytes
<6>TCP: Hash tables configured (established 2048 bind 4096)
<6>Linux IP multicast router 0.06 plus PIM-SM
<4>ip_conntrack version 2.1 (4099 buckets, 2048 max) - 368 bytes per conntrack
<4>ip_tables: (C) 2000-2002 Netfilter core team
<6>NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
<6>NET4: Ethernet Bridge 008 for NET4.0
<1>802.1Q VLAN Support v1.7 Ben Greear <greearb@candelatech.com>
<1>All bugs added by David S. Miller <davem@redhat.com>
<4>VFS: Mounted root (squashfs filesystem) readonly.
<6>Mounted devfs on /dev
<6>Freeing unused kernel memory: 64k freed
<4>Algorithmics/MIPS FPU Emulator v1.5
<4>ip_conntrack_pptp version 1.9 loaded
<4>ip_nat_pptp version 1.5 loaded
<4>ip_conntrack_rtsp v0.01 loading
<4>ip_nat_rtsp v0.01 loading
<4>eth0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 3.90.38.0
<4>eth1: Broadcom BCM4320 802.11 Wireless Controller 3.90.38.0
<4>tomato_ct.c [May 8 2007 19:04:20]
<6>vlan0: dev_set_promiscuity(master, 1)
<6>device eth0 entered promiscuous mode
<6>device vlan0 entered promiscuous mode
<6>device eth1 entered promiscuous mode
<6>br0: port 2(eth1) entering learning state
<6>br0: port 1(vlan0) entering learning state
<6>br0: port 2(eth1) entering forwarding state
<6>br0: topology change detected, propagating
<6>br0: port 1(vlan0) entering forwarding state
<6>br0: topology change detected, propagating
[ 本帖最后由 yankailei 于 2007-9-2 11:53 编辑 ] |
|