|
|
这一款的TTL显示信息：
CFE version 1.16.0-102.9 for BCM96368 (32bit,SP,BE)
Build Date: 06/02/2011 (tomato@sw3-code-build-srv-02)
Copyright (C) 2000-2009 Broadcom Corporation.
Parallel flash device: name AM29DL800B, id 0x22cb, size 8192KB
CPU type 0x2A031: 400MHz, Bus: 160MHz, Ref: 64MHz
CPU running TP0
Total memory: 33554432 bytes (32MB)
Boot Address 0xb8000000
Board IP address : 192.168.1.1:ffffff00
Host IP address : 192.168.1.100
Gateway IP address :
Run from flash/host (f/h) : f
Default host run file name : vmlinux
Default host flash file name : bcm963xx_fs_kernel
Boot delay (0-9 seconds) : 3
Board Id (0-4) : 96368MVWG
Number of MAC Addresses (1-32) : 10
Base MAC Address : c8:6c:87:9b:82:44
PSI Size (1-64) KBytes : 24
Main Thread Number [0|1] : 0
*** Press any key to stop auto run (3 seconds) ***
Auto run second count down: 0
Checking Reset button on GPIO 34
Wait for Multiboot Service Packet... 0
Booting from only image (0xb8020000) ...
Code Address: 0x80010000, Entry Address: 0x802e2000
Decompression OK!
Entry at 0x802e2000
Closing network.
Disabling Switch ports.
Flushing Receive Buffers...
0 buffers found.
Closing DMA Channels.
Starting program at 0x802e2000
Linux version 2.6.21.5 (tomato@sw3-code-build-srv-02) (gcc version 4.2.3) #1 Thu Jun 2 15:59:50 CST 2011
Parallel flash device: name AM29DL800B, id 0x22cb, size 8192KB
96368MVWG prom init
CPU revision is: 0002a031
Determined physical RAM map:
memory: 01f00000 @ 00000000 (usable)
On node 0 totalpages: 7936
DMA zone: 32 pages used for memmap
DMA zone: 0 pages reserved
DMA zone: 4064 pages, LIFO batch:0
Normal zone: 30 pages used for memmap
Normal zone: 3810 pages, LIFO batch:0
Built 1 zonelists. Total pages: 7874
Kernel command line: root=31:0 ro noinitrd console=ttyS0,115200
brcm mips: enabling icache and dcache...
Primary instruction cache 64kB, physically tagged, 4-way, linesize 16 bytes.
Primary data cache 32kB, 2-way, linesize 16 bytes.
Synthesized TLB refill handler (21 instructions).
Synthesized TLB load handler fastpath (33 instructions).
Synthesized TLB store handler fastpath (33 instructions).
Synthesized TLB modify handler fastpath (32 instructions).
PID hash table entries: 128 (order: 7, 512 bytes)
Using 200.000 MHz high precision timer.
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 28248k/31744k available (2174k kernel code, 3496k reserved, 709k data, 96k init, 0k highmem)
KLOB Pool 1 Initialized: 1048576 bytes <0x80c00000 ... 0x80d00000>
Calibrating delay loop... 398.33 BogoMIPS (lpj=199168)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
Total Flash size: 8192K with 135 sectors
File system address: 0xb8020100
two psi used size = 131072
registering PCI controller with io_map_base unset
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
BLOG v1.0 Initialized
NET: Registered protocol family 8
NET: Registered protocol family 20
Time: MIPS clocksource has been installed.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
squashfs: version 3.2-r2 (2007/01/15) Phillip Lougher
squashfs: LZMA suppport for slax.org by jro
fuse init (API version 7.8)
io scheduler noop registered (default)
PPP generic driver version 2.4.2
NET: Registered protocol family 24
bcm963xx_mtd driver v1.0
PCI: Enabling device 0000:00:0a.0 (0000 -> 0002)
PCI: Setting latency timer of device 0000:00:0a.0 to 64
ehci_hcd 0000:00:0a.0: EHCI Host Controller
ehci_hcd 0000:00:0a.0: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:0a.0: irq 15, io mem 0x10001500
ehci_hcd 0000:00:0a.0: USB f.f started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ohci_hcd: 2006 August 04 USB 1.1 'Open' Host Controller (OHCI) Driver
PCI: Enabling device 0000:00:09.0 (0000 -> 0002)
PCI: Setting latency timer of device 0000:00:09.0 to 64
ohci_hcd 0000:00:09.0: OHCI Host Controller
ohci_hcd 0000:00:09.0: new USB bus registered, assigned bus number 2
ohci_hcd 0000:00:09.0: irq 13, io mem 0x10001600
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
usbcore: registered new interface driver usblp
drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usbcore: registered new interface driver usbserial
drivers/usb/serial/usb-serial.c: USB Serial Driver core
drivers/usb/serial/usb-serial.c: USB Serial support registered for GSM modem (1-port)
usbcore: registered new interface driver option
drivers/usb/serial/option.c: USB Driver for GSM modems: v0.7.1
brcmboard: brcm_board_init entry
kerSysScreenPciDevices: 0x14e4:0x4318 slot 1) detected
kerSysScreenPciDevices: 0x14e4:0x6300slot 9) detected
kerSysScreenPciDevices: 0x14e4:0x6300slot 10) detected
SES: Button Interrupt 0x1 is enabled
SES: LED GPIO 0x8018 is enabled
DSL WAN is selected
Serial: BCM63XX driver $Revision: 3.00 $
ttyS0 at MMIO 0xb0000100 (irq = 10) is a BCM63XX
ttyS1 at MMIO 0xb0000120 (irq = 11) is a BCM63XX
bcmxtmrt: Broadcom BCM6368B2 ATM/PTM Network Device v0.1 Jun 2 2011 15:57:46
IPSEC SPU: SUCCEEDED
Mirror/redirect action on
u32 classifier
input device check on
Actions configured
TCP cubic registered
Initializing XFRM netlink socket
NET: Registered protocol family 1
NET: Registered protocol family 17
NET: Registered protocol family 15
Ebtables v2.0 registered
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 96k freed
init started: BusyBox v1.00 (2011.06.02-08:03+0000) multi-call binary
mkdir: Cannot create directory `/
BusyBox v1.00 (2011.06.02-08:03+0000) Built-in shell (msh)
Enter 'help' for a list of built-in commands.
Loading drivers and kernel modules...
pktflow: module license 'Proprietary' taints kernel.
Broadcom Packet Flow Cache learning via BLOG enabled.
Created Proc FS /procfs/fcache
Constructed Broadcom Packet Flow Cache v0.1 Jul 22 2010 10:12:02
Broadcom Packet CMF (Experimental) Char Driver v0.1 Jul 22 2010 10:12:01 Registered<232>
Broadcom Packet CMF (Experimental) [6368-B2] v0.1 Jul 22 2010 10:12:01 Loaded
bcmxtmcfg: bcmxtmcfg_init entry
adsl: adsl_init entry
Broadcom BCMPROCFS v1.0 initialized
Broadcom BCM6368B2 Ethernet Network Device v0.1 Jun 2 2011 15:56:53
KLOB extended to 2 pools
KLOB extended to 3 pools
KLOB extended to 4 pools
dgasp: kerSysRegisterDyingGaspHandler: bcmsw registered
Broadcom Packet CMF (Experimental) SWC RESET.
Broadcom Packet CMF (Experimental) SWC INITIALIZED.
KLOB extended to 5 pools
KLOB extended to 6 pools
KLOB extended to 7 pools
KLOB extended to 8 pools
Broadcom Packet CMF (Experimental) Forwarder Net Device 0 v0.1 Jul 22 2010 10:12:02 Registered
Broadcom Packet CMF (Experimental) Forwarder Net Device 1 v0.1 Jul 22 2010 10:12:02 Registered
Broadcom Packet CMF (Experimental) ENABLED.
eth0: MAC Address: C8:6C:87:9B:82:44
eth1: MAC Address: C8:6C:87:9B:82:44
eth2: MAC Address: C8:6C:87:9B:82:44
eth3: MAC Address: C8:6C:87:9B:82:44
eth4: MAC Address: C8:6C:87:9B:82:44
link up/1/time=*info=eth4 Link UP 100 mbps full duplex
PCI: Enabling device 0000:00:01.0 (0000 -> 0002)
PCI: Setting latency timer of device 0000:00:01.0 to 64
wl: srom not detected, using main memory mapped srom info (wombo board)
wl0: wlc_attach: MAC addr from system pool. id:0x776c0000
wl0: MAC Address: C8:6C:87:9B:82:45
wl0: Broadcom BCM4318 802.11 Wireless Controller 5.10.85.0.cpe4.402.8
dgasp: kerSysRegisterDyingGaspHandler: wl0 registered
p8021ag: p8021ag_init entry
163
166
===== Release Version 4.02L.03 (build timestamp 110602_1600) =====
ip_tables: (C) 2000-2006 Netfilter Core Team
Netfilter messages via NETLINK v0.30.
conntrack rate:0nf_conntrack version 0.5.0 (1280 buckets, 10240 max) |
|
/1 
简体中文
繁體中文
English
日本語
Deutsch
한국 사람
بالعربية
TÜRKÇE
português
คนไทย
IP卡
狗仔卡
置顶卡
沉默卡
喧嚣卡
顶贴卡
显身卡