请问下TPLINK的WA801N 和 WA805N有支持DDWRT吗

89665519

原厂的太不稳定了，求支持WA801N或者WA805N的第三方固件，最主要解决无线上的问题

dato

tp wa801 v1直接支持
tp wa801 v2看这里我可以非常肯定的告诉你我刷成功了，可是刷回来的时候。用了ftp上传到/tmp再dd的方法砖，不会玩TTL至今没修复。当时没测试v2的稳定性，应该是问题不大。有个tplink 701n刷了tplink 801 v1的ddwrt固件没问题。不再有动不动死机的情况，信号也好了很多，那段时间流量都发不起来，忍不可忍刷成ddwrt。今年的固件非常好啊，没碰到以前在tp 841 v3 dd build 14xxx版本遇到的无线老消失的情况。一开机都30天的长时间稳定运行。

http://www.dd-wrt.com/phpBB2/vie ... er=asc&start=15


701 v2 mr3020-webflash


hey there,

today i bought my WA801ND V2, checked the hardware and was suprised. in my opinion there is no difference between the WA801ND V2 and WA830RE V2! the WA830RE V2 is under "developing/testing" there --> http://www.dd-wrt.com/phpBB2/vie ... der=asc&start=0

flint

edit: the production code an revision on mainboard is also the same (2053500039 Rev:1.0)

edit: binary from link above works well on my WA801ND V2 like on WA830RE V2. there is also no lan after first boot --> binary came from WR841ND V8 where the switch part of AR9x is connected to the world. first connect at wlan to configure lan port.


I have my router working perfectly, wireless extending and my LAN port is working too.

So follow this tutorial here to solve the 18005 error when flashing factory-to-ddwrt.bin:
https://forum.openwrt.org/viewtopic.php?pid=168045#p168045

Since we all have the same routers and same default firmwares, use these two hex codes when patching the factory-to-ddwrt.bin file (no need to input stock firmware):

0x40-0x43 - input 08300002
0x44-0x47 - input 00000001

After that just flash it in the TP-Link Webgui of your router. Then you may proceed as usual!
I'm using the latest updated firmware here: http://dd-wrt.com/site/support/o ... ink_tl-wr841ndv8%2F

After that I followed the tutorial here: http://www.dd-wrt.com/wiki/index.php/Repeater_Bridge#Atheros

Follow the Atheros tutorial for the first part, then continue with the Broadcom tutorial.

89665519

dato 发表于 2014-5-19 19:22
tp wa801 v1直接支持
tp wa801 v2看这里我可以非常肯定的告诉你我刷成功了，可是刷回来的时候。用了ftp上 ...

可惜我识wa801 V2
如果V2刷701的固件的话，无线稳定吗·？